RESUMO
This study presents wind observations from an airborne Doppler Wind Lidar (ADWL) in 2016 tropical cyclones (TC). A description of ADWL measurement collection and quality control methods is introduced for the use in a TC environment. Validation against different instrumentation on-board the National Oceanographic and Atmospheric Administration's WP-3D aircraft shows good agreement of the retrieved ADWL measured wind speed and direction. Measurements taken from instruments such as the global positioning system dropsonde, flight-level wind probe, tail Doppler radar, and Stepped Frequency Microwave Radiometer are compared to ADWL observations by creating paired datasets. These paired observations represent independent measurements of the same observation space through a variety of mapping techniques that account for differences in measurement procedure. Despite high correlation values, outliers are identified and discussed in detail. The errors between paired observations appear to be caused by differences in the ability to capture various length scales, which directly relate to certain regions in a TC regime. In validating these datasets and providing evidence that shows the mitigation of gaps in 3-dimensional wind representation, the unique wind observations collected via ADWL have significant potential to impact numerical weather prediction of TCs.
RESUMO
This study investigates the atmospheric boundary layer structure based on multiple-level tower observations with a height of 350 m during the landfall of Super Typhoon Mangkhut (2018). Results show a layer of log wind profile outside of the radius of maximum wind speed with a height of 100 m or larger. The log layer height increases with the wind speed. The height of the constant flux layer reaches ~ 300 m for 10-m wind speeds less than 13 m s-1 while this height decreases with the wind speed. Momentum fluxes and turbulent kinetic energy increase with the wind speed at all vertical levels. The drag coefficient and surface roughness length estimated at the tower location have values of 7.3 × 10-3 and 0.09 m, respectively, which are independent of wind speed. The estimated vertical eddy diffusivity and mixing length increase with height up to ~ 160 m and then slowly decrease with height. The vertical eddy diffusivity increases with the wind speed while the vertical mixing length has no dependence on the wind speed. Comparing our results with previous work indicates that the vertical eddy diffusivity is larger over land than over ocean at a given wind speed range.
RESUMO
Helical rolls are known to play a significant role in modulating both the mean and turbulence structure of the atmospheric boundary layer in tropical cyclones. However, in-situ measurements of these rolls have been limited due to safety restrictions. This study presents analyses of data collected by an aircraft operated by the Hong Kong Observatory in Typhoon Kalmaegi (1415) and Typhoon Nida (1604). Examination of the flight-level data at ~ 600 m altitude confirmed the existence of sub-kilometer-scale rolls. These rolls were mostly observed in the outer-core region. Turbulent momentum fluxes were computed using the eddy correlation method. The averaged momentum flux of flight legs with rolls was found to be ~ 2.5 times that of legs without rolls at a similar wind speed range. This result suggests that rolls could significantly modulate turbulent transfer in the tropical cyclone boundary layer. This roll effect on turbulent fluxes should be considered in the planetary boundary layer parameterization schemes of numerical models simulating and forecasting tropical cyclones.
RESUMO
Spherulites are radial distributions of acicular crystals, common in biogenic, geologic, and synthetic systems, yet exactly how spherulitic crystals nucleate and grow is still poorly understood. To investigate these processes in more detail, we chose scleractinian corals as a model system, because they are well known to form their skeletons from aragonite (CaCO3) spherulites, and because a comparative study of crystal structures across coral species has not been performed previously. We observed that all 12 diverse coral species analyzed here exhibit plumose spherulites in their skeletons, with well-defined centers of calcification (CoCs), and crystalline fibers radiating from them. In 7 of the 12 species, we observed a skeletal structural motif not observed previously: randomly oriented, equant crystals, which we termed "sprinkles". In Acropora pharaonis, these sprinkles are localized at the CoCs, while in 6 other species, sprinkles are either layered at the growth front (GF) of the spherulites, or randomly distributed. At the nano- and micro-scale, coral skeletons fill space as much as single crystals of aragonite. Based on these observations, we tentatively propose a spherulite formation mechanism in which growth front nucleation (GFN) of randomly oriented sprinkles, competition for space, and coarsening produce spherulites, rather than the previously assumed slightly misoriented nucleations termed "non-crystallographic branching". Phase-field simulations support this mechanism, and, using a minimal set of thermodynamic parameters, are able to reproduce all of the microstructural variation observed experimentally in all of the investigated coral skeletons. Beyond coral skeletons, other spherulitic systems, from aspirin to semicrystalline polymers and chocolate, may also form according to the mechanism for spherulite formation proposed here. STATEMENT OF SIGNIFICANCE: Understanding the fundamental mechanisms of spherulite nucleation and growth has broad ranging applications in the fields of metallurgy, polymers, food science, and pharmaceutical production. Using the skeletons of reef-building corals as a model system for investigating these processes, we propose a new spherulite growth mechanism that can not only explain the micro-structural diversity observed in distantly related coral species, but may point to a universal growth mechanism in a wide range of biologically and technologically relevant spherulitic materials systems.