Versatile, compact chirped pulse amplifier pump system for ultrafast optical parametric amplifiers.

We report on the development of a pump system for ultrafast optical parametric amplifiers (uOPA) as an upgrade for the existing uOPA at the Petawatt High Energy Laser for heavy Ion eXperiments (PHELIX) and the new Petawatt ENergy-Efficient Laser for Optical Plasma Experiments (PEnELOPE). The system consists of a two-stage chirped pulse amplifier, centered around a high energy Yb:YAG regenerative amplifier that delivers 108 mJ uncompressed output energy, resulting in 92 mJ at 1030 nm after compression, pulse durations of 1.4 ps, a high beam quality of Mx/y2 = 1.02 / 1.16 and a relative energy stability of 0.35 %. A second harmonic generation (SHG) efficiency of up to 70 % is achievable and a maximum pulse energy of 43 mJ at 515 nm has been obtained, which is only limited by the damage threshold of the SHG crystal. A self-phase modulation stage makes this system a widely applicable, self-seedable pump module for uOPA without placing strong requirements on its seed oscillator.

Compact millijoule Yb3+:CaF2 laser with 162 fs pulses.

We report on a compact diode-pumped, chirped pulse regenerative amplifier system with a pulse duration of 162 fs and an output pulse energy of 1 mJ before as well as 910 µJ after compression optimized for the probing of ultrafast relativistic laser-plasma processes. A chirped volume Bragg grating (CVBG) acts as a combined pulse stretcher/compressor representing a robust solution for a CPA laser system in the millijoule range. Yb3+:CaF2 is used as gain medium to support a large bandwidth of 16 nm (FWHM) when spectral gain shaping is applied. Chirped mirrors compensate for any additional dispersion introduced to the system.

High-energy diode-pumped D2O-cooled multislab Yb:YAG and Yb:QX-glass lasers.

We investigated the lasing performance of a multislab Yb:QX and Yb:YAG laser amplifiers using a facet-cooled design. Di-deuterium oxide (D2O) was used as the coolant flowing between the active slabs with the pump and laser light passing through the very low absorbing heavy-water films. A square pump profile at a maximum intensity of 40 kW/cm2 drove the amplifier with a peak fluence of 5.5 J/cm2 and a pulse duration of 6 ns. We demonstrated a maximum pulse energy of 1 J for each gain medium as well as a repetition rate of 10 Hz for Yb:YAG and 1 Hz for Yb:QX glass, thus showing the feasibility and scalability of directly water-cooled, diode-pumped, high-energy short-pulse lasers.

Efficient burst mode amplifier for ultra-short pulses based on cryogenically cooled Yb³âº:CaF2.

We present a novel approach for the amplification of high peak power femtosecond laser pulses at a high repetition rate. This approach is based on an all-diode pumped burst mode laser scheme. In this scheme, pulse bursts with a total duration between 1 and 2 ms are be generated and amplified. They contain 50 to 2000 individual pulses equally spaced in time. The individual pulses have an initial duration of 350 fs and are stretched to 50 ps prior to amplification. The amplifier stage is based on Yb3+:CaF2 cooled to 100 K. In this amplifier, a total output energy in excess of 600 mJ per burst at a repetition rate of 10 Hz is demonstrated. For lower repetition rates the total output energy per burst can be scaled up to 915 mJ using a longer pump duration. This corresponds to an efficiency as high as 25% of extracted energy from absorbed pump energy. This is the highest efficiency, which has so far been demonstrated for a pulsed Yb3+:CaF2 amplifier.

Temperature dependent emission and absorption cross section of Yb3+ doped yttrium lanthanum oxide (YLO) ceramic and its application in diode pumped amplifier.

Temperature dependent absorption and emission cross-sections of 5 at% Yb(3+) doped yttrium lanthanum oxide (Yb:YLO) ceramic between 80K and 300 K are presented. In addition, we report on the first demonstration of ns pulse amplification in Yb:YLO ceramic. A pulse energy of 102 mJ was extracted from a multi-pass amplifier setup. The amplification bandwidth at room temperature confirms the potential of Yb:YLO ceramic for broad bandwidth amplification at cryogenic temperatures.

Ultra-short pulse laser acceleration of protons to 80 MeV from cryogenic hydrogen jets tailored to near-critical density.

Laser plasma-based particle accelerators attract great interest in fields where conventional accelerators reach limits based on size, cost or beam parameters. Despite the fact that particle in cell simulations have predicted several advantageous ion acceleration schemes, laser accelerators have not yet reached their full potential in producing simultaneous high-radiation doses at high particle energies. The most stringent limitation is the lack of a suitable high-repetition rate target that also provides a high degree of control of the plasma conditions required to access these advanced regimes. Here, we demonstrate that the interaction of petawatt-class laser pulses with a pre-formed micrometer-sized cryogenic hydrogen jet plasma overcomes these limitations enabling tailored density scans from the solid to the underdense regime. Our proof-of-concept experiment demonstrates that the near-critical plasma density profile produces proton energies of up to 80 MeV. Based on hydrodynamic and three-dimensional particle in cell simulations, transition between different acceleration schemes are shown, suggesting enhanced proton acceleration at the relativistic transparency front for the optimal case.

