RESUMO
OBJECTIVE: Twenty-four-hour multichannel intraluminal impedance (MII) and pH monitoring is used for detecting reflux episodes in patients with gastroesophageal reflux (GER) disease. However, the clinical significance of baseline impedance levels (BILs) has not been well studied. We aimed to evaluate whether BILs are related to various reflux events or acid-related parameters and to determine whether BILs during specific intervals could be substituted for 24-h BILs. MATERIAL AND METHODS: One-hundred forty-two patients GER symptoms underwent 24-h pH/impedance monitoring. We measured pH [(5 cm above the low esophageal sphincter (LES)] and BILs from three sites (3, 5, and 15 cm above the LES). RESULTS: Eighty-one subjects (57.0%) were diagnosed with gastroesophageal reflux disease, and 53 (37.3%) had acid reflux and 28 (19.7%) had nonacid reflux. The 24-h BILs at distal sites were lower in the "reflux" group than in the "no reflux" group (p < 0.001) and lower in the "acid reflux" group than in the "nonacid reflux" group (p < 0.001). However, there was no significant difference in 24-h BILs at the proximal site among the "no reflux", "acid reflux", and "nonacid reflux" groups. The interclass correlation coefficient value of 24-h BILs with daytime 6-h BILs was 0.916 (95% CI 0.882-0.940) and that with nighttime 6-h BILs was 0.909 (95% CI 0.871-0.935). CONCLUSION: BILs are related to GER, especially acid reflux. Location and duration of assessment for BILs needs to be standardized. Six-hour BILs could be substitutes for 24-h BILs. During analysis of MII-pH, more attention should be paid to BILs in the lower esophagus.
Assuntos
Monitoramento do pH Esofágico/métodos , Refluxo Gastroesofágico/diagnóstico , Adolescente , Adulto , Idoso , Impedância Elétrica , Esôfago , Feminino , Humanos , Masculino , Pessoa de Meia-Idade , Estudos Retrospectivos , Fatores de TempoRESUMO
This study investigates the effects of annealing on the tunnel magnetoresistance (TMR) ratio in CoFeB/MgO/CoFeB-based magnetic tunnel junctions (MTJs) with different capping layers and correlates them with microstructural changes. It is found that the capping layer plays an important role in determining the maximum TMR ratio and the corresponding annealing temperature (Tann). For a Pt capping layer, the TMR reaches ~95% at a Tann of 350 °C, then decreases upon a further increase in Tann. A microstructural analysis reveals that the low TMR is due to severe intermixing in the Pt/CoFeB layers. On the other hand, when introducing a Ta capping layer with suppressed diffusion into the CoFeB layer, the TMR continues to increase with Tann up to 400 °C, reaching ~250%. Our findings indicate that the proper selection of a capping layer can increase the annealing temperature of MTJs so that it becomes compatible with the complementary metal-oxide-semiconductor backend process.
RESUMO
Discrete track magnetic recording media with a 60 nm track pitch and prewritten servo patterns were fabricated and tested for read/write performance, and a feasibility analysis of the embedded servo was performed. The fabrication process consisted of ultraviolet nanoimprint lithography (UV-NIL) and sequential ion beam etching on a conventional perpendicular magnetic recording medium. Magnetic patterns were written to the fabricated tracks at 700 kilo flux changes per inch (kFCI) using a spin stand and were read using magnetic force microscopy (MFM), with a resulting signal-to-noise ratio (SNR) of 12.15 dB. The servo pattern was also visualized with MFM. These results demonstrated the feasibility of writing to a 30 nm wide discrete data track and the workability of the embedded servo pattern.
RESUMO
Spatial light modulators are essential optical elements in applications that require the ability to regulate the amplitude, phase and polarization of light, such as digital holography, optical communications and biomedical imaging. With the push towards miniaturization of optical components, static metasurfaces are used as competent alternatives. These evolved to active metasurfaces in which light-wavefront manipulation can be done in a time-dependent fashion. The active metasurfaces reported so far, however, still show incomplete phase modulation (below 360°). Here we present an all-solid-state, electrically tunable and reflective metasurface array that can generate a specific phase or a continuous sweep between 0 and 360° at an estimated rate of 5.4 MHz while independently adjusting the amplitude. The metasurface features 550 individually addressable nanoresonators in a 250 × 250 µm2 area with no micromechanical elements or liquid crystals. A key feature of our design is the presence of two independent control parameters (top and bottom gate voltages) in each nanoresonator, which are used to adjust the real and imaginary parts of the reflection coefficient independently. To demonstrate this array's use in light detection and ranging, we performed a three-dimensional depth scan of an emulated street scene that consisted of a model car and a human figure up to a distance of 4.7 m.
Assuntos
Dispositivos Ópticos , Tecnologia de Sensoriamento Remoto/instrumentação , Automóveis , Desenho de Equipamento , Humanos , Imageamento Tridimensional , Luz , Cristais Líquidos , Miniaturização , Nanoestruturas/química , Nanotecnologia/instrumentação , Estudo de Prova de Conceito , Tecnologia de Sensoriamento Remoto/métodosRESUMO
Bit patterned media with 25 nm hole diameter and 50 nm pitch size were fabricated with serial processes comprising master patterning with electron-beam lithography, a Si etching process, multi-layer soft stamp replication, and UV nanoimprinting, followed by Co-Pt magnetic material filling by electro-deposition. From these processes, the designed patterns were well defined, and perpendicular magnetic anisotropy of the fabricated bit patterned media was obtained.
RESUMO
Tunable metasurfaces enable dynamical control of the key constitutive properties of light at a subwavelength scale. To date, electrically tunable metasurfaces at near-infrared wavelengths have been realized using free carrier modulation, and switching of thermo-optical, liquid crystal and phase change media. However, the highest performance and lowest loss discrete optoelectronic modulators exploit the electro-optic effect in multiple-quantum-well heterostructures. Here, we report an all-dielectric active metasurface based on electro-optically tunable III-V multiple-quantum-wells patterned into subwavelength elements that each supports a hybrid Mie-guided mode resonance. The quantum-confined Stark effect actively modulates this volumetric hybrid resonance, and we observe a relative reflectance modulation of 270% and a phase shift from 0° to ~70°. Additionally, we demonstrate beam steering by applying an electrical bias to each element to actively change the metasurface period, an approach that can also realize tunable metalenses, active polarizers, and flat spatial light modulators.