The effect of primer cap material on ballistic toolmark evidence.

There has recently been an increase in the research and implementation of advanced measurement techniques to ballistic toolmark identification. This has led to a shift from greyscale imaging to the acquisition of dense areal datasets. With the addition of mathematical correlation algorithms, these advanced techniques will be advantageous in criminal investigation. However, with the use of areal topography comes the addition of height point data which may differ in primer caps of varying material composition. This study discusses the differences in the overall topography of firing pin impressions in different primer cap materials, and the effect it has on the successful correlation of ballistic toolmark evidence.

The Impact of Alkaliphilic Biofilm Formation on the Release and Retention of Carbon Isotopes from Nuclear Reactor Graphite.

14C is an important consideration within safety assessments for proposed geological disposal facilities for radioactive wastes, since it is capable of re-entering the biosphere through the generation of 14C bearing gases. The irradiation of graphite moderators in the UK gas-cooled nuclear power stations has led to the generation of a significant volume of 14C-containing intermediate level wastes. Some of this 14C is present as a carbonaceous deposit on channel wall surfaces. Within this study, the potential of biofilm growth upon irradiated and 13C doped graphite at alkaline pH was investigated. Complex biofilms were established on both active and simulant samples. High throughput sequencing showed the biofilms to be dominated by Alcaligenes sp at pH 9.5 and Dietzia sp at pH 11.0. Surface characterisation revealed that the biofilms were limited to growth upon the graphite surface with no penetration of the deeper porosity. Biofilm formation resulted in the generation of a low porosity surface layer without the removal or modification of the surface deposits or the release of the associated 14C/13C. Our results indicated that biofilm formation upon irradiated graphite is likely to occur at the pH values studied, without any additional release of the associated 14C.

The influence of hydroalcoholic media on the performance of Grewia polysaccharide in sustained release tablets.

Co-administration of drugs with alcohol can affect the plasma concentration of drugs in patients. It is also known that the excipients used in the formulation of drugs may not always be resistant to alcohol. This study evaluates effect of varying alcohol concentrations on theophylline release from two grades of Grewia mollis polysaccharides. X-ray microtomography showed that native polysaccharide formulation compacts were not homogenous after the mixing process resulting in its failure in swelling studies. Removal of starch from the native polysaccharide resulted in homogenous formulation compacts resistant to damage in high alcoholic media in pH 6.8 (40%v/v absolute ethanol). Destarched polymer compacts had a significantly higher hardness (375N) than that of the native polysaccharide (82N) and HPMC K4M (146N). Dissolution studies showed similarity at all levels of alcohol tested (f2=57-91) in simulated gastric media (pH 1.2). The dissolution profiles in the simulated intestinal fluids were also similar (f2=60-94), with the exception of the native polysaccharide in pH 6.8 (40%v/v absolute ethanol) (f2=43). This work highlights the properties of Grewia polysaccharide as a matrix former that can resist high alcoholic effects therefore; it may be suitable as an alternative to some of the commercially available matrix formers with wider applications for drug delivery as a cheaper alternative in the developing world.

Improvement in the assessment of wear of total knee replacements using coordinate-measuring machine techniques.

Total joint replacement is one of the most common elective surgical procedures performed worldwide, with an estimate of 1.5x 10(6) operations performed annually. Currently joint replacements are expected to function for 10-15 years; however, with an increase in life expectancy, and a greater call for knee replacement due to increased activity levels, there is a requirement to improve their function to offer longer-term improved quality of life for patients. Wear analysis of total joint replacements has long been an important means in determining failure mechanisms and improving longevity of these devices. The effectiveness of the coordinate-measuring machine (CMM) technique for assessing volumetric material loss during simulated life testing of a replacement knee joint has been proved previously by the present authors. The purpose of the current work is to present an improvement to this method for situations where no pre-wear data are available. To validate the method, simulator tests were run and gravimetric measurements taken throughout the test, such that the components measured had a known wear value. The implications of the results are then discussed in terms of assessment of joint functionality and development of standardized CMM-based product standards. The method was then expanded to allow assessment of clinically retrieved bearings so as to ascertain a measure of true clinical wear.

The precipitation of calcium carbonate polymorphs in vitro at 37 degrees C.

In order to determine some of the factors that affect the formation of the three polymorphs of calcium carbonate in gallstones, its precipitation from undisturbed solutions containing calcium chloride and sodium bicarbonate was studied. The variation in the amount of calcium carbonate formed with time was studied by weighing the precipitate, and the percentages of calcite, vaterite, and aragonite were determined by x-ray diffraction (XRD) analysis. The effects of additives and stirring were noted. Minor changes in conditions were sufficient to affect the formation of the polymorphs, and all three polymorphs could be found simultaneously in some solutions. It is suggested that no great differences in precipitating conditions need to be postulated to account for the presence of different polymorphs in gallstones. Aragonite seems to be formed slowly in undisturbed conditions.

Microstructure of gallstones.

Electron microprobe analysis, x-ray diffraction, and infrared spectroscopy have been used to investigate the nature and arrangement of materials present in gallstones. Calcium phosphate and carbonate deposits present centrally in many stones were mixed with a pigmented phase containing copper and protein. In several stones, the central calcium deposits were surrounded by discrete adjacent layers of calcium bilirubinate and cholesterol. The calcium bilirubinate layer was distinguished from other pigmented layers by its higher protein content and increased iron/copper ratio. This sequence of calcium salt and cholesterol deposition occurred in the outer layers of some stones. The phase relationships shown by the present study are consistent with a biphasic mechanism of stone growth in which calcium salts and lipid were alternately deposited. Calcium salt precipitation has been inferred to initiate the sequence as calcium salts were found at the stone centers. The layer sequence has been discussed in terms of some possible effects of damage to the gallbladder wall caused by the calcium salt deposits.

Electron probe microanalysis in the study of gallstones.

Detailed information on the structure and composition of gallstones was obtained using an electron probe microanalyser in conjunction with the other methods. Gallstones were studied layer by layer without greatly disturbing the arrangement of the materials present. Elements, including trace elements such as copper, iron, and manganese, were identified and their distributions mapped. The range of the method was extended to determine the character and distribution of certain chemical groups present by treating sections of gallstone with reagents which contained easily detected elements. The nature of the bonding of the sulphur in the stones was studied by examining the sulphur-X-ray spectrum. Pigmented sulphur-containing deposits were found to contain sulphur in a low valence state but taurine conjugates and the sulphate groups of mucosubstances were not detected. Microcrystalline apatite present in the stones contained some manganese and seemed to be implicated in the absorption of the low valence sulphur compound and in the nucleation of some stones.

A structural study of gallstones.

A number of gallstones have been studied using methods which have not previously been applied to gallstones. In particular, the use of scanning electron microscopy and micro-x-radiography have allowed detailed observations to be made on the structure of the stones and the distribution of the various components within the stones. Large differences in structure have been shown to exist between stones having similar overall chemical compositions. In cholesterol gallstones containing calcium carbonate the crystalline nature, distribution and method of deposition of the calcium carbonate was studied and was found to vary from stone to stone. Evidence was found for the presence of fibrous material in the centre of many stones and it is possible that this material acted as a nucleus for the deposition of the other stone components.