High-efficiency 10 J diode pumped cryogenic gas cooled Yb:YAG multislab amplifier.

We report on the first demonstration of a diode-pumped, gas cooled, cryogenic multislab Yb:YAG amplifier. The performance was characterized over a temperature range from 88 to 175 K. A maximum small-signal single-pass longitudinal gain of 11.0 was measured at 88 K. When amplifying nanosecond pulses, recorded output energies were 10.1 J at 1 Hz in a four-pass extraction geometry and 6.4 J at 10 Hz in a three-pass setup, corresponding to optical to optical conversion efficiencies of 21% and 16%, respectively. To our knowledge, this represents the highest pulse energy so far obtained from a cryo-cooled Yb-laser and the highest efficiency from a multijoule diode pumped solid-state laser system.

Broadband, diode pumped Yb:SiO2 multicomponent glass laser.

Fabrication, spectroscopic properties, and laser performance of a Yb:SiO(2) multicomponent glass have been investigated in this paper. The glass system composed of SiO(2), Al(2)O(3), and La(2)O(3) excels in terms of a high thermal stress resistance compared to other laser glasses. The laser experiments were conducted with a 3.4 mm thick and 0.9 mol. % Y(2)O(3) doped sample. A maximum slope efficiency of 51%, a maximum optical to optical efficiency of 42%, and a tuning range from 1010-1090 nm was realized. Due to the promising laser properties and a straightforward fabrication technique it may well qualify as an alternative gain medium in high-energy, ultrashort pulse laser systems.

Time-of-flight spectroscopy for laser-driven proton beam monitoring.

Application experiments with laser plasma-based accelerators (LPA) for protons have to cope with the inherent fluctuations of the proton source. This creates a demand for non-destructive and online spectral characterization of the proton pulses, which are for application experiments mostly spectrally filtered and transported by a beamline. Here, we present a scintillator-based time-of-flight (ToF) beam monitoring system (BMS) for the recording of single-pulse proton energy spectra. The setup's capabilities are showcased by characterizing the spectral stability for the transport of LPA protons for two beamline application cases. For the two beamline settings monitored, data of 122 and 144 proton pulses collected over multiple days were evaluated, respectively. A relative energy uncertainty of 5.5% (1[Formula: see text]) is reached for the ToF BMS, allowing for a Monte-Carlo based prediction of depth dose distributions, also used for the calibration of the device. Finally, online spectral monitoring combined with the prediction of the corresponding depth dose distribution in the irradiated samples is demonstrated to enhance applicability of plasma sources in dose-critical scenarios.

Off-harmonic optical probing of high intensity laser plasma expansion dynamics in solid density hydrogen jets.

Due to the non-linear nature of relativistic laser induced plasma processes, the development of laser-plasma accelerators requires precise numerical modeling. Especially high intensity laser-solid interactions are sensitive to the temporal laser rising edge and the predictive capability of simulations suffers from incomplete information on the plasma state at the onset of the relativistic interaction. Experimental diagnostics utilizing ultra-fast optical backlighters can help to ease this challenge by providing temporally resolved inside into the plasma density evolution. We present the successful implementation of an off-harmonic optical probe laser setup to investigate the interaction of a high-intensity laser at [Formula: see text] peak intensity with a solid-density cylindrical cryogenic hydrogen jet target of [Formula: see text] diameter as a target test bed. The temporal synchronization of pump and probe laser, spectral filtering and spectrally resolved data of the parasitic plasma self-emission are discussed. The probing technique mitigates detector saturation by self-emission and allowed to record a temporal scan of shadowgraphy data revealing details of the target ionization and expansion dynamics that were so far not accessible for the given laser intensity. Plasma expansion speeds of up to [Formula: see text] followed by full target transparency at [Formula: see text] after the high intensity laser peak are observed. A three dimensional particle-in-cell simulation initiated with the diagnosed target pre-expansion at [Formula: see text] and post processed by ray tracing simulations supports the experimental observations and demonstrates the capability of time resolved optical diagnostics to provide quantitative input and feedback to the numerical treatment within the time frame of the relativistic laser-plasma interaction.

Efficient laser-driven proton acceleration from cylindrical and planar cryogenic hydrogen jets.

We report on recent experimental results deploying a continuous cryogenic hydrogen jet as a debris-free, renewable laser-driven source of pure proton beams generated at the 150 TW ultrashort pulse laser Draco. Efficient proton acceleration reaching cut-off energies of up to 20 MeV with particle numbers exceeding 109 particles per MeV per steradian is demonstrated, showing for the first time that the acceleration performance is comparable to solid foil targets with thicknesses in the micrometer range. Two different target geometries are presented and their proton beam deliverance characterized: cylindrical (∅ 5 µm) and planar (20 µm × 2 µm). In both cases typical Target Normal Sheath Acceleration emission patterns with exponential proton energy spectra are detected. Significantly higher proton numbers in laser-forward direction are observed when deploying the planar jet as compared to the cylindrical jet case. This is confirmed by two-dimensional Particle-in-Cell (2D3V PIC) simulations, which demonstrate that the planar jet proves favorable as its geometry leads to more optimized acceleration conditions.