RESUMO
This paper studies the thermal, morphological, and mechanical properties of 3D-printed polylactic acid (PLA) blends of virgin and recycled material in the following proportions: 100/0, 25/75, 50/50, and 75/25, respectively. Real waste, used as recycled content, was shredded and sorted by size without a washing step. Regular dog-bone specimens were 3D printed from filaments, manufactured in a single screw extruder. Thermogravimetric analysis indicated that adding PLA debris to raw material did not significantly impact the thermal stability of the 3D-printed samples and showed that virgin and recycled PLA degraded at almost the same temperature. Differential scanning calorimetry revealed a significant reduction in crystallinity with increasing recycled content. Scanning electron microscopy showed a more homogenous structure for specimens from 100% pure PLA, as well as a more heterogeneous one for PLA blends. The tensile strength of the PLA blends increased by adding more recycled material, from 44.20 ± 2.18 MPa for primary PLA to 52.61 ± 2.28 MPa for the blend with the highest secondary PLA content. However, this study suggests that the mechanical properties of the reprocessed parts and their basic association are unique compared with those made up of virgin material.
RESUMO
In the new transformation of 'Industry 4.0', additive manufacturing technologies have become one of the fastest developed industries, with polylactic acid (PLA) playing a significant role. However, there is an increasing amount of garbage generated during the printing process and after prototypes or end-of-life parts. Re-3D printing is one way to recycle PLA waste from fused filament fabrication. To do this process successfully, the properties of the waste mixture should be known. Previous studies have found that PLA degrades hydrolytically, but the time at which this process occurs for 3D printed products is not specified. This work aims to establish the baseline of the degradation kinetics of 3D printed PLA products to predict the service time until which these properties are retained. To achieve this, 3D printed specimens were thermally and hydrothermally aged during several time intervals. Thermal and mechanical properties were also determined. This study reveals that tensile strength decreases after 1344 h of hydrothermal ageing, simulating 1.5-2.5 years of real service time. PLA therefore has the same thermo-mechanical properties before reaching 1.5-years of age, so it could be recycled.