Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 4 de 4
Filtrar
Mais filtros

Base de dados
Tipo de documento
Intervalo de ano de publicação
1.
J Tissue Viability ; 24(3): 91-101, 2015 Aug.
Artigo em Inglês | MEDLINE | ID: mdl-26187897

RESUMO

Pressure ulcers are hazardous to people with diminished sensory and motor functions who remain in the same position for a long time. An important reason for the occurrence of pressure ulcers is the inability of wheelchair users to make postural changes by themselves with no appropriate method of pressure release. In this study, we researched the effects of applying an air cell inflate-deflate alternating sequence cushion prototype to relieve pressure from tissue loaded areas. Moreover, the hypothesis that the alternating sequence could stimulate blood reperfusion in loaded tissues and redistribute interface pressure on support area was also tested. Ten healthy volunteers were recruited to try the prototype cushion for 65 min of continuous loading; 5 min on static mode and 60 min on alternating mode. This study was conducted on healthy people because their sensitivity allowed them to state clearly and in detail, in a feedback questionnaire, any discomfort experienced with the use of our cushion. In order to address our hypothesis, interface pressure, and bilateral ischial oxygenated and deoxygenated hemoglobin were measured. After applying the alternating cushion, the interface pressure was redistributed over a larger contact area. Besides, blood perfusion was improved according to increments in oxygenated hemoglobin and decrements in deoxygenated hemoglobin of ischial regions during loaded condition. Feedback questionnaire showed that the participants did not feel pain or discomfort using the alternating cushion. The overall results showed positive effects on healthy tissue which has encouraged us to design a study involving subjects who use wheelchairs for mobility.


Assuntos
Ísquio/fisiologia , Oxigênio/metabolismo , Pressão , Adulto , Nádegas , Feminino , Humanos , Masculino , Úlcera por Pressão/prevenção & controle
2.
Med Eng Phys ; 38(8): 793-800, 2016 08.
Artigo em Inglês | MEDLINE | ID: mdl-27185034

RESUMO

The aim of this study is to assess the suitability of a micro-processing unit of motion analysis (MPUMA), for monitoring, reproducing, and tracking upper limb movements. The MPUMA is based on an inertial measurement unit, a 16-bit digital signal controller and a customized algorithm. To validate the performance of the system, simultaneous recordings of the angular trajectory were performed with a video-based motion analysis system. A test of the flexo-extension of the shoulder joint during the active elevation in a complete range of 120º of the upper limb was carried out in 10 healthy volunteers. Additional tests were carried out to assess MPUMA performance during upper limb tracking. The first, a 3D motion reconstruction of three movements of the shoulder joint (flexo-extension, abduction-adduction, horizontal internal-external rotation), and the second, an upper limb tracking online during the execution of three movements of the shoulder joint followed by a continuous random movement without any restrictions by using a virtual model and a mechatronic device of the shoulder joint. Experimental results demonstrated that the MPUMA measured joint angles that are close to those from a motion-capture system with orientation RMS errors less than 3º.


Assuntos
Monitorização Fisiológica/métodos , Movimento , Extremidade Superior/fisiologia , Algoritmos , Estudos de Viabilidade , Humanos , Amplitude de Movimento Articular
3.
Artigo em Inglês | MEDLINE | ID: mdl-25570740

RESUMO

The distribution and release of pressure on ischial regions are two important parameters for evaluating the effectiveness of a cushion; especially the release of pressure over time on ischial tuberosities, which is significant for preventing pressure ulcers. The aim of this work is to evaluate the effect on interface pressure through the application of a proposed alternating pressure sequence for an air-cell cushion. Six healthy volunteers were asked to sit on the air cell cushion, in static and alternating modes, as well as on a typical foam cushion for 12 minutes. Interface pressure was monitored with a matrix sensor system. Interface pressure values on ischial tuberosities, user contact area and pressure distribution were analyzed. Results showed that IP on IT tends to increase in both foam and static cushions, while in alternating cushion IP on IT tends to decrease. User contact area was significantly larger in alternating cushion than in static or foam cushions. Moreover, there is a better pressure re-distribution with alternating cushion than with the other cushions. The goal of the alternating sequence is to redistribute pressure and stimulate the ischial regions in order to promote blood flow and prevent pressure occurring in wheelchair users.


Assuntos
Úlcera por Pressão/prevenção & controle , Pressão , Adulto , Ar , Feminino , Humanos , Masculino , Ossos Pélvicos/fisiopatologia , Postura
4.
Artigo em Inglês | MEDLINE | ID: mdl-24110796

RESUMO

Pressure ulcers are skin injuries caused by long term exposition to high pressures on support points that interrupt blood circulation reducing the transport of oxygen and nutrients to the cells. They mainly affect people with poor mobility that stay in seating position for long periods of time. In spite of the diversity of commercial prototypes of cushions, ulcers caused by pressure are still a problem for wheelchair users. This work describes the design of a measurement system of pressure distribution in sedentary position. The aim of the system is to record the pressure concentration in order to obtain specific information about the supporting areas, and with these data used as feedback, eventually to determine an efficient random stimulation sequence to provide, in the future, a system to prevent these referred injuries. The proposed system consists of a 12 air-cell division cushion. Each cell has a pressure sensor and an input for electro valves to inflate and deflate. The recording and control of the valves is carried out through a graphical interface designed in LabVIEW®. A calibration procedure for the designed cushion was made by comparing the greatest load values pressure with a commercial platform, similar results were obtained.


Assuntos
Aparelhos Ortopédicos/efeitos adversos , Úlcera por Pressão/prevenção & controle , Cadeiras de Rodas/efeitos adversos , Calibragem , Desenho de Equipamento , Humanos , Úlcera por Pressão/etiologia
SELEÇÃO DE REFERÊNCIAS
Detalhe da pesquisa