RESUMO
The frequent use of synthetic pesticides to control Aedes aegypti population can lead to environmental and/or human contamination and the emergence of resistant insects. Linalool and methyl cinnamate are presented as an alternative to the synthetic pesticides, since they can exhibit larvicidal, repellent and/or insecticidal activity and are considered safe for use. The aim of this study was to evaluate the larvicidal activity of methyl cinnamate, linalool and methyl cinnamate/linalool in combination (MC-L) (1:4 ratio, respectively) against Aedes aegypti. The in vitro preliminary toxicity through brine shrimp lethality assay and hemolytic activity, and the phytotoxic potential were also investigated to assess the safety of their use as larvicide. Methyl cinnamate showed significant larvicidal activity when compared to linalool (LC50 values of 35.4µg/mL and 275.2µg/mL, respectively) and to MC-L (LC50 138.0µg/mL). Larvae morphological changes subjected to the specified treatments were observed, as the flooding of tracheal system and midgut damage, hindering the larval development and survival. Preliminary in vitro toxicity through brine shrimp showed the high bioactivity of the substances (methyl cinnamate LC50 35.5µg/mL; linalool LC50 96.1µg/mL) and the mixture (MC-L LC50 57.7µg/mL). The results showed that, despite the higher larvicidal activity of methyl cinnamate, the use of MC-L as a larvicide seems to be more appropriate due to its significant larvicidal activity and low toxicity.
Assuntos
Aedes/efeitos dos fármacos , Cinamatos/toxicidade , Inseticidas/toxicidade , Larva/efeitos dos fármacos , Monoterpenos/toxicidade , Monoterpenos Acíclicos , Aedes/crescimento & desenvolvimento , Animais , Artemia/efeitos dos fármacos , Sinergismo Farmacológico , Larva/crescimento & desenvolvimento , Dose Letal Mediana , Extratos Vegetais/toxicidadeRESUMO
This study investigated the resin-dentin bond strength (µTBS), degree of conversion (DC), and antibacterial potential of an innovative adhesive system containing a quaternary ammonium methacrylate polymer (QAMP) using in situ and in vitro assays. Forty-two human third molars were flattened until the dentin was exposed and were randomly distributed into three groups of self-etching adhesive systems: Clearfil™ SE Bond containing 5% QAMP (experimental group), Clearfil™ Protect Bond (positive control) and Clearfil™ SE Bond (negative control). After light curing, three 1 mm-increments of composite resin were bonded to each dentin surface. A total of thirty of these bonded teeth (10 teeth per group) was sectioned to obtain stick-shaped specimens and tested under tensile stress immediately, and after 6 and 12 months of storage in distilled water. Twelve bonded teeth (4 teeth per group) were longitudinally sectioned in a mesio-to-distal direction to obtain resin-bonded dentin slabs. In situ DC was evaluated by micro-Raman spectroscopy. In vitro DC of thin films of each adhesive system was measured using Fourier transform infrared spectroscopy. In vitro susceptibility tests of these three adhesive systems were performed by the minimum inhibitory/minimum bactericidal concentration (MIC/MBC) assays against Streptococcus mutans, Lactobacillus casei, and Actinomyces naeslundii. No statistically significant difference in µTBS was observed between Clearfil™ SE Bond containing 5% QAMP and Clearfil™ SE Bond (p>0.05) immediately, and after 6 and 12 months of water storage. However Clearfil™ Protect Bond showed a significant reduction of µTBS after 12 months of storage (p=0.039). In addition, QAMP provided no significant change in DC after incorporating into Clearfil™ SE Bond (p>0.05). Clearfil™ SE Bond containing 5% QAMP demonstrated MIC/MBC values similar to the positive control against L. casei and A. naeslundii and higher than the negative control for all evaluated bacterial strains. The use of QAMP in an adhesive system demonstrated effective bond strength, a suitable degree of conversion, and adequate antibacterial effects against oral bacteria, and may be useful as a new approach to provide long-lasting results for dental adhesives.
Assuntos
Cimentos Dentários/química , Metacrilatos/química , Polímeros/química , Compostos de Amônio Quaternário/química , Actinomyces/efeitos dos fármacos , Resinas Compostas/química , Resinas Compostas/farmacologia , Lâmpadas de Polimerização Dentária , Colagem Dentária , Cimentos Dentários/farmacologia , Humanos , Lacticaseibacillus casei/efeitos dos fármacos , Teste de Materiais , Testes de Sensibilidade Microbiana , Streptococcus mutans/efeitos dos fármacos , Propriedades de Superfície , Resistência à Tração , Fatores de TempoRESUMO
The aim of this paper was to use chromatographic tools for validating an analytical method for the tacrolimus (TAC) determination in polymeric nanocapsules and for identifying the drug degradation products after alkaline stress. A rapid Ultra-High-Performance Liquid Chromatography coupled with photo-diode array (UHPLC-PDA) method was successfully performed using the following chromatographic conditions: the Shimadzu Shim-pack XR-ODS III C18 column (100 mm×2.00 mm, 2.2 µm), the mobile phase consisting of methanol and acidified ultrapure water (89:11 v/v), the flow rate of 0.55 mL·min-1, and the ultraviolet (UV) detection at 235 nm. This method was validated as per International Council for Harmonisation (ICH) guidelines. In addition, a TAC forced degradation assay was carried out after alkaline stress and its degradation products were investigated using Liquid Chromatography coupled tandem mass spectroscopy (LC-MS/MS). The calibration curve was linear in the range of 100.0-300.0 µg·mL-1 (r >0.9999). Accuracy was confirmed by the TAC recovery of 96.55 to 98.19%. Precision (intraday and interday) were demonstrated by relative standard deviation lower than 0.89% and 3.25%, respectively. Selectivity and robustness were also proved. The method developed it was successfully applied to quantify TAC from polymeric nanocapsules, showing a high loading efficiency rate (>96.47%). The main drug degradation product observed in a multiple reaction monitoring (MRM) experiment was m/z 844, confirming the susceptibility of TAC under alkaline conditions; this finding was first time described.
Assuntos
Nanocápsulas , Cromatografia Líquida de Alta Pressão , Cromatografia Líquida , Poliésteres , Reprodutibilidade dos Testes , Tacrolimo , Espectrometria de Massas em TandemRESUMO
Capsaicinoids show several pharmacological effects including weight loss. However, their pungency limits the long-term use through the gastrointestinal tract. In that sense, the goal of this study was to prepare capsaicinoids-loaded poly(ε-caprolactone) microparticles as an oral carrier in order to improve their gastric tolerability and to make feasible the long-term treatment of obesity. Formulations containing 3, 5 and 10% capsaicinoids were successfully obtained by simple emulsion/solvent evaporation method. Values of encapsulation efficiency above 90% were achieved. Microparticles showed spherical shape and smooth surface. The particle size was suitable for oral use in order to provide an extended release through the gastrointestinal tract. No chemical bond was observed between drug and polymer. Microencapsulation led to drug amorphization. Formulations prolonged the release of capsaicinoids without changing the release kinetic (biexponential model). Microencapsulation increased the gastric tolerability of capsaicinoids because it prevented inflammatory processes in the stomach of rats. Microparticles containing 5% capsaicinoids demonstrated a statistically significant reduction of Lee index, mesenteric and retroperitoneal fat pads of rats with obesity induced by hypothalamic lesion using monosodium l-glutamate. In summary, capsaicinoids-loaded poly(ε-caprolactone) microparticles are low-irritative oral controlled-release carriers for a long-term use in obesity.