Risk factors for postoperative pain in the first three weeks after arthroscopic or open shoulder surgery.

INTRODUCTION: Shoulder surgery is a painful procedure. Adequate postoperative pain control increases patient satisfaction. The objectives of this study were to investigate postoperative pain development in shoulder surgery and to assess risk factors for high postoperative pain. HYPOTHESIS: Patients who undergo rotator cuff repair are more painful than patients who undergo different kinds of shoulder surgery. MATERIAL AND METHODS: Four hundred and sixty five patients who underwent shoulder surgery were included in this retrospective cohort study. A linear mixed model analysis was used to compare NRS (Numeric Rating Scale) for pain between different kinds of shoulder surgery in the first three weeks postoperatively. To assess risk factors for high postoperative pain odds ratios were calculated. RESULTS: Pain development in the first 3 weeks differed between procedures with rotator cuff repair being the most painful procedure. Risk factors for high postoperative pain were female sex and subacromial decompression with distal clavicle resection. DISCUSSION: Patients who undergo rotator cuff repair are indeed more painful than patients who undergo different kinds of shoulder surgery. With identifying these differences in pain development and the risk factors for high postoperative pain after shoulder surgery, we can optimize postoperative pain treatment. However, further research is needed to support these results. LEVEL OF EVIDENCE: IV, retrospective cohort study.

Comparison of anatomic vs. straight femoral stem design in total hip replacement - femoral canal fill in vivo.

INTRODUCTION: The femoral canal fill between an anatomic and a straight prosthesis design in cementless total hip arthroplasty (THA) was compared. We hypothesised that the anatomic SPS stem has higher proximal fill and lesser distal fill than the straight stem. MATERIAL AND METHODS: The femoral canal fill was measured on 3 months routine postoperative x-rays at 5 levels of the stem in 50 consecutive patients, aged 35-83 years, who underwent 56 THA procedures by a single surgeon in this hospital. 22 patients received a straight design Ceramconcept Global stem, 34 patients received an anatomic design Symbios SPS stem. Both anteroposterior (AP) and lateral x-rays were combined to suggest a 3-D measurement. RESULTS: On the AP x-rays, the canal fill was significantly higher using the anatomic design stem at the proximal measurement levels, and was significantly higher at the distal levels using the straight stem. With the AP and lateral x-rays combined, the canal fill at the proximal levels was also significantly higher in the anatomic groups, nonsignificantly lower at the central level and significantly lower at the distal levels. DISCUSSION: In THA surgery, achieving high fill at the metaphysis of the femur and less fill at the diaphysis has been suggested to result in satisfactory outcome and high stability of the prosthesis. This study demonstrated that, compared to straight stem design, an anatomically designed stem has a significantly higher metaphyseal femoral canal fill.

Ultrasound guided Needling vs Radial Shockwave Therapy in calcific tendinitis of the shoulder: A prospective randomized trial.

PURPOSE: Ultrasound Needling(UN) and Radial Shockwave(RSWT) aim to dissolve deposits in Shoulder Calcific tendinitis. METHODS: RCT in 25 patients to compare short term effectiveness. Outcome measures were pain and functional outcome at 6 weeks and 1 year and decrease of deposits after 6 weeks. RESULTS: UN decreased deposit more than RSWT(P = 0.029). After 6 weeks, Constant, NRS and Oxford improved more in UN. After 1 year, there was no significant difference in NRS(p = 0.45) or Oxford(p = 0.32). CONCLUSION: Compared to RSWT, UN resulted in lower pain and faster resorption of calcifications after 6 weeks. No significant differences were found after 1 year.