RESUMO
AnMBR technology is a promising alternative to achieve future energy-efficiency and environmental-friendly urban wastewater (UWW) treatment. However, the large amount of dissolved methane lost in the effluent represents a potential high environmental impact that hinder the feasibility of this technology for full-scale applications. The use of degassing membranes (DM) to capture the dissolved methane from AnMBR effluents can be considered as an interesting alternative to solve this problem although further research is required to assess the suitability of this emerging technology. The aim of this study was to assess the effect of operating temperature and hydrodynamics on the capture of dissolved methane from AnMBR effluents by DMs. To this aim, a commercial polydimethylsiloxane (PDMS) DM was coupled to an industrial prototype AnMBR (demonstration scale) treating UWW at ambient temperature. Different operating temperatures have been evaluated: 11, 18, 24 and 30 °C. Moreover, the DM was operated at different ratios of liquid flow rate to membrane area (QL:A) ranging from 22 to 190 Lh-1m-2 in order to study the resistance of the system to methane permeation. Methane recovery was maximized when temperature raised and QL:A was reduced, giving methane recovery efficiencies (MRE) of about 85% at a temperature of 30 °C and a QL:A of 25 Lh-1m-2. The study showed that high QL:A ratios hinder methane recovery by the perturbation of the DM fibers, being this effect intensified at lower temperatures probably due the higher liquid viscosities. Also, the performed fouling evaluation showed that not significant membrane fouling may be expected in the DM unit at the short-term when treating AnMBR effluents. A resistance-in-series model was proposed to predict the overall mass transfer of the system according to operating temperature and QL:A, showing that methane capture was controlled by the liquid phase, which represented up to 80-90% of total mass transfer resistance. The energy and environmental evaluation performed in this study revealed that PDMS DMs would enhance energy recovery and environmental feasibility of AnMBR technology for UWW treatment, especially when operating at low temperatures. When MRE was maximized, the combination of AnMBR with DM achieved net energy productions and net greenhouse gas reductions of up to 0.87 kWh and 0.216 kg CO2-eq per m3 of treated water.
Assuntos
Metano , Purificação da Água , Anaerobiose , Reatores Biológicos , Dimetilpolisiloxanos , Hidrodinâmica , Membranas Artificiais , Temperatura , Eliminação de Resíduos Líquidos , Águas Residuárias/análiseRESUMO
In recent decades, the wastewater treatment sector has undergone a shift to adapt to increasing discharge limits. In addressing the evaluation of innovative technologies, it is necessary to determine the scale at which reliable and representative values of environmental impacts and costs can be obtained, ensuring that the system under assessment follows the direction of eco-efficiency. This study has evaluated the environmental and economic indicators of an autotrophic nitrogen removal technology (ELAN®) from laboratory conception (1.5â¯L) to full scale (2 units of 115â¯m3) using the Life Cycle Assessment (LCA) methodology. Indirect emissions related to electricity consumption are the main contributor in all impact categories except eutrophication. Electricity consumption referred to the functional unit (1â¯m3 of treated wastewater) decreases as the scale increases. The rationale behind this can be explained, among other reasons, by the low energy efficiency of small-scale equipment (pumps and aerators). Accordingly, a value of approximately 25â¯kg CO2eq per m3 of treated water is determined for laboratory scale, compared to only 5â¯kg CO2eq per m3 at full-scale. When it comes to assessing the reliability of data, a pilot scale system of 0.2â¯m3 allowed to perform a trustworthy estimation of environmental indicators, which were validated at full-scale. In terms of operational costs, the scale of approximately 1â¯m3 provided a more accurate estimate of the costs associated with energy consumption.
Assuntos
Desnitrificação , Eliminação de Resíduos Líquidos , Águas Residuárias , Reatores Biológicos , Meio Ambiente , Nitrogênio , Reprodutibilidade dos TestesRESUMO
Microalgae culture in high rate algae ponds (HRAP) is an environmentally friendly technology for wastewater treatment. However, for the implementation of these systems, a better understanding of the oxygenation potential and the influence of climate conditions is required. In this work, the rates of oxygen production, consumption, and exchange with the atmosphere were calculated under varying conditions of solar irradiance and dilution rate during six months of operation in a real scale unit. This analysis allowed determining the biological response of these dynamic systems. The rates of oxygen consumption measured were considerably higher than the values calculated based on the organic loading rate. The response to light intensity in terms of oxygen production in the bioreactor was described with one of the models proposed for microalgae culture in dense concentrations. This model is based on the availability of light inside the culture and the specific response of microalgae to this parameter. The specific response to solar radiation intensity showed a reasonable stability in spite of the fluctuations due to meteorological conditions. The methodology developed is a useful tool for optimization and prediction of the performance of these systems.
