On the effects of quadrupolar relaxation in Earth's field NMR spectra.

There is growing interest in using low-field magnetic resonance experiments for routine chemical characterization. Earth's field NMR is one such technique that can garner structural information and enable sample differentiation with low cost and highly portable designs. The resulting NMR spectra are primarily influenced by J-couplings, resulting in so-called J-coupled spectra (JCS). Many small molecules include atoms with NMR-active nuclei that are quadrupolar either at natural abundance or are often isotopically enriched (e.g.,2H, 6Li, 11B, 14N, 17O, etc.) where the effects of quadrupolar J-couplings and relaxation on JCS of strongly- and weakly-coupled spin systems have not been explored to date. Herein, using a set of seven fluoropyridine samples with unique substitution and J-couplings, we demonstrate that the 14N relaxation rates can induce drastic line-broadening in the JCS. This includes a previously unexplored unique line broadening mechanism enabled by strongly coupled spins at low-field. Numerical simulations are used to model and refine the magnitudes and signs of J-couplings, as well as indirectly determine the 14N relaxation rates in a single 1D experiment that has a higher fidelity than observed in high-field NMR experiments.

Correction of Q Factor Effects for Simultaneous Collection of Elemental Analysis and Relaxation Times by Nuclear Magnetic Resonance.

A new method for measurement of elemental analysis by nuclear magnetic resonance (NMR) of unknown samples is discussed here as a quick and robust means to measure elemental ratios without the use of internal or external calibration standards. The determination of elemental ratios was done by normalizing the signal intensities by the frequency dependent quality factor (Q) and the gyromagnetic ratios (γ) for each measured nucleus. The correction for the frequency dependence was found by characterizing the output signal of the probe as a function of the quality factor (Q) and the frequency, and the correction for γ was discussed in a previous study. A Carr-Purcell-Meiboom-Gill (CPMG) pulse sequence was used for evaluation of the relative signal intensities, which allows for derivation of elemental ratios, and was correspondingly used to simultaneously measure the T2* of samples for an added parameter for more accurate identification of unknown samples.

Synthesis of isotopically labeled 1,3-dithiane.

The 1,3-dithiane is a protected formaldehyde anion equivalent that could serve as a useful labeled synthon. We report a facile synthesis of 1,3-[2-(13)C]- and 1,3-[2-(13)C, 2-(2)H2]dithiane in two steps from [(13)C]- or [(13) C, (2)H3 ]methyl phenyl sulfoxide. We have previously reported the high yield synthesis of [(13)C]methyl phenyl sulfide from [(13)C]MEOH and the oxidation of [(13)C]methyl phenyl sulfide to [(13)C]methyl phenyl sulfoxide. Here, we describe the facile exchange of deuterium from (2) H2 O into [(13)C]methyl phenyl sulfoxide to yield [(13)C, (2)H3]methyl phenyl sulfoxide. Thus, from [(13)C]MEOH and (2)H2O, all possible C2 stable isotopomers of 1,3-dithiane are available. Our synthetic route is also amenable to preparation of radiolabeled 1,3-dithianes.

Large-scale preparation of (13) C-labeled 2-(phenylthio)acetic acid and the corresponding labeled sulfoxides and sulfones.

We have developed large-scale efficient procedures for the conversion of commercially available [(13) C]- or [(2) H3 ,(13) C]methanol and (13) CO2 or (13) C-labeled bromoacetic acid to 2-(phenylthio)[1,2-(13) C2 ]-, [1-(13) C]-, and [2-(13) C]acetic acid. The resulting derivatives are versatile, chemically stable, and nonvolatile two-carbon labeling precursors. We have used the (13) C-isotopomers of 2-(phenylthio)acetic acid in the synthesis of (13) C-labeled acrylic acid, methacrylic acid, and trans-crotonic acid.