Impact of dietary regime on the metabolomic profile of bovine buttermilk and whole milk powder.

INTRODUCTION: Bovine milk contains a rich matrix of nutrients such as carbohydrates, fat, protein and various vitamins and minerals, the composition of which is altered by factors including dietary regime. OBJECTIVES: The objective of this research was to investigate the impact of dietary regime on the metabolite composition of bovine whole milk powder and buttermilk. METHODS: Bovine whole milk powder and buttermilk samples were obtained from spring-calving cows, consuming one of three diets. Group 1 grazed outdoors on perennial ryegrass which was supplemented with 5% concentrates; group 2 were maintained indoors and consumed a total mixed ration diet; and group 3 consumed a partial mixed ration diet consisting of perennial ryegrass during the day and total mixed ration maintained indoors at night. RESULTS: Metabolomic analysis of the whole milk powder (N = 27) and buttermilk (N = 29) samples was preformed using liquid chromatography-tandem mass spectrometry, with 504 and 134 metabolites identified in the samples respectively. In whole milk powder samples, a total of 174 metabolites from various compound classes were significantly different across dietary regimes (FDR adjusted p-value ≤ 0.05), including triglycerides, of which 66% had their highest levels in pasture-fed samples. Triglycerides with highest levels in pasture-fed samples were predominantly polyunsaturated with high total carbon number. Regarding buttermilk samples, metabolites significantly different across dietary regimes included phospholipids, sphingomyelins and an acylcarnitine. CONCLUSION: In conclusion the results reveal a significant impact of a pasture-fed dietary regime on the metabolite composition of bovine dairy products, with a particular impact on lipid compound classes.

Unlocking the nutritional and functional potential of legume waste to produce protein ingredients.

Worldwide, many production supply chains generate a considerable amount of legume by-products (e.g., leaves, husks, broken seeds, defatted cakes). These wastes can be revalorized to develop sustainable protein ingredients, with positive economic and environmental effects. To separate protein from legume by-products, a broad spectrum of conventional (e.g., alkaline solubilization, isoelectric precipitation, membrane filtration) and novel methodologies (e.g., ultrasound, high-pressure homogenization, enzymatic approaches) have been studied. In this review, these techniques and their efficiency are discussed in detail. The present paper also provides an overview of the nutritional and functional characteristics of proteins extracted from legume by-products. Moreover, existing challenges and limitations associated with the valorization of by-product proteins are highlighted, and future perspectives are proposed.

Impact of varying levels of pasture allowance on the nutritional quality and functionality of milk throughout lactation.

The objective of this study was to examine the impact of increasing proportions of grazed pasture in the diet on the composition, quality, and functionality of bovine milk across a full lactation. Fifty-four spring-calving cows were randomly assigned to 1 of 3 groups (n = 18), blocked on the basis of mean calving date (February 15, 2020 ± 0.8 d), pre-experimental daily milk yield (24.70 ± 3.70 kg), milk solids yield (2.30 ± 0.27 kg), lactation number (3.10 ± 0.13), and economic breeding index (182 ± 19). Raw milk samples were obtained weekly from each group between March and November 2020. Group 1 (GRS) consumed perennial ryegrass and was supplemented with 5% concentrates (dry matter basis); group 2 was maintained indoors and consumed a total mixed ration (TMR) diet consisting of maize silage, grass silage, and concentrates; and group 3 consumed a partial mixed ration diet (PMR), rotating between perennial ryegrass during the day and indoor TMR feeding at night. Raw milk samples consisted of a pooled morning and evening milking and were analyzed for gross composition, free amino acids, fatty acid composition, heat coagulation time, color, fat globule size, and pH. The TMR milks had a significantly higher total solids, lactose, protein, and whey protein as a proportion of protein content compared with both GRS and PMR milks. The GRS milks demonstrated a significantly lower somatic cell count (SCC), but a significantly higher pH and b*-value than both TMR and PMR milks. The PMR milks exhibited significantly lower total solids and fat content, but also demonstrated significantly higher SCC and total free amino acid content compared with GRS and TMR. Partial least squares discriminant analysis of fatty acid profiles displayed a distinct separation between GRS and TMR samples, while PMR displayed an overlap between both GRS and TMR groupings. Variable importance in projection analysis identified conjugated linoleic acid cis-9,trans-11, C18:2n-6 cis, C18:3n-3, C11:0, and C18:2n-6 trans as the largest contributors to the variation between the diets. Milk fats derived from GRS diets exhibited the highest proportion of unsaturated fats and higher unsaturation, health-promoting, and desaturase indices. The lowest proportions of saturated fats and the lowest atherogenic index were also exhibited by GRS-derived milk fats. This work highlights the positive influence of grass-fed milk for human consumption through its more nutritionally beneficial fatty acid profile, despite the highest milk solid percentages derived from TMR feeding systems. Furthermore, this study demonstrates the proportional response of previously highlighted biomarkers of pasture feeding to the proportion of pasture in the cow's diet.

