RESUMO
Wildland fire emissions are routinely estimated in the US Environmental Protection Agency's National Emissions Inventory, specifically for fine particulate matter (PM2.5) and precursors to ozone (O3); however, there is a large amount of uncertainty in this sector. We employ a brute-force zero-out sensitivity method to estimate the impact of wildland fire emissions on air quality across the contiguous US using the Community Multiscale Air Quality (CMAQ) modelling system. These simulations are designed to assess the importance of wildland fire emissions on CMAQ model performance and are not intended for regulatory assessments. CMAQ ver. 5.0.1 estimated that fires contributed 11% to the mean PM2.5 and less than 1% to the mean O3 concentrations during 2008-2012. Adding fires to CMAQ increases the number of 'grid-cell days' with PM2.5 above 35 µg m-3 by a factor of 4 and the number of grid-cell days with maximum daily 8-h average O3 above 70 ppb by 14%. Although CMAQ simulations of specific fires have improved with the latest model version (e.g. for the 2008 California wildfire episode, the correlation r = 0.82 with CMAQ ver. 5.0.1 v. r = 0.68 for CMAQ ver. 4.7.1), the model still exhibits a low bias at higher observed concentrations and a high bias at lower observed concentrations. Given the large impact of wildland fire emissions on simulated concentrations of elevated PM2.5 and O3, improvements are recommended on how these emissions are characterised and distributed vertically in the model.
RESUMO
We examine the impact of dimethylsulfide (DMS) emissions on sulfate concentrations over the continental U.S. by using the Community Multiscale Air Quality (CMAQ) model version 5.4 and performing annual simulations without and with DMS emissions for 2018. DMS emissions enhance sulfate not only over seawater but also over land, although to a lesser extent. On an annual basis, the inclusion of DMS emissions increase sulfate concentrations by 36% over seawater and 9% over land. The largest impacts over land occur in California, Oregon, Washington, and Florida, where the annual mean sulfate concentrations increase by ~25%. The increase in sulfate causes a decrease in nitrate concentration due to limited ammonia concentration especially over seawater and an increase in ammonium concentration with a net effect of increased inorganic particles. The largest sulfate enhancement occurs near the surface (over seawater) and the enhancement decreases with altitude, diminishing to 10-20% at an altitude of ~5 km. Seasonally, the largest enhancement of sulfate over seawater occurs in summer, and the lowest in winter. In contrast, the largest enhancements over land occur in spring and fall due to higher wind speeds that can transport more sulfate from seawater into land.
RESUMO
Atmospheric nitrogen oxide and nitrogen dioxide (NO + NO2, together termed as NO X ) estimates from annual photochemical simulations for years 2002-2016 are compared to surface network measurements of NO X and total gas-phase-oxidized reactive nitrogen (NO Y ) to evaluate the Community Multiscale Air Quality (CMAQ) modeling system performance by U.S. region, season, and time of day. In addition, aircraft measurements from 2011 Deriving Information on Surface Conditions from Column and Vertically Resolved Observations Relevant to Air Quality are used to evaluate how emissions, chemical mechanism, and measurement uncertainty each contribute to the overall model performance. We show distinct seasonal and time-of-day patterns in NO X performance. Summertime NO X is overpredicted with bimodal peaks in bias during early morning and evening hours and persisting overnight. The summertime morning NO X bias dropped from between 28% and 57% for earlier years (2002-2012) to between -2% and 7% for later years (2013-2016). Summer daytime NO X tends to be unbiased or underpredicted. In winter, the evening NO X overpredictions remain, but NO X is unbiased or underpredicted overnight, in the morning, and during the day. NO X overpredictions are most pronounced in the Midwestern and Southern United States with Western regions having more of a tendency toward model underpredictions of NO X . Modeled NO X performance has improved substantially over time, reflecting updates to the emission inputs and the CMAQ air quality model. Model performance improvements are largest for years simulated with CMAQv5.1 or later and for emission inventory years 2014 and later, coinciding with reduced onroad NO X emissions from vehicles with newer emission control technologies and improved treatment of chemistry, deposition, and vertical mixing in CMAQ. Our findings suggest that emissions temporalization of specific mobile source sectors have a small impact on model performance, while chemistry updates improve predictions of NO Y but do not improve summertime NO X bias in the Baltimore/DC area. Sensitivity runs performed for different locations across the country suggest that the improvement in summer NO X performance can be attributed to updates in vertical mixing incorporated in CMAQv5.1.
