Effect of Tris Buffer in the Intensity of the Multipoint Covalent Immobilization of Enzymes in Glyoxyl-Agarose Beads.

Tris is an extensively used buffer that presents a primary amine group on its structure. In the present work trypsin, chymotrypsin and penicillin G acylase (PGA) were immobilized/stabilized on glyoxyl agarose in presence of different concentrations of Tris (from 0 to 20 mM). The effects of the presence of Tris during immobilization were studied analyzing the thermal stability of the obtained immobilized biocatalysts. The results indicate a reduction of the enzyme stability when immobilized in the presence of Tris. This effect can be observed in inactivations carried out at pH 5, 7, and 9 with all the enzymes assayed. The reduction of enzyme stability increased with the Tris concentration. Another interesting result is that the stability reduction was more noticeable for immobilized PGA than in the other immobilized enzymes, the biocatalysts prepared in presence of 20