RESUMO
Microcellular injection moulding is an important injection moulding technique to create foaming plastic parts. However, there are no consistent conclusions on the impact of processing parameters on the cell morphology of microcellular injection moulded parts. This paper investigates the influence of the main processing parameters, such as melt temperature, mould temperature, injection pressure, flow rate, shot volume and gas dosage amount, on the average cell size and weight reduction of a talc-reinforced polypropylene square part (165 mm × 165 mm × 3.2 mm), using the commercial software Moldex 3D. The effect of each parameter is investigated considering a range of values and the simulation results were compared with published experimental results. The differences between numerical and experimental trends are discussed.
RESUMO
Microcellular injection moulding (MuCell®) is a polymer processing technology that uses a supercritical fluid inert gas, CO2 or N2, to produce light-weight products. Due to environmental pressures and the requirement of light-weight parts with good mechanical properties, this technology recently gained significant attention. However, poor surface appearance and limited mechanical properties still prevent the wide applications of this technique. This paper reviews the microcellular injection moulding process, main characteristics of the process, bubble nucleation and growth, and major recent developments in the field. Strategies to improve both the surface quality and mechanical properties are discussed in detail as well as the relationships between processing parameters, morphology, and surface and mechanical properties. Modelling approaches to simulate microcellular injection moulding and the mathematical models behind Moldex 3D and Moldflow, the two most commonly used software tools by industry and academia, are reviewed, and the main limitations are highlighted. Finally, future research perspectives to further develop this technology are also discussed.