Assuntos
Microalgas/metabolismo , Oxigênio/metabolismo , Fotossíntese , Lagoas/microbiologia , Biomassa , Reatores Biológicos , Luz , Eliminação de Resíduos Líquidos/métodosRESUMO
A semi-industrial scale AnMBR plant was operated for more than 600 days to evaluate the long-term operation of this technology at ambient temperature (ranging from 10 to 27 âC), variable hydraulic retention times (HRT) (from 25 to 41 h) and influent loads (mostly between 15 and 45 kg COD·d-1). The plant was fed with sulfate-rich high-loaded municipal wastewater from the pre-treatment of a full-scale WWTP. The results showed promising AnMBR performance as the core technology for wastewater treatment, obtaining an average 87.2 ± 6.1 % COD removal during long-term operation, with 40 % of the data over 90%. Five periods were considered to evaluate the effect of HRT, influent characteristics, COD/SO42--S ratio and temperature on the biological process. In the selected periods, methane yields varied from 70.2±36.0 to 169.0±95.1 STP L CH4·kg-1 CODinf, depending on the influent sulfate concentration, and wasting sludge production was reduced by between 8 % and 42 % compared to conventional activated sludge systems. The effluent exhibited a significant nutrient recovery potential. Temperature, HRT, SRT and influent COD/SO42--S ratio were corroborated as crucial parameters to consider in maximizing AnMBR performance.
Assuntos
Eliminação de Resíduos Líquidos , Purificação da Água , Reatores Biológicos , Esgotos , Temperatura , Eliminação de Resíduos Líquidos/métodosRESUMO
Microalgae cultures were used for a WW treatment to remediate nutrients while producing biomass and recycling water. In these trials, raceway ponds (RWPs; 1 and 0.5 ha) were located next to a municipal (WW) treatment plant in Mérida, Spain. The ponds were used for continuous, all-year-round microalgae production using WW as a source of nutrients. Neither CO2 nor air was supplied to cultures. The objective was to validate photosynthesis monitoring techniques in large-scale bioreactors. Various in-situ/ex-situ methods based on chlorophyll fluorescence and oxygen evolution measurements were used to follow culture performance. Photosynthesis variables gathered with these techniques were compared to the physiological behavior and growth of cultures. Good photosynthetic activity was indicated by the build-up of dissolved oxygen concentration up to 380% saturation, high photochemical yield (Fv/Fm = 0.62-0.71), and relative electron transport rate rETR between 200 and 450 µmol e- m-2 s-1 at midday, which resulted in biomass productivity of about 15-25 g DW m-2 day-1. The variables represent reliable markers reflecting the physiological status of microalgae cultures. Using waste nutrients, the biomass production cost can be significantly decreased for abundant biomass production in large-scale bioreactors, which can be exploited for agricultural purposes.
RESUMO
Feasibility of an AnMBR demonstration plant treating urban wastewater (UWW) at temperatures around 25-30 °C was assessed during a 350-day experimental period. The plant was fed with the effluent from the pre-treatment of a full-scale municipal WWTP, characterized by high COD and sulfate concentrations. Biodegradability of the UWW reached values up to 87%, although a portion of the biodegradable COD was consumed by sulfate reducing organisms. Effluent COD remained below effluent discharge limits, achieving COD removals above 90%. System operation resulted in a reduction of sludge production of 36-58% compared to theoretical aerobic sludge productions. The membranes were operated at gross transmembrane fluxes above 20 LMH maintaining low membrane fouling propensities for more than 250 days without chemical cleaning requirements. Thus, the system resulted in net positive energy productions and GHG emissions around zero. The results obtained confirm the feasibility of UWW treatment in AnMBR under mild and warm climates.
Assuntos
Eliminação de Resíduos Líquidos , Águas Residuárias/análise , Anaerobiose , Reatores Biológicos , Membranas Artificiais , MetanoRESUMO
Biogas production in wastewater treatment plants (WWTPs) plays a decisive role in the reduction of CO2 emissions and energy needs in the context of the water-energy nexus. The biogas obtained from sewage sludge digestion can be converted into biomethane by the use of biogas upgrading technologies. In this regard, an innovative water scrubbing based technology, known as ABAD Bioenergy® is presented and considered in this work. The effluents resulting from this system consist of biomethane and treated wastewater with a high CO2 concentration. Therefore, the study explores the feasibility of using this CO2-containing effluent in the cathode of a bioelectrochemical system (BES) for the transformation of CO2 into methane. Techno-economic assessment of the process is presented, including the valorisation of anode reactions through the production of chlorine compounds. Finally, the potential impacts of applying this technology in a WWTP operated by FCC Aqualia are (i) increasing biomethane production by 17.4%, (ii) decreasing CO2 content by 42.8% and (iii) producing over 60â¯ppm of chlorine compounds to disinfect all the treated wastewater of the plant.
RESUMO
The streams from municipal wastewater treatment plants (WWTP) have been considered a valuable medium for mass cultivation of algal biomass. The aim of this work is to test and compare the performance of Chlorella vulgaris on several streams from five stages, from two different WWTP. The results showed biomass yields ranging from 39 to 195mg dry-weightl(-1)days(-1). The best performance as biomass production was obtained with the centrate (effluent from drying the anaerobic sludge). After testing a wide range of N/P ratios with centrate, the highest productivity and growth rates were obtained with the original N/P ratio (2.0) of this stream. The highest removal rates were of 9.8 (N) and 3.0 (P) mgl(-1)days(-1), in the centrate. Finally, this research also suggests that microalgal production seems to be a promising process when coupled to wastewater treatment.