RESUMO
The fabrication of structured zeolite adsorbents through photopolymerization-based 3D printing which offers a solution to the limitations of conventional shaping techniques has been demonstrated but many parameters still need to be optimized. In this study, we studied the influence of zeolite compensation cations on the photopolymerization and the composite's properties. Modified zeolites (LTA 4â A and FAU 13X exchanged with K+ , Li+ , Sr2+ , Ca2+ or Mg2+ ) were incorporated in PEGDA with BDMK as photoinitiator, and the formulation was cured under mild conditions (LED@405â nm, room temperature, under air). Our results indicate that the nature of zeolite compensation cations affects the colorimetric properties of polymer/zeolite composites: a better translucency parameter results in higher depth of cure. After calcination at 650 °C and complete removal of PEGDA, pure zeolitic monoliths were tested for adsorption of gas molecules of interest (carbon dioxide, dichlorobenzene and water). Structured 4â A and 13X monoliths obtained by 3D printing exhibit comparable adsorption capacity to commercial beads prepared from the same zeolites. This study enhances our understanding of the photopolymerization process involved in the production of polymer/zeolite composites. These composites are used in the fabrication of zeolitic objects through 3D printing, offering potential solutions to various environmental and dental challenges.