First Report of White Mold Caused by Sclerotinia sclerotiorum on Hymenocallis glauca in Mexico.

In Mexico, there are 29 native species of the genus Hymenocallis, where H. glauca is one of the most cultivated bulbous plants. It holds economic importance as it is commercialized as a potted plant and cut flower (Leszczyñska and Borys, 2001). In October 2023, field sampling was conducted in the Research Center in Horticulture and Native Plants (18°55'55" N, 98°24'02.8"W) of UPAEP University. H. glauca diseased plants were found in an area of 0.4 ha, with an incidence of 35% and an estimated severity of 45% on infected plants in vegetative stage. The symptoms included chlorosis of foliage, necrosis at the base of the stem, and soft rot with abundant white to gray mycelium and abundant production of black, irregular sclerotia of approximately 3.5 mm diameter. Finally, the plants wilted and died. The fungus was isolated from 40 symptomatic plants. Sclerotia were collected, disinfested with 3% NaOCl for one minute, rinsed with sterile distilled water (SDW), and plated on Petri dishes containing potato dextrose agar (PDA) with sterile forceps. Subsequently, a sterile dissecting needle was used to place fragments of mycelium directly on Petri dishes with PDA. Plates were incubated at 23 °C in dark for 7 days. One isolate was obtained from each diseased plant by the hyphal-tip method (20 isolates from sclerotia and 20 from mycelium). After 7 days, colonies had fast-growing, dense, and cottony-white aerial mycelium forming irregular sclerotia of 3.57 ± 0.59 mm (mean ± standard deviation, n=100). In each Petri dish there were produced 21.5 ± 7.9 sclerotia (mean ± standard deviation, n=40), after 11 days; these were initially white and gradually turned black. The isolates were tentatively identified as Sclerotinia sclerotiorum based on morphological characteristics (Saharan and Mehta 2008). Two representative isolates were chosen for molecular identification and genomic DNA was extracted by the CTAB protocol. The ITS region and the glyceraldehyde 3-phosphate dehydrogenase (G3PDH) gene were amplified and sequenced (Staats et al. 2005; White et al. 1990). The sequences of a representative isolate (SsHg3) were deposited in GenBank (ITS- PP094578; G3PDH- PP101843). BLAST analysis of the partial sequences ITS (519 bp), and G3PDH (950 bp) showed 100% similarity to S. sclerotiorum isolates (GenBank: MG249967, MW082601). Pathogenicity was confirmed by inoculating 30 H. glauca plants in vegetative stage grown in pots with sterile soil. Ten sclerotia were deposited at the base of the stem, 10 mm below the soil surface. As control treatment, SDW was applied to 10 plants. The plants were placed in a greenhouse at 23 °C and 90% relative humidity. After 17 days, all inoculated plants displayed symptoms similar to those observed in the field, while no symptoms were observed on the controls. The fungus was re-isolated from the inoculated plants as described above, fulfilling Koch's postulates. The pathogenicity tests were repeated three times. S. sclerotiorum has been reported causing white mold on other bulbous plants, like fennel (Foeniculum vulgare) in Korea (Choi et al. 2015). To our knowledge, this is the first report of S. sclerotiorum causing white mold on H. glauca in Mexico. Information about diseases affecting this plant is very limited, so this research is essential for developing integrated management strategies and preventing spread to other production areas.

First Report of White Mold Caused by Sclerotinia sclerotiorum on Echeveria gigantea in Mexico.

Echeveria gigantea, native of Mexico (Reyes et al. 2011), holds economic importance as it is marketed as a potted plant and cut flower due to its drought-tolerant capabilities and aesthetic appeal. In September 2023, a field sampling was conducted at the Research Center in Horticulture and Native Plants (18°55'56.6" N, 98°24'01.5" W) of UPAEP University. Echeveria gigantea cv. Quilpalli plants with white mold symptoms were found in an area of 0.5 ha, with an incidence of 40% and severity of 50% on severely affected stems. The symptoms included chlorosis of older foliage, necrosis at the base of the stem, and soft rot with abundant white to gray mycelium and abundant production of irregular sclerotia resulting in wilted plants. The fungus was isolated from 30 symptomatic plants. Sclerotia were collected, sterilized in 3% NaOCl, rinsed with sterile distilled water (SDW), and plated on Potato Dextrose Agar (PDA) with sterile forceps. Subsequently, a dissecting needle was used to place fragments of mycelium directly on PDA. Plates were incubated at 23 °C in darkness. A total of 30 isolates were obtained using the hyphal-tip method, one from each diseased plant (15 isolates from sclerotia and 15 from mycelium). After 6 days, colonies had fast-growing, dense, cottony-white aerial mycelium forming irregular sclerotia of 3.67 ± 1.13 mm (n=100). Each Petri dish produced 32.47 ± 7.5 sclerotia (n=30), after 12 days. The sclerotia were initially white and gradually turned black. The isolates were tentatively identified as Sclerotinia sclerotiorum based on morphological characteristics (Saharan and Mehta 2008). Two isolates were selected for molecular identification. Genomic DNA was extracted using the CTAB protocol. The ITS region and the glyceraldehyde 3-phosphate dehydrogenase (G3PDH) gene were sequenced for two randomly selected isolates (White et al. 1990; Staats et al. 2005). The ITS and G3PDH sequences of the SsEg9 isolate were deposited in GenBank (ITS-OR816006; G3PDH-OR879212). BLAST analysis of the partial ITS (510 bp) and G3PDH (915 bp) sequences showed 100% and 99.78% similarity to S. sclerotiorum isolates (GenBank: MT101751 and MW082601). Pathogenicity was confirmed by inoculating 30 120-day-old E. gigantea cv. Quilpalli plants grown in pots with sterile soil. Ten sclerotia were deposited at the base of the stem, 10 mm below the soil surface. As control treatment, SDW was applied to 10 plants. The plants were placed in a greenhouse at 23 °C and 90% relative humidity. After 16 days, all inoculated plants displayed symptoms similar to those observed in the field. Control plants did not display any symptoms. The fungus was reisolated from the inoculated stems, fulfilling Koch's postulates. The pathogenicity tests were repeated three times. Recently S. sclerotiorum has been reported causing white mold on cabbage in the state of Puebla, Mexico (Terrones-Salgado et al. 2023). To the best of our knowledge, this is the first report of S. sclerotiorum causing white mold on E. gigantea in Mexico. Information about diseases affecting this plant is very limited, so this research is crucial for designing integrated management strategies and preventing spread to other production areas.

