RESUMO
Introduction: Dislocations of the knee joint represent very rare injuries in the literature, accounting for less than 0.02% of all musculoskeletal injuries. Case Report: This report describes a patient suffered a knee joint dislocation of the knee joint caused by a low impact injury following a stumbling trauma during volunteer of a sport competition. Anterior knee joint dislocation with incipient compartment syndrome was clinically prognosed. Vascular and nerve injuries were radiologically examined. Taken together the injury was classified as Schenck type IV CN, and surgical management of the current knowledge was pursued. A satisfying range of motion was examined during surgery next to solid vascular und nerve conditions post-surgery. Conclusion: In case of severe knee joint dislocations, the current standard of a closed reduction with subsequent diagnostic is recommended. Compartment syndrome, nerve, and vascular tears indicate emergency surgery.
RESUMO
Biomechanical tests typically involve bending, compression, or shear stress, while fall tests are less common. The main challenge in performing fall tests is the non-reproducible directionality of bone when tested with soft tissue. Upon removal of the soft tissue, the explanted bone's resistance to impact diminishes. Therefore, ballistic gels can fix specimens in reproducible directions and simulate periosteal soft tissue. However, the use of ballistic gels in biomechanical studies is neither standardized nor widespread. This study aimed to optimize a ballistic gel consistency that mimics the upper thigh muscle in sheep. Our results suggest a standardized and flexible evaluation method by embedding samples in ballistic gel. Compression tests were conducted using cylindrical pieces of gluteal muscle from sheep. Various compositions of agarose and gelatin mixtures were tested to achieve a muscle-like consistency. The muscle-equivalent ballistic gel was found to consist of 29.5% gelatin and 0.35% agarose. Bones remained stable within the ballistic gel setup after freeze-thaw cycles between -20 °C and +20 °C. This method reduces the variability caused by muscle and improves storage quality, allowing for tests to be conducted under consistent conditionsBallistic gels of agarose and gelatin are suitable for bone fracture models. They have muscle-like strength, fix fractures simultaneously, are inexpensive to produce, and can be stored to allow repeated measurements of the same object with changing questions.