The influence of human resource management practices on occupational health and safety in the manufacturing industry.

This study provides an overview of the influence of applying two human resource management (HRM) practices on workers' occupational health and safety (OHS). These practices are selection and recruitment, and development and training. Furthermore, this study highlights the observed activities to define hazards, processes and OHS measures in the manufacturing industries. It also assesses the importance of workers' knowledge and awareness of OHS programs. A structured questionnaire was administered to those working in the manufacturing sector in several countries. The responses were analyzed statistically. The results showed that the demographic variables had a significant impact on workers' knowledge and awareness of OHS programs. In addition, HRM practices played a major role in OHS. Therefore, it is recommended to top management to highly consider OHS practices by integrating them into the workplace, starting from worker selection, all the way to production, operations and management, by establishing a strong HRM system.

The effect of resistance grooves on the fracture toughness of zirconia-based crowns from mono and cyclic loading.

OBJECTIVE: Prosthetic molar crowns in service are subjected to chewing loads, which cause a shift or dislodgment. The objective of this study is to investigate whether the addition of resistance grooves to the proximal surfaces of the abutment teeth would enhance the fracture resistance of the zirconia crowns and to compare between the patterns of cracks development on the zirconia crowns after the application of mono loading versus cyclic loading forces. MATERIALS AND METHODS: Thirty-six all-ceramic zirconia cored crowns were prepared on the same abutment. Resistance grooves were added to the mesial and distal surfaces of 16 abutments. Before testing, all specimens subjected to thermal aging. Two groups of crowns were then subjected to cyclic axial and lateral forces for 1,250,000 cycles in aqueous conditions. Two groups of samples were also tested in monoloading fashion. RESULTS: The crack pattern between mono and cyclic loading were compared. The crown fracture resistance was compared in the two types of abutments, with and without grooves. The results confirmed that the grooves addition had no effect on critical conditions to initiate failure in the case of mono loading. In cyclic loading, grooves addition increased the critical loads in the order of two. Failure patterns and location were obtained. CONCLUSIONS: The results showed that the location of retention grooves halted the failure in the surfaces where it was located in all loading mechanisms used in this study.