First Report of Gray Mold Caused by Botrytis cinerea on Dragon Fruit (Hylocereus undatus) in Mexico.

The dragon fruit is native of Mexico, and Puebla is the third-largest producing state (SIAP 2023). In June 2023, field sampling was conducted in El Paraíso, Atlixco (18° 49' 5.275" N, 98° 26' 52.353" W), Puebla, Mexico. The mean temperature and relative humidity were 20 °C and 75% for seven consecutive days. Dragon fruits cv. 'Delight' close to harvest with gray mold symptoms were found in a commercial area of 2 ha, with an incidence of 35 to 40% and an estimated severity of 75% on infected fruit. The symptoms included necrosis at the apex, which later spread throughout the fruit, along with a soft, black rot covered in abundant mycelium and sporulation. The fungus was isolated from 40 symptomatic fruits by disinfesting pieces of necrotic tissue with 3% NaClO for one minute, rinsing with sterile distilled water (SDW), plating on Petri dishes with potato dextrose agar, and incubating at 25 °C in the dark. One isolate was obtained from each diseased fruit by the hyphal-tip method. The colonies were initially white with a growth rate of 1.15-1.32 cm per day and turned gray after 10 days; the mycelium was dense and aerial. Spherical and irregular sclerotia were formed, measuring 0.9-1.4 × 0.6-1.1 mm (n = 100). Each Petri dish produced 56-278 sclerotia (n = 40) after 11 days; these were initially white and gradually turned dark brown. Brown to olive conidiophores were straight, septate, and branched, measuring 1075-1520 × 10-21 µm, with elliptical hyaline to light brown conidia of 6.6-11.5 × 5-8.1 µm (n=100). The isolates were tentatively identified as Botrytis cinerea based on morphological characteristics (Ellis 1971). Two representative isolates were chosen for molecular identification and genomic DNA was extracted by the CTAB protocol. The ITS region and the heat shock protein (HSP60), RNA polymerase binding II (RPB2) and glyceraldehyde 3-phosphate dehydrogenase (G3PDH) genes were sequenced (White et al. 1990; Staats et al. 2005). The sequences of a representative isolate (BcPh5) were deposited in GenBank (ITS-OR582337; HSP60-OR636622; RPB2-OR636623; and G3PDH-OR636621). BLAST analysis of the partial sequences of ITS (479 bp), HSP60 (1006 bp), RPB2 (1126 bp), and G3PDH (907 bp) showed 100% similarity to B. cinerea isolates (GenBank: KM840848, MH796663, MK919495, MF480679). Phylogenetic analysis confirmed that BcPh5 clustered with B. cinerea strains. Pathogenicity was confirmed by inoculating the non-wounded surface of 20 detached dragon fruits cv. 'Delight' using the BcPh5 isolate by depositing 20 µl of a 105 conidia/ml suspension with a sterile syringe. The fruits were placed on the rim of a plastic container and inserted in a moisture box with 2 cm of water at the bottom. The box was covered with a plastic sheet to maintain humidity. Control fruits were inoculated with SDW. The inoculated fruits became covered with abundant white to gray mycelium, and soft rot developed within eight days, while no symptoms were observed on the controls. The fungus was re-isolated from the inoculated fruits as described above, fulfilling Koch's postulates. The pathogenicity tests were repeated three times. Gray mold caused by B. cinerea was also recently reported in Mexico on pomegranate (Hernández et al. 2023) and rose apple (Isodoro et al. 2023). As far as we know, this is the first report of B. cinerea causing gray mold on dragon fruit in Mexico. This research is essential for designing integrated management strategies against gray mold on dragon fruits.