Assuntos
Oxigênio/sangue , Síndrome do Desconforto Respiratório/diagnóstico , Adulto , Idoso , Idoso de 80 Anos ou mais , Biomarcadores/sangue , Feminino , Humanos , Masculino , Pessoa de Meia-Idade , Prognóstico , Reprodutibilidade dos Testes , Síndrome do Desconforto Respiratório/sangue , Síndrome do Desconforto Respiratório/mortalidade , Síndrome do Desconforto Respiratório/terapia , Estudos RetrospectivosRESUMO
An electrochemical immunosensor for the accurate detection of cat neutrophil gelatinase-associated lipocalin (NGAL) in urine samples based on an electrode with a monolayer of gold nanoparticles (AuNPs) was proposed in this study. To fabricate the sensing electrode, a nickel mold with concave micron hemisphere array was prepared and then used to transfer the micron hemispherical structure onto a polyethylene terephthalate (PET) film using the hot embossing technique. A gold thin film was sputtered onto the micron hemispherical structure array, after which 1,6-hexanedithol and AuNPs were uniformly deposited on the PET membrane to form a sensing electrode. The NGAL concentrations were measured by electrochemical impedance spectroscopy after attaching the anti-NGAL. Results revealed that the proposed sensing scheme exhibited a wide dynamic detection range from 1 to 100 ng/mL, which is far enough to distinguish the healthy (NGAL concentration <10 ng/mL) from the damaged kidney. A low limit of detection and high sensitivity of 0.47 ng/mL and 10261.8 Ω ng-1mL, respectively, were also measured. After performing real sample detection using urine samples from cats collected at a veterinary hospital, the results confirmed that the proposed NGAL detection approach in this research could accurately detect the concentration of NGAL in cat urine samples.
Assuntos
Técnicas Biossensoriais , Nanopartículas Metálicas , Técnicas Biossensoriais/métodos , Técnicas Eletroquímicas/métodos , Eletrodos , Ouro/química , Imunoensaio/métodos , Lipocalina-2 , Nanopartículas Metálicas/químicaRESUMO
This study aimed to develop simple electrochemical electrodes for the fast detection of chloride, sodium and potassium ions in human serum. A flat thin-film gold electrode was used as the detection electrode for chloride ions; a single-piece type membrane based solid-state ion-selective electrode (ISE), which was formed by covering a flat thin-film gold electrode with a mixture of 7,7,8,8-tetracyanoquinodimethane (TCNQ) and ion-selective membrane (ISM), was developed for sodium and potassium ions detection. Through cyclic voltammetry (CV) and square-wave voltammetry (SWV), the detection data can be obtained within two minutes. The linear detection ranges in the standard samples of chloride, sodium, and potassium ions were 25-200 mM, 50-200 mM, and 2-10 mM, with the average relative standard deviation (RSD) of 0.79%, 1.65%, and 0.47% and the average recovery rates of 101%, 100% and 96%, respectively. Interference experiments with Na+, K+, Cl-, Ca2+, and Mg2+ ions demonstrated that the proposed detection electrodes have good selectivity. Moreover, the proposed detection electrodes have characteristics such as the ability to be prepared under relatively simple process conditions, excellent detection sensitivity, and low RSD, and the detection linear range is suitable for the Cl-, Na+ and K+ concentrations in human serum.
Assuntos
Técnicas Eletroquímicas , Eletrólitos/análise , Eletrodos , Ouro , Humanos , Eletrodos Seletivos de Íons , Íons , PotássioRESUMO
BACKGROUND: Soft mist inhalers (SMIs) generate aerosols with a smaller particle size than pressurized metered-dose inhalers (pMDIs). However, the whole-span particle size distribution (PSD) of SMIs and the optimal delivery method of SMIs during mechanical ventilation have not been fully investigated. This study aimed to measure the PSD of the SMI alone and the SMI coupled to an inhalation aid (eg, a spacer, a valved holding chamber), as well as the delivery efficiency of SMI in different actuation timings and circuit positions during mechanical ventilation. As a suitable comparison, the pMDI was chosen for the same measurement. METHODS: SMIs (2.5 µg/actuation of tiotropium) were compared with pMDIs (100 µg/actuation of salbutamol). A microorifice uniform deposit impactor was utilized for the particle sizing of drug aerosols generated by inhalers alone, inhalers with a spacer, and inhalers with a valved holding chamber. To optimize the delivery efficiency of both inhalers during mechanical ventilation, the operating parameters included the circuit positions and actuation timings in the ventilator circuit. Particle sizes and inhaled doses were measured with an optical particle sizer and filters used to collect and quantify the drug, respectively. RESULTS: The SMI generated a smaller mass medium aerodynamic diameter (MMAD) than that from the pMDI. The extrafine-particle fraction (EFPF, < 1 µm) of the SMI was significantly higher than that of the pMDI. With the use of either inhalation aid, the MMAD of both inhalers decreased, and both inhalers with inhalation aid showed significant increases in EFPF. During mechanical ventilation, the optimum way to deliver the SMI and pMDI was at 15 cm from the Y-piece and actuated at the end of expiration and the onset of inspiration, respectively. CONCLUSIONS: The SMI with an inhalation aid showed marginal improvement on the PSD. The inhaler type, actuation timing, and position within the circuit also played important roles in delivery efficiency during mechanical ventilation.
Assuntos
Broncodilatadores , Respiração Artificial , Administração por Inalação , Aerossóis , Desenho de Equipamento , Humanos , Inaladores Dosimetrados , Nebulizadores e Vaporizadores , Tamanho da PartículaRESUMO
BACKGROUND: Aerosol delivery through mechanical ventilation is influenced by the type of aerosol generator, pattern of nebulization, and a patient's breathing pattern. This study compares the efficiency of pneumatic nebulization modes provided by a ventilator with adult and pediatric in vitro lung models. METHODS: Three pneumatic nebulization modes (inspiratory intermittent [IIM], continuous [CM], and expiratory intermittent [EIM]) provided by the Galileo Gold ventilator delivered medical aerosol to collection filters distal to an endotracheal tube with adult and pediatric test lungs. A unit dose of 5 mg/2.5 mL albuterol was diluted into 4 mL with distilled water and added to a jet nebulizer. The nebulizer was placed proximal to the ventilator, 15 cm from the inlet of the heated humidifier chamber with a T-piece and corrugated aerosol tubing and powered by gas from the ventilator in each of the 3 modes. Time for nebulization was recorded in minutes. Albuterol samples collected in the inhalation filter, nebulizer, T-piece, and corrugated tubing were eluted with distilled water and analyzed with a spectrophotometer. RESULTS: The inhaled drug, as a percentage of total dose in both lung models, was 5.1-7.5%, without statistical significance among the 3 modes. Median nebulization times for IIM, CM, and EIM were 38.9, 14.3, and 17.7 min, respectively, and nebulization time for the 3 modes significantly differed (P < .001). The inhaled drug mass for the 3 modes with the adult lung model was similar to that with the pediatric lung model (7.39 ± 0.76 vs. 6.27 ± 0.69%, P = .77). CONCLUSIONS: Aerosol drug delivery with a jet nebulizer placed proximal to the ventilator was not dependent on nebulization mode during simulated pediatric and adult conventional mechanical ventilation. Use of expiratory intermittent mode and continuous nebulization should be considered to reduce treatment time.