Modification of AgNP-Decorated PET: A Promising Strategy for Preparation of AgNP-Filled Nuclear Pores in Polymer Membranes.

Polymer-based membranes represent an irreplaceable group of materials that can be applied in a wide range of key industrial areas, from packaging to high-end technologies. Increased selectivity to transport properties or the possibility of controlling membrane permeability by external stimuli represents a key issue in current material research. In this work, we present an unconventional approach with the introduction of silver nanoparticles (AgNPs) into membrane pores, by immobilising them onto the surface of polyethyleneterephthalate (PET) foil with subsequent physical modification by means of laser and plasma radiation prior to membrane preparation. Our results showed that the surface characteristics of AgNP-decorated PET (surface morphology, AgNP content, and depth profile) affected the distribution and concentration of AgNPs in subsequent ion-track membranes. We believe that the presented approach affecting the redistribution of AgNPs in the polymer volume may open up new possibilities for the preparation of metal nanoparticle-filled polymeric membranes. The presence of AgNPs on the pore walls can facilitate the grafting of stimuli-responsive molecules onto these active sites and may contribute to the development of intelligent membranes with controllable transport properties.

Polyvinylalcohol Composite Filled with Carbon Dots Produced by Laser Ablation in Liquids.

Carbon dots (CDs), owing to their excellent photoluminescent features, have been extensively studied for physics preparation methods and for biomedical and optoelectronic device applications. The assessment of the applicability of CDs in the production of luminescent polymeric composites used in LEDs, displays, sensors, and wearable devices is being pursued. The present study reports on an original, environmentally friendly, and low-cost route for the production of carbon dots with an average size of 4 nm by laser ablation in liquid. Jointly, to prove the significance of the study for a wide range of applications, a free-standing flexible polyvinyl alcohol (PVA) composite containing photoluminescent carbon dots was manufactured. CDs were prepared using targets of porose charcoal with a density of 0.271 g/cm3 placed in phosphate-buffered saline (PBS) liquid solution and irradiated for 30 min by pulsed IR diode laser. The optical properties of the obtained suspension containing carbon dots were studied with UV-ViS and FTIR spectroscopies. The photoluminescence of the produced carbon dots was confirmed by the emission peak at 480 nm in the luminescence spectrum. A narrow luminescence band with a full width at half-maximum (FWHM) of less than 40 nm could be an asset in spectral emission analysis in different applications. Atomic force microscopy confirms the feasibility of manufacturing CDs in clean and biocompatible environments, paving the way for an easier and faster production route, crucial for their wider applicability.