RESUMO
To achieve the quantitative elemental analysis of aluminum alloy samples, the one-point and multi-line calibration (OP-MLC) method and femtosecond laser-ablation spark-induced breakdown spectroscopy (fs-LA-SIBS) were combined in this study. An ultrafast Ti: sapphire laser with high single-pulse energy and high repetition-rate operation was used as the laser source to ablate the sample at a 1k Hz pulse repetition rate and achieve re-excitation using spark discharge. Subsequently, an enhanced spectral peak intensity was achieved, which increased the sensitivity and analytical capabilities of laser-induced breakdown spectroscopy (LIBS) technique. Considering only one confirmed sample, the OP-MLC method was used to calculate the concentration ratios of trace elements Mg, Cr, Cu, Mn and Zn in four aluminum alloy samples to the calibration samples by the integral intensity ratio of the elemental characteristic lines between the two samples. The average relative errors with the identified concentrations were 3.99%, 15.13%, 8.76%, 9.30% and 9.64%, respectively. The results showed that the combination of OP-MLC method and fs-LA-SIBS has good accuracy in the quantitative analysis of elements, and has the advantages of simplicity, rapidity and high sensitivity.
Assuntos
Ligas , Alumínio , Calibragem , Análise Espectral , LasersRESUMO
In this work, magnesium (Mg), copper (Cu), manganese (Mn) and chromium (Cr) in aluminum alloy samples were quantified by femtosecond laser-induced breakdown spectroscopy (fs-LIBS). The different parameters affecting the experimental results, including the laser pulse energy, moving speed of the 2D platform and spectral average number were optimized. The background signal preprocessing methods of median filtering (MF corrected) and Savitzky-Golay filtering (SG corrected) algorithms were used and the effect of the LIBS spectral analysis in the experiment investigated. The calibration curves of Mg, Cu, Mn and Cr elements were established separately and their corresponding detection limits (LODs) were calculated. After background correction, the LODs of Mg, Cu, Mn and Cr elements in MF corrected were 54.52, 11.69, 7.33 and 27.72 ppm, and in SG corrected were 59.15, 17.48, 14.75 and 31.97 ppm. The LODs of these elements in MF corrected and SG corrected have 1.4-5.2 and 1.2-2.5 improvement factors compared to those obtained using the fs-LIBS technique. This work demonstrates that background signal preprocessing methods are very helpful for improving analytical sensitivity and accuracy in quantitative analyses of aluminum alloys.