RESUMO
A highly densified electrode material is desirable to achieve large volumetric capacity. However, pores acting as ion transport channels are critical for high utilization of active material. Achieving a balance between high volume density and pore utilization remains a challenge particularly for hollow materials. Herein, capillary force is employed to convert hollow fibers to a bamboo-weaving-like flexible electrode (BWFE), in which the shrinkage of hollow space results in high compactness of the electrode. The volume of the electrode can be decreased by 96% without sacrificing the gravimetric capacity. Importantly, the conductivity of BWFE after thermal treatment can reach up to 50,500 S/m which exceeds that for most other carbon materials. Detailed mechanical analysis reveals that, due to the strong interaction between nanoribbons, Young's modulus of the electrode increases by 105 times. After SnO2 active materials is impregnated, the BWFE/SnO2 electrode exhibits an exceptionally ultrahigh volumetric capacity of 2000 mAh/cm3.
RESUMO
Biomass-derived carbon for supercapacitors faces the challenge of achieving hierarchical porous carbon with graphitic structure and specific heteroatoms through a single-stage thermal process that minimises resource input. Herein, molten base carbonisation and activation is proposed. The process utilises the inherent moisture of Moso bamboo shoots, coupled with a low amount of KOH, to form potassium organic salts before drying. The resultant potassium salts promote in-situ activation during single-stage heating process, yielding hierarchical porous, large specific surface area, and partially graphitised carbon with heteroatoms (N, O). As an electrode material, this carbon exhibits a specific capacitance of 327F g-1 in 6 M KOH and 182F g-1 in 1 M TEABF4/AN, demonstrating excellent cycling stability over 10,000 cycles at 2 A/g. Overall, this study presents a straightforward process that avoids pre-drying of biomass, minimises base consumption, and employs single-stage heating to fabricate electrode carbon suitable for supercapacitors.
Assuntos
Biomassa , Carbono , Capacitância Elétrica , Eletrodos , Porosidade , Carbono/química , Técnicas Eletroquímicas/métodosRESUMO
In this paper, a Si@EG composite was prepared by liquid phase mixing and the elevated temperature solid phase method, while polyaniline was synthesized by the in situ chemical polymerization of aniline monomer to coat the surface of nano-silicon and exfoliated graphite composites (Si@EG). Pyrolytic polyaniline (p-PANI) coating prevents the agglomeration of silicon nanoparticles, forming a good conductive network that effectively alleviates the volume expansion effect of silicon electrodes. SEM, TEM, XRD, Raman, TGA and BET were used to observe the morphology and analyze the structure of the samples. The electrochemical properties of the materials were tested by the constant current charge discharge and cyclic voltammetry (CV) methods. The results show that Si@EG@p-PANI not only inhibits the agglomeration between silicon nanoparticles and forms a good conductive network but also uses the outermost layer of p-PANI carbon coating to effectively alleviate the volume expansion of silicon nanoparticles during cycling. Si@EG@p-PANI had a high initial specific capacity of 1491 mAh g-1 and still maintains 752 mAh g-1 after 100 cycles at 100 mA g-1, which shows that it possesses excellent electrochemical stability and reversibility.
RESUMO
Numerous studies have reported that the enhancement of rate capability of carbonaceous anode by heteroatom doping is due to the increased diffusion-controlled capacity induced by expanding interlayer spacing. However, percentage of diffusion-controlled capacity is less than 30% as scan rate is larger than 1 mV s-1 , suggesting there is inaccuracy in recognizing principle of improving rate capability of carbonaceous anode. In this paper, it is found that the heteroatom doping has little impact on interlayer spacing of carbon in bulk phase, meaning that diffusion-controlled capacity is hard to be enhanced by doping. After synergizing with tensile stress, however, the interlayer spacing in subsurface region is obviously expanded to 0.40 nm, which will increase the thickness of accessible subsurface region at high current density. So SRNDC-700 electrodes display a high specific capacity of 160.6 and 69.5 mAh g-1 at 20 and 50 A g-1 , respectively. Additionally, the high reversibility of carbon structure insures ultralong cycling stability and hence attenuation of SRNDC-700 is only 0.0025% per cycle even at 10 A g-1 for 6000 cycles. This report sheds new insight into mechanism of improving electrochemical performance of carbonaceous anode by doping and provides a novel design concept for doping carbon.