Superporous agarose anion exchangers for plasmid isolation.

Superporous agarose beads have wide, connecting flow pores allowing large molecules such as plasmids to be transported into the interior of the beads by convective flow. The pore walls provide additional surface for plasmid binding thus increasing the binding capacity of the adsorbent. Novel superporous agarose anion exchangers have been prepared, differing with respect to bead diameter, superpore diameter and type of anion-exchange functional group (poly(ethyleneimine) and quaternary amine). The plasmid binding capacities were obtained from breakthrough curves and compared with the binding capacity of homogeneous agarose beads of the same particle size. Significantly, the smaller diameter superporous agarose beads were found to have four to five times higher plasmid binding capacity than the corresponding homogeneous agarose beads. The experimentally determined plasmid binding capacity was compared with the theoretically calculated surface area for each adsorbent and fair agreement was found. Confocal microscopy studies of beads with adsorbed, fluorescently labelled plasmids aided in the interpretation of the results. Superporous poly(ethyleneimine)-substituted beads with a high ion capacity (230 micromol/ml) showed a plasmid binding of 3-4 mg/ml adsorbent. Superporous quaternary amine-substituted beads had a lower ion capacity (81 micromol/ml) and showed a correspondingly lower plasmid binding capacity (1-2 mg/ml adsorbent). In spite of the lower capacity, the beads with quaternary amine ligand were preferred, due to their much better plasmid recovery (70-100% recovery). Interestingly, both capacity and recovery was improved when the plasmid adsorption step was carried out in the presence of a moderate salt concentration. The most suitable superporous bead type (45-75 microm diameter beads; 4 microm superpores; quaternary amine ligand) was chosen for the capture of plasmid DNA from a clarified alkaline lysate. Two strategies were evaluated, one with and one without enzymatic digestion of RNA. The strategy without RNase gave high plasmid recovery, quantitative removal of protein and a 70% reduction in RNA.

Confocal Raman and fluorescence spectroscopy applied to polymeric chromatographic adsorbent particles.

Distributions of functional groups in individual chromatographic adsorbent particles have been investigated using confocal Raman and fluorescence spectroscopy. Measurements have been performed with different microscope objectives and it was found that an immersion objective should be used when wet adsorbent particles are analysed. Nd3+ ions have been used as fluorescence probes to evaluate the distribution of chelating and negatively charged functional groups. The fluorescence spectrum from Nd3+ has also been used to obtain information about the coordination of Nd3+ within the adsorbent particles.

Mechanism and kinetics of protein transport in chromatographic media studied by confocal laser scanning microscopy. Part I. The interplay of sorbent structure and fluid phase conditions.

An experimental study on the interplay of sorbent structure and fluid phase conditions (pH) has been carried out examining adsorption and transport of bovine serum albumin (BSA) and a monoclonal antibody (IgG 2a) on SP Sepharose Fast Flow and SP Sepharose XL. SP Sepharose Fast Flow is characterised by a relatively open pore network, while SP Sepharose XL is a composite structure with ligand-carrying dextran chains filling the pore space. Both adsorbents have similar ionic capacity. Protein transport and adsorption profiles were evaluated using confocal laser scanning microscopy. Under all investigated conditions, BSA uptake could be adequately explained by a pore diffusion mechanism. The adsorption profiles obtained for IgG 2a, however, indicated that changes in fluid phase conditions as well as a change in the solid phase structure could result in a more complex uptake mechanism as compared to pore diffusion alone. This mechanism results in a fast transport of proteins into the adsorbent, followed by an overshoot of protein in the center of the sorbent and a setback towards a homogeneous adsorption profile.

Ligand distributions in agarose particles as determined by confocal Raman spectroscopy and confocal scanning laser microscopy.

Confocal Raman spectroscopy and confocal scanning laser microscopy have been used to analyze ligand distributions within individual chromatographic adsorbent particles. Three different types of particles have been investigated. The first type was synthesized to have a uniform distribution of allyl groups, whereas the two others were designed to have a surface layer of sulphopropyl groups and cores containing allyl groups and dextran, respectively. With confocal Raman spectroscopy it was possible to follow the distribution of both the surface layer and the interior. The distribution of sulphopropyl groups was evaluated with both confocal scanning laser microscopy and confocal Raman spectroscopy, whereas the distributions of allyl groups and dextran were evaluated only with the latter method. The results from the confocal measurements showed the expected result with a uniform distribution of allyl groups in the first type of particle and surface layers of sulphopropyl groups and cores with dextran or allyl groups for the two others.

Ion exchange chromatography of antibody fragments.

Effects of pH and conductivity on the ion exchange chromatographic purification of an antigen-binding antibody fragment (Fab) of pI 8.0 were investigated. Normal sulfopropyl (SP) group modified agarose particles (SP Sepharosetrade mark Fast Flow) and dextran modified particles (SP Sepharose XL) were studied. Chromatographic measurements including adsorption isotherms and dynamic breakthrough binding capacities, were complemented with laser scanning confocal microscopy. As expected static equilibrium and dynamic binding capacities were generally reduced by increasing mobile phase conductivity (1-25 mS/cm). However at pH 4 on SP Sepharose XL, Fab dynamic binding capacity increased from 130 to 160 (mg/mL media) as mobile phase conductivity changed from 1 to 5 mS/cm. Decreasing protein net charge by increasing pH from 4 to 5 at 1.3 mS/cm caused dynamic binding capacity to increase from 130 to 180 mg/mL. Confocal scanning laser microscopy studies indicate such increases were due to faster intra-particle mass transport and hence greater utilization of the media's available binding capacity. Such results are in agreement with recent studies related to ion exchange of whole antibody molecules under similar conditions.