A solvent-free HPLC method for the simultaneous determination of Favipiravir and its hydrolytic degradation product.

During COVID-19 pandemic, Favipiravir (FPV) showed a great efficacy against COVID-19 virus, it produced noticeable improvements in recovery of the patients. The aim of this study was to develop a new, green and simple method for the simultaneous determination of FPV and its acid-induced degradation product (ADP) in its pure and pharmaceutical dosage forms. This method will be key for the inevitable development of FPV solution and inhaler formulations. A green micellar RP-HPLC method was developed using an RP-VDSPHERE PUR 100 column (5 µm, 250 × 4.6 mm) and an isocratic mixed micellar mobile phase composed of 0.02 M Brij-35, 0.1 M SDS and 0.01 M potassium dihydrogen orthophosphate anhydrous and adjusted to pH 3.0 with 1.0 mL min-1 flow rate. The detection was performed at 280 nm with a run time of less than six min. Under the optimized chromatographic conditions, linear relationship has been established between peak area and concentration of FPV and its ADP in the range of 5-100 and 10-100 µg mL-1 with elution time of 3.8 and 5.7 min, respectively. The developed method was validated according to the ICH guidelines and applied successfully for determination of FPV in its pharmaceutical dosage form.

Spectrophotometric determination of favipiravir in presence of its acid hydrolysis product.

Favipiravir (FAV) has been approved as an antiviral drug used in pandemic corona virus to treat covid-19. It has an amide moiety susceptible to hydrolysis and degradation in acid medium. Therefore, four simple, sensitive, and accurate stability indicating spectrophotometric methods have been developed for the determination of FAV in presence of its acid induced degradation product. The first method describes direct determination of FAV at 323 nm. Dual wavelength method was the second developed one for FAV quantitation by recording the absorbance difference at 322.7 and 270 nm. The third method involves using first derivative peak to peak amplitude at 338.0 and 308.0 nm, while difference spectrophotometry was the fourth suggested method, and it was based on recording the spectral changes at 361.3 nm as pH changes. The obtained calibration curves were linear over 4.0-22.0 µg/mL. Accuracy of the suggested procedures ranged from 99.11 to100.06, while precision results were from 0.80 to1.68. The developed methods were used to determine FAV in pure powdered form, laboratory-prepared mixtures with their degradation product, and pharmaceutical formulation without interference from its acidic degradation product.The greenness was assessed based on GAPI and ACREE metric and was found to be compatible and in reconciliation with green analytical chemistry concepts.