Changes in color and contrast ratio of resin composites after curing and storage in water.

PURPOSE: To verify the color change and contrast ratio of resin composites after curing and after 30 days of storage in water. METHODS: Dentin A2 shades of different light-cured dental resin composites (Vittra APS, FGM, Brazil; Z350 XT, 3M ESPE, EUA; Tetric N-Ceram, Ivoclar Vivadent, Liechtenstein, and Charisma Diamond, Heraeus Kulzer, Germany) were tested. Ten rounded specimens (8 mm × 2 mm) were prepared for each material. Reflectance for all samples was obtained using a spectrophotometer (Minolta CM 3700d, Konica Minolta, Japan) before curing, immediately after curing, and after 30 days of storage in water. The color change (ΔE*lab) and contrast ratio (CR) data were analyzed using a one-way analysis of variance with Tukey's and paired t-tests (α = 1%). RESULTS: For all materials tested, significant color changes were noticeable after curing and after 30 days in water (p < 0.01). Significant changes in the CR values before curing, after curing, and 30 days of storage in water were observed in the resin composites investigated (p < 0.01) except for Z350 (p > 0.01). CONCLUSION: The CR values and color changes after curing and 30 days of storage in water varied depending on the material tested. This study corroborates the clinical practice of curing a small amount of unpolymerized resin composite on the tooth surface to select the desired shade before undertaking esthetic restorative procedures.

Post-cure heat treatments influence on mechanical and optical properties of resin composites.

This study evaluated the effect of post-cure heat treatment (PCHT) on the Knoop microhardness (KHN), degree of conversion (DC), color changes, and contrast ratio (CR) of four resin composites (RCs): Z100 (3M ESPE), Z350 XT (3M ESPE), Estelite Omega (Tokuyama) and Empress Direct (Ivoclar Vivadent). Specimens (12 × 1 mm) were prepared for each material (n = 10 / group). After curing, samples were subjected to PCHT for 10 min at 100°C or 170°C. Control group was maintained at room temperature (24°C) for the same time. The DC was analyzed by FT-NIR immediately and 24 h after the PCHT (n = 3 / group). KHN was analyzed 24 h after PCHT (n = 10 / group). According to CIEDE2000 (∆E00), color measurements were obtained immediately after curing, five minutes after PCHT, and after seven days of storage in water, coffee, and red wine. Data were analyzed by One and Two-Way ANOVA (p < 0.05). Z100, Z350, and Estelite Omega showed increases in KHN with increased temperature (p < 0.05). PCHT at 100°C and 170°C led to a higher DC of all RCs (p < 0.05). Initially, the PCHT lead to increased ∆E00 values (p < 0.05), which was decreased after immersion in coffee and wine (p < 0.05). Considering the effect of PCHT and staining solutions, lower color changes were observed in the thermally treated specimens (p < 0.05). Taken collectively, the results suggest the PCHT as an economical and practical alternative to enhance direct RC's properties in direct-indirect and indirect restorations.

Post-cure heat treatments influence on mechanical and optical properties of resin composites

Abstract This study evaluated the effect of post-cure heat treatment (PCHT) on the Knoop microhardness (KHN), degree of conversion (DC), color changes, and contrast ratio (CR) of four resin composites (RCs): Z100 (3M ESPE), Z350 XT (3M ESPE), Estelite Omega (Tokuyama) and Empress Direct (Ivoclar Vivadent). Specimens (12 × 1 mm) were prepared for each material (n = 10 / group). After curing, samples were subjected to PCHT for 10 min at 100°C or 170°C. Control group was maintained at room temperature (24°C) for the same time. The DC was analyzed by FT-NIR immediately and 24 h after the PCHT (n = 3 / group). KHN was analyzed 24 h after PCHT (n = 10 / group). According to CIEDE2000 (∆E00), color measurements were obtained immediately after curing, five minutes after PCHT, and after seven days of storage in water, coffee, and red wine. Data were analyzed by One and Two-Way ANOVA (p < 0.05). Z100, Z350, and Estelite Omega showed increases in KHN with increased temperature (p < 0.05). PCHT at 100°C and 170°C led to a higher DC of all RCs (p < 0.05). Initially, the PCHT lead to increased ∆E00 values (p < 0.05), which was decreased after immersion in coffee and wine (p < 0.05). Considering the effect of PCHT and staining solutions, lower color changes were observed in the thermally treated specimens (p < 0.05). Taken collectively, the results suggest the PCHT as an economical and practical alternative to enhance direct RC's properties in direct-indirect and indirect restorations.

