Suppressing transverse mode instability through multimode excitation in a fiber amplifier.

High-power fiber laser amplifiers have enabled an increasing range of applications in industry, science, and defense. The power scaling for fiber amplifiers is currently limited by transverse mode instability. Most techniques for suppressing the instability are based on single- or few-mode fibers in order to output a clean collimated beam. Here, we study theoretically using a highly multimode fiber amplifier with many-mode excitation for efficient suppression of thermo-optical nonlinearity and instability. We find that the mismatch of characteristic length scales between temperature and optical intensity variations across the fiber generically leads to weaker thermo-optical coupling between fiber modes. Consequently, the transverse mode instability (TMI) threshold power increases linearly with the number of equally excited modes. When the frequency bandwidth of a coherent seed laser is narrower than the spectral correlation width of the multimode fiber, the amplified light maintains high spatial coherence and can be transformed to any target pattern or focused to a diffraction-limited spot by a spatial mask at either the input or output end of the amplifier. Our method simultaneously achieves high average power, narrow spectral width, and good beam quality, which are required for fiber amplifiers in various applications.

Mitigating stimulated Brillouin scattering in multimode fibers with focused output via wavefront shaping.

The key challenge for high-power delivery through optical fibers is overcoming nonlinear optical effects. To keep a smooth output beam, most techniques for mitigating optical nonlinearities are restricted to single-mode fibers. Moving out of the single-mode paradigm, we show experimentally that wavefront-shaping of coherent input light to a highly multimode fiber can increase the power threshold for stimulated Brillouin scattering (SBS) by an order of magnitude, whilst simultaneously controlling the output beam profile. The SBS suppression results from an effective broadening of the Brillouin spectrum under multimode excitation, without broadening of transmitted light. Strongest suppression is achieved with selective mode excitation that gives the broadest Brillouin spectrum. Our method is efficient, robust, and applicable to continuous waves and pulses. This work points toward a promising route for mitigating detrimental nonlinear effects in optical fibers, enabling further power scaling of high-power fiber systems for applications to directed energy, remote sensing, and gravitational-wave detection.

Multimode optical fiber specklegram smart bed sensor array.

SIGNIFICANCE: Monitoring the movement and vital signs of patients in hospitals and other healthcare environments is a significant burden on healthcare staff. Early warning systems using smart bed sensors hold promise to relieve this burden and improve patient outcomes. We propose a scalable and cost-effective optical fiber sensor array that can be embedded into a mattress to detect movement, both sensitively and spatially. AIM: Proof-of-concept demonstration that a multimode optical fiber (MMF) specklegram sensor array can be used to detect and image movement on a bed. APPROACH: Seven MMFs are attached to the upper surface of a mattress such that they cross in a 3 × 4 array. The specklegram output is monitored using a single laser and single camera and movement on the fibers is monitored by calculating a rolling zero-normalized cross-correlation. A 3 × 4 image is formed by comparing the signal at each crossing point between two fibers. RESULTS: The MMF sensor array can detect and image movement on a bed, including getting on and off the bed, rolling on the bed, and breathing. CONCLUSIONS: The sensor array shows a high sensitivity to movement, which can be used for monitoring physiological parameters and patient movement for potential applications in healthcare settings.