RESUMO
NASA's Deriving Information on Surface Conditions from Column and Vertically Resolved Observations Relevant to Air Quality (DISCOVER-AQ, conducted in 2011-2014) campaign in the United States and the joint NASA and National Institute of Environmental Research (NIER) Korea-United States Air Quality Study (KORUS-AQ, conducted in 2016) in South Korea were two field study programs that provided comprehensive, integrated datasets of airborne and surface observations of atmospheric constituents, including nitrogen dioxide (NO2), with the goal of improving the interpretation of spaceborne remote sensing data. Various types of NO2 measurements were made, including in situ concentrations and column amounts of NO2 using ground- and aircraft-based instruments, while NO2 column amounts were being derived from the Ozone Monitoring Instrument (OMI) on the Aura satellite. This study takes advantage of these unique datasets by first evaluating in situ data taken from two different instruments on the same aircraft platform, comparing coincidently sampled profile-integrated columns from aircraft spirals with remotely sensed column observations from ground-based Pandora spectrometers, intercomparing column observations from the ground (Pandora), aircraft (in situ vertical spirals), and space (OMI), and evaluating NO2 simulations from coarse Global Modeling Initiative (GMI) and high-resolution regional models. We then use these data to interpret observed discrepancies due to differences in sampling and deficiencies in the data reduction process. Finally, we assess satellite retrieval sensitivity to observed and modeled a priori NO2 profiles. Contemporaneous measurements from two aircraft instruments that likely sample similar air masses generally agree very well but are also found to differ in integrated columns by up to 31.9 %. These show even larger differences with Pandora, reaching up to 53.9 %, potentially due to a combination of strong gradients in NO2 fields that could be missed by aircraft spirals and errors in the Pandora retrievals. OMI NO2 values are about a factor of 2 lower in these highly polluted environments due in part to inaccurate retrieval assumptions (e.g., a priori profiles) but mostly to OMI's large footprint (> 312 km2).
RESUMO
Ammonia surface flux is bidirectional; that is, net flux can be either upward or downward. In fertilized agricultural croplands and grasslands there is usually more emission than deposition especially in midday during warmer seasons. In North America, most of the ammonia emissions are from agriculture with a significant fraction of that coming from fertilizer. A new bidirectional ammonia flux modeling system has been developed in the Community Multiscale Air Quality (CMAQ) model, which has close linkages with the Environmental Policy Integrated Climate (EPIC) agricultural ecosystem model. Daily inputs from EPIC are used to calculate soil ammonia concentrations that are combined with air concentrations in CMAQ to calculate bidirectional surface flux. The model is evaluated against surface measurements of NH3 concentrations, NH4 + and SO4 2- aerosol concentrations, NH4 + wet deposition measurements, and satellite retrievals of NH3 concentrations. The evaluation shows significant improvement over the base model without bidirectional ammonia flux. Comparisons to monthly average satellite retrievals show similar spatial distribution with the highest ammonia concentrations in the Central Valley of California (CA), the Snake River valley in Idaho, and the western High Plains. In most areas the model underestimates, but in the Central Valley of CA, it generally overestimates ammonia concentration. Case study analyses indicate that modeled high fluxes of ammonia in CA are often caused by anomalous high soil ammonia loading from EPIC for particular crop types. While further improvements to parameterizations in EPIC and CMAQ are recommended, this system is a significant advance over previous ammonia bidirectional surface flux models.