Resumo Este estudo avaliou o efeito do tratamento térmico pós-cura (PCHT) na microdureza Knoop (KHN), grau de conversão (DC), mudanças de cor e razão de contraste (CR) de quatro compósitos resinosos (RCs): Z100 (3M ESPE ), Z350 XT (3M ESPE), Estelite Omega (Tokuyama) e Empress Direct (Ivoclar Vivadent). Corpos de prova (12 × 1 mm) foram preparadas para cada material (n = 10 / grupo). Após a cura, as amostras foram submetidas ao PCHT por 10 min a 100 ou 170° C. O grupo controle foi mantido à temperatura ambiente (24° C) pelo mesmo tempo. O DC foi analisada por FT-NIR imediatamente e 24 h após a PCHT (n = 3 / grupo). KHN foi analisado 24 h após PCHT (n = 10 / grupo). De acordo com o CIEDE2000 (∆E00), as medidas de cor foram obtidas imediatamente após a cura, cinco minutos após a PCHT e após sete dias de armazenamento em água, café e vinho tinto. Os dados foram analisados por ANOVA de um e dois fatores (P < 0,05). Z100, Z350 XT e Estelite Omega mostraram aumentos no KHN com o aumento da temperatura (P < 0,05). PCHT a 100 ° C e 170 ° C levou a uma maior DC de todos os RCs (P < 0,05). Inicialmente, o PCHT levou ao aumento dos valores de ∆E00 (P < 0,05), que diminuiu após a imersão em café e vinho (P < 0,05). Considerando o efeito de PCHT e soluções de coloração, menores mudanças de cor foram observadas nas amostras tratadas termicamente (P < 0,05). Os resultados sugerem o PCHT como uma alternativa econômica e prática para aumentar as propriedades diretas de compósitos resinosos em restaurações diretas-indiretas e indiretas.

Atypical lesion on soft palate: a curious case / Lesión atípica en el paladar blando: relato de caso

The aim of this work is to present a case of a 39-years-old man with a 2cm sized purple pedunculated tissue on the soft palate, next to upper right retromolar area, asymptomatic, with one day time evolution and vascular appearance. There was no trauma history or systemic diseases. Based on the clinical findings our previous diagnosis was traumatic granuloma, hemangioma or blood coagulum formation after local trauma. After one week, intraoral examination revealed absence of the lesion, which disappeared completely. This case illustrates that the absence of trauma history and atypical clinical characteristics can be a diagnostic defiance in the clinical routine.

El objetivo de este trabajo es presentar un caso de un hombre de 39 años de edad, con un tejido de 2 cm pediculado color púrpura en el paladar blando, junto al área retromolar superior derecha, asintomático, con un día de evolución y de aspecto vascular. No había historia de trauma o enfermedades sistémicas. Con base en los hallazgos clínicos nuestro diagnóstico previo fue granuloma traumático, hemangioma o la formación de coágulos sanguíneos, después de un traumatismo local. Luego de una semana, el examen intraoral reveló ausencia de la lesión, la que desapareció por completo. Este caso ilustra que la ausencia de historia de trauma y las características clínicas atípicas, puede ser un desafío diagnóstico en la rutina clínica.

Dental manifestations in bariatric patients: review of literature.

The rate of bariatric surgery has significantly risen in the past decade as an increasing prevalence of extreme obesity can be observed. Although bariatric surgery is an effective therapeutic modality for extreme obesity, it is associated with risk factors affecting also oral health. Based on an overview of the current literature, this paper presents a summary of dental manifestations in bariatric patients. Bariatric surgeries are associated with an increased risk for gastro-esophageal reflux which in turn might account for the higher amount of carious and erosive lesions observed in bariatric patients. As a result, also dentin hypersensitivity might be observed more frequently. The current data indicate that recommended postsurgical meal patterns and gastric reflux might increase the risk for dental lesions, particularly in the presence of other risk factors, such as consumption of sweet-tasting foods and acidic beverages. Further research is needed to evaluate the correlation of bariatric surgery and the development of dental diseases.

Dental manifestations in bariatric patients: review of literature

The rate of bariatric surgery has significantly risen in the past decade as an increasing prevalence of extreme obesity can be observed. Although bariatric surgery is an effective therapeutic modality for extreme obesity, it is associated with risk factors affecting also oral health. Based on an overview of the current literature, this paper presents a summary of dental manifestations in bariatric patients. Bariatric surgeries are associated with an increased risk for gastro-esophageal reflux which in turn might account for the higher amount of carious and erosive lesions observed in bariatric patients. As a result, also dentin hypersensitivity might be observed more frequently. The current data indicate that recommended postsurgical meal patterns and gastric reflux might increase the risk for dental lesions, particularly in the presence of other risk factors, such as consumption of sweet-tasting foods and acidic beverages. Further research is needed to evaluate the correlation of bariatric surgery and the development of dental diseases.