New insights into the production, characterization and potential uses of vineyard pruning waste biochars.

Vineyard pruning waste (VP) can be converted into a useful char using pyrolysis as part of a valorization strategy. This study analyzed the effect of temperature (300 and 600 °C) and residence time (1 and 3 h) on an ample number of properties of VP derived biochars, including potential negative environmental impacts. The results showed a clear influence of temperature on biochar's properties and a weaker effect of residence time. Increasing temperature raised soil pH, electrical conductivity (EC), ash and C contents, aromaticity, specific surface area, solid density, mesoporosity and partial graphitization. However, higher pyrolysis temperature reduced O/C and N/C ratios, total N, P and Mg, and polycyclic aromatic hydrocarbons (PAHs). Particularly, the concentration of water extractable organic carbon (WEOC) decreased dramatically with pyrolysis temperature. Moreover, the WEOC fraction of biochars pyrolyzed at 300 °C exhibited a larger aromaticity than those pyrolyzed at 600 °C. Prolonged residence time increased ash content and fixed carbon (FC) and decreased H/C and O/C ratios; however, most frequently this parameter affected biochar properties following opposite trends for the two pyrolysis temperatures. Hydrophysical properties were adequate to consider VP derived biochars as growing media component. PAH concentration was much lower than thresholds following international standards. The germination index increased with temperature and decreased with residence time, so that phytotoxicity was observed in VP and in biochars pyrolyzed for 3 h. Our research demonstrates that, besides temperature, residence time can be useful to modulate the properties of biochars and that prolonged time effect is temperature-dependent.

Low-Temperature Thermal Degradation of Disinfected COVID-19 Non-Woven Polypropylene-Based Isolation Gown Wastes into Carbonaceous Char.

Yields of carbonaceous char with a high surface area were enhanced by decreasing the temperature to improve the conversion of hazardous plastic polypropylene (PP), the major component in abundantly used isolation gowns. This study applied pyrolysis with different low pyrolytic temperatures to convert disinfected PP-based isolation gown waste (PP-IG) into an optimised amount of char yields. A batch reactor with a horizontal furnace was used to mediate the thermal decomposition of PP-IG. Enhanced surface area and porosity value of PP-IG derived char were obtained via an optimised slow pyrolysis approach. The results showed that the amount of yielded char was inversely proportional to the temperature. This process relied heavily on the process parameters, especially pyrolytic temperature. Additionally, as the heating rate decreased, as well as longer isothermal residence time, the char yields were increased. Optimised temperature for maximum char yields was recorded. The enhanced SBET values for the char and its pore volume were collected, ~24 m2 g-1 and ~0.08 cm3 g-1, respectively. The char obtained at higher temperatures display higher volatilisation and carbonisation. These findings are beneficial for the utilisation of this pyrolysis model in plastic waste management and conversion of PP-IG waste into char for further activated carbon and fuel briquettes applications, with the enhanced char yields, amidst the COVID-19 pandemic.