RESUMO
A high-gain low-profile reflector antenna with dual-band radiation ability is presented in this paper. The antenna achieves a relative 2 dB gain bandwidth of 10% around fl, and a relative 2 dB gain bandwidth of 20%, around fh, where fl and fh are the center operating frequencies of the frequency bands of 29.4~32.4 GHz and 142~174 GHz, respectively. To achieve the dual-band radiation ability, a composite dual-band feed with an fh/fl ratio of around 5 is proposed as the feed for the reflector antenna, which includes a higher-band circular waveguide and a lower-band coaxial horn. The metallic elliptical surface serves as the subreflector (SR) in the higher band, while the SR is the planar reflectarray in the lower band. Due to the design of the dual reflector, the dual-band reflector antenna features a low focal-to-diameter (F/D) ratio of approximately 0.2. According to the simulated results, the proposed reflector antenna achieves efficiencies of 59.0% and 42.9% at fl and fh, respectively. For verification purposes, a Ku/E-band scaled prototype is manufactured. The measured VSWRs, radiation patterns, and gains are in reasonable agreement with the simulated ones, proving the correctness of the proposed design method.
RESUMO
A shape adjustment method for subreflectors based on minimizing the residual wavefront error of the large dual-reflector antenna is presented. This method is used to compensate for the antenna structural deformation caused by environment loading. The shape of the subreflector is adjusted using actuators fixed under the panels. The shape adjustment response function for the subreflector shape and the actuators' adjustment amount is established, which is based on the inverse distance weighting function, and then the control function of the subreflector shape is obtained. The actuators' adjustment amount can be calculated using the least squares matrix transformation with the minimum residual wavefront error. Analysis of the experiment's results shows the residual wavefront error and primary aberration are greatly reduced under different elevation angles, and the effectiveness of the proposed method is verified.