Implementing magnetically-active Sn-based nanocomposites in hexavalent chromium removal from drinking water.

A novel nanocomposite consisting of Fe3O4-loaded tin oxyhydroxy-chloride is demonstrated as an efficient adsorbent for the removal of hexavalent chromium in compliance to the new drinking water regulation. This study introduces a continuous-flow production of the nanocomposite through the separate synthesis of (i) 40 nm Fe3O4 nanoparticles and (ii) multilayered spherical arrangements of a tin hydroxy-chloride identified as abhurite, before the application of a wet-blending process. The homogeneous distribution of Fe3O4 nanoparticles on the abhurite's morphology, features nanocomposite with magnetic response whereas the 10 % loaded nanocomposite preserves a Cr(VI) uptake capacity of 7.2 mg/g for residual concentrations below 25 µg/L. Kinetic and thermodynamic examination of the uptake evolution indicates a relative rapid Cr(VI) capture dominated by interparticle diffusion and a spontaneous endothermic process mediated by reduction to Cr(III). The efficiency of the optimized nanocomposite was validated in a pilot unit operating in a sequence of a stirring reactor and a rotary magnetic separator showing an alternative and competitive application path than typical fixed-bed filtration, which is supported by the absence of any acute cellular toxicity according to human kidney cell viability tests.

Tin Oxide Nanoparticles via Solar Vapor Deposition for Hexavalent Chromium Remediation.

Tin oxide nanoparticles optimized to capture low concentrations of hexavalent chromium from water were developed through a facile, scalable, and low-cost one-step solar vapor deposition methodology. Considering the preservation of high electron donation capacity as the key to support the reduction of mobile Cr(VI) into insoluble forms, the growth of SnO nanoparticles was favored by the co-evaporation of SnO2 with Fe powders at various mass ratios. Characterization techniques indicated that the percentage and the stability of SnO is proportional to the Fe content in the target with a requirement of at least 50% wt to inhibit the formation of a passive SnO2 surface layer. The produced particles were evaluated regarding their efficiency to capture Cr(VI) under conditions similar to water treatment for drinking purposes (pH 7). It was revealed that passivation-free SnO nanoparticles deliver significant improvement in the adsorption capacity corresponding to the residual concentration of 25 µg/L, reaching a value of 1.74 mg/g for the sample prepared with 50% wt Fe in the target. The increase of water acidity was found responsible for the activation of more reduction sites on the particle surface, as reflected through the elevation of efficiency by more than 20% at pH 6.