Nondairy food applications of whey and milk permeates: Direct and indirect uses.

Permeates are generated in the dairy industry as byproducts from the production of high-protein products (e.g., whey or milk protein isolates and concentrates). Traditionally, permeate was disposed of as waste or used in animal feed, but with the recent move toward a "zero waste" economy, these streams are being recognized for their potential use as ingredients, or as raw materials for the production of value-added products. Permeates can be added directly into foods such as baked goods, meats, and soups, for use as sucrose or sodium replacers, or can be used in the production of prebiotic drinks or sports beverages. In-direct applications generally utilize the lactose present in permeate for the production of higher value lactose derivatives, such as lactic acid, or prebiotic carbohydrates such as lactulose. However, the impurities present, short shelf life, and difficulty handling these streams can present challenges for manufacturers and hinder the efficiency of downstream processes, especially compared to pure lactose solutions. In addition, the majority of these applications are still in the research stage and the economic feasibility of each application still needs to be investigated. This review will discuss the wide variety of nondairy, food-based applications of milk and whey permeates, with particular focus on the advantages and disadvantages associated with each application and the suitability of different permeate types (i.e., milk, acid, or sweet whey).

Determining the influence of fava bean pre-processing on extractability and functional quality of protein isolates.

In this study, fava bean protein (FPI) was isolated from flours prepared from dehulled seeds and compared to FPI extracted from whole flours; in the latter case, flours were prepared either by dry- or wet-milling. Significant differences in composition and functionality were observed between the three FPIs produced. Dehulling maximized protein purity, oil-absorption capacity, solubility, foamablity and minimized both starchy and non-starchy carbohydrate contents. Protein isolated from wet-milled whole beans provided higher mass and extraction yields, better water-absorption capacity, and exhibited higher surface charge (zeta potential) compared to other samples. The protein extracted from dry-milled whole seed exhibited a higher least gelation concentration, emulsifying activity and zeta value compared to its dehulled counterpart. Dehulling was also found to be a useful process to increase the lightness/whiteness of protein powder. Overall, the present findings provide useful technological information relating to the production of FPI with and without a dehulling step.

Pulse Spray Drying for Bovine Skimmed Milk Powder Production.

Pulse Spray Drying (PSD) has potential as a sustainable means of skimmed milk powder (SMP) production. In this study, powders were obtained from PSD using different drying outlet temperatures (70, 80, 90 and 100 °C), and their characteristics were compared to those of traditional Spray Drying (SD). Native whey proteins were well preserved and Solubility Indexes were over 98% in all cases, despite powders obtained by PSD displaying lower solubility than the SD ones. No visual difference was observable in the powders (ΔE < 2); however, PSD powders were found to be yellower with a higher Browning Index. The drying technology did not have a significant effect on powder moisture content and bulk density. Particle size distribution and scanning electron microscopy images confirmed the presence of fine particles (<10 µm) in all samples that might have provided poor flowability and wetting behavior (overall Carr Index and Hausner ratio were 33.86 ± 3.25% and 1.52 ± 0.07, respectively). Higher amounts of agglomerated particles were found at low temperatures in the products processed with both technologies, but PSD samples showed a narrower particle size distribution and hollow particles with more wrinkles on the surface (probably due to the fast evaporation rate in PSD). Overall, PSD provided SMP with comparable physicochemical characteristics to SD and, once optimized at the industrial level, could offer significant advantages in terms of thermal efficiency without significant modification of the final product quality.

