Conjugates of desferrioxamine and aromatic amines improve markers of iron-dependent neurotoxicity.

Alzheimer's Disease (AD) is a complex neurodegenerative disorder associated in some instances with dyshomeostasis of redox-active metal ions, such as copper and iron. In this work, we investigated whether the conjugation of various aromatic amines would improve the pharmacological efficacy of the iron chelator desferrioxamine (DFO). Conjugates of DFO with aniline (DFOANI), benzosulfanylamide (DFOBAN), 2-naphthalenamine (DFONAF) and 6-quinolinamine (DFOQUN) were obtained and their properties examined. DFOQUN had good chelating activity, promoted a significant increase in the inhibition of ß-amyloid peptide aggregation when compared to DFO, and also inhibited acetylcholinesterase (AChE) activity both in vitro and in vivo (Caenorhabditis elegans). These data indicate that the covalent conjugation of a strong iron chelator to an AChE inhibitor offers a powerful approach for the amelioration of iron-induced neurotoxicity symptoms.

Laser-induced breakdown spectroscopy (LIBS) combined with hyperspectral imaging for the evaluation of printed circuit board composition.

In this study, laser-induced breakdown spectroscopy (LIBS) was combined with chemometric strategies (PCA, Principal Component Analysis) and scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDS) to investigate the metal composition of a printed circuit board (PCB) sample from a mobile phone. Scanning electron microscopy-EDS was used for two main reasons: it was possible at the same time to visualize the sample surface, craters (made by the laser pulses) and also the chemical composition of the samples. A 30 mm×40 mm area of the mobile phone PCB sample, which was manufactured in 2011, was investigated. In this case, a matrix with 30 rows and 40 columns (1200 points) was analyzed, and 10 pulses were performed at each point. A total of 12,000 emission spectra were recorded in the wavelength range from 186 to 1040 nm. After an initial exploratory investigation using PCA, 18 emission lines were selected (representing the elements Al, Au, Ba, Ca, Co, Cu, Fe, K, Li, Mg, Mn, Na, Ni, Sb, Si, Sn, Ti and Zn) and then normalized by the relative intensities, and a new PCA was calculated with the autoscaled data. For example, Au and Si were mainly observed in the superficial electrical contacts and in the bulk of the PCB, respectively. A second sample (a mouse PCB) was also analyzed and Pb (emission lines 357.273, 363.956, 368.346, 373.994 and 405.780 nm) was identified in the solders. In addition, this element was determined using FAAS (flame atomic absorption spectrometry) and the Pb concentration was around 25% (w/w). This study opens the possibility for improved recycling processes and the chemical investigation of solid samples measuring a few millimeters in dimension without sample preparation.