A 40 MHz 11-Bit ENOB Delta Sigma ADC for Communication and Acquisition Systems.

This paper describes a Delta Sigma ADC IC that embeds a 5th-order Continuous-Time Delta Sigma modulator with 40 MHz signal bandwidth, a low ripple 20 to 80 MS/s variable-rate digital decimation filter, a bandgap voltage reference, and high-speed CML buffers on a single die. The ADC also integrates on-chip calibrations for RC time-constant variation and quantizer offset. The chip was fabricated in a 1P7M 65 nm CMOS process. Clocked at 640 MHz, the Continuous-Time Delta Sigma modulator achieves 11-bit ENOB and 76.5 dBc THD up to 40 MHz of signal bandwidth while consuming 82.3 mW.

Excel Methods to Design and Validate in Microelectronics (Complementary Metal-Oxide-Semiconductor, CMOS) for Biomedical Instrumentation Application.

CMOS microelectronics design has evolved tremendously during the last two decades. The evolution of CMOS devices to short channel designs where the feature size is below 1000 nm brings a great deal of uncertainty in the way the microelectronics design cycle is completed. After the conceptual idea, developing a thinking model to understand the operation of the device requires a good "ballpark" evaluation of transistor sizes, decision making, and assumptions to fulfill the specifications. This design process has iterations to meet specifications that exceed in number of the available degrees of freedom to maneuver the design. Once the thinking model is developed, the simulation validation follows to test if the design has a good possibility of delivering a successful prototype. If the simulation provides a good match between specifications and results, then the layout is developed. This paper shows a useful open science strategy, using the Excel software, to develop CMOS microelectronics hand calculations to verify a design, before performing the computer simulation and layout of CMOS analog integrated circuits. The full methodology is described to develop designs of passive components, as well as CMOS amplifiers. The methods are used in teaching CMOS microelectronics to students of electronic engineering with industrial partner participation. This paper describes an exhaustive example of a low-voltage operational transconductance amplifier (OTA) design which is used to design an instrumentation amplifier. Finally, a test is performed using this instrumentation amplifier to implement a front-end signal conditioning device for CMOS-MEMS biomedical applications.

Fully integrated biochip platforms for advanced healthcare.

Recent advances in microelectronics and biosensors are enabling developments of innovative biochips for advanced healthcare by providing fully integrated platforms for continuous monitoring of a large set of human disease biomarkers. Continuous monitoring of several human metabolites can be addressed by using fully integrated and minimally invasive devices located in the sub-cutis, typically in the peritoneal region. This extends the techniques of continuous monitoring of glucose currently being pursued with diabetic patients. However, several issues have to be considered in order to succeed in developing fully integrated and minimally invasive implantable devices. These innovative devices require a high-degree of integration, minimal invasive surgery, long-term biocompatibility, security and privacy in data transmission, high reliability, high reproducibility, high specificity, low detection limit and high sensitivity. Recent advances in the field have already proposed possible solutions for several of these issues. The aim of the present paper is to present a broad spectrum of recent results and to propose future directions of development in order to obtain fully implantable systems for the continuous monitoring of the human metabolism in advanced healthcare applications.