The Impact of Seasonality in Pasture-Based Production Systems on Milk Composition and Functionality.

Seasonal calving, pasture-based dairy systems are widely practiced in countries with a temperate climate and plentiful rainfall such as Ireland and New Zealand. This approach maximizes milk production from pasture and, consequently, is a low-cost, low-input dairy production system. On the other hand, the majority of global milk supply is derived from high input indoor total mixed ration systems where seasonal calving is not practiced due to the dependence on ensiled silages, grains and concentrated feeds, which are available year-round. Synchronous changes in the macro and micronutrients in milk are much more noticeable as lactation progresses through early, mid and late stages in seasonal systems compared to non-seasonal systems-which can have implications on the processability and functionality of milk.

Powder and Reconstituted Properties of Commercial Infant and Follow-On Formulas.

The physical properties of 15 commercially available infant formulas (IF) and follow-on (FO) formulas were analysed. Powders made with intact milk proteins were classified into two groups; Type I-homogenous mixtures of milk powder particles (n = 6); and Type II-heterogeneous mixtures of milk powder particles and tomahawk-shaped α-lactose monohydrate crystals (n = 6). Powders made using hydrolysed proteins were classified as Type III powders (n = 3). Type II powders exhibited similar flow characteristics to Type I powders despite having significantly (p < 0.05) smaller particle size, lower circularity, and greater elongation. Type III powders exhibited lowest particles size, highest surface free fat, and poorest flow properties (p < 0.05 for all). Upon reconstitution of powders (12.5% w/w), no significant difference (p < 0.05) in apparent viscosity was observed between Type I and II powders. Reconstituted Type III powders had relatively poor stability to separation compared to Type I and II powders, caused by large starch granules and/or poor emulsification by hydrolysed proteins. Overall, this study illustrated the range of physical behaviour and structures present in commercial IF powders. In particular, the effect of dry addition of lactose and the hydrolysis of protein were found to have major effects on physical properties.

Dynamic Mechanical Analysis as a Complementary Technique for Stickiness Determination in Model Whey Protein Powders.

The α-relaxation temperatures (Tα), derived from the storage and loss moduli using dynamic mechanical analysis (DMA), were compared to methods for stickiness and glass transition determination for a selection of model whey protein concentrate (WPC) powders with varying protein contents. Glass transition temperatures (Tg) were determined using differential scanning calorimetry (DSC), and stickiness behavior was characterized using a fluidization technique. For the lower protein powders (WPC 20 and 35), the mechanical Tα determined from the storage modulus of the DMA (Tα onset) were in good agreement with the fluidization results, whereas for higher protein powders (WPC 50 and 65), the fluidization results compared better to the loss modulus results of the DMA (Tα peak). This study demonstrates that DMA has the potential to be a useful technique to complement stickiness characterization of dairy powders by providing an increased understanding of the mechanisms of stickiness.

Decoupling macronutrient interactions during heating of model infant milk formulas.

Understanding macronutrient interactions during heating is important for controlling viscosity during infant milk formula (IMF) manufacture. Thermal behavior of macronutrients (casein, whey, lactose, fat) was studied, in isolation and combination, over a range of concentrations. Addition of phosphocasein to whey protein solutions elevated denaturation temperature (Td) of ß-lactoglobulin and the temperature at which viscosity started to increase upon heating (Tv). Secondary structural changes in whey proteins occurred at higher temperatures in dispersions containing phosphocasein; the final extent of viscosity increase was similar to that of whey protein alone. Addition of lactose to whey protein solutions delayed secondary structural changes, increased Td and Tv, and reduced post heat treatment viscosity. This study demonstrated that heat-induced changes in IMF associated with whey protein (denaturation, viscosity) are not only a function of concentration but are also dependent on interactions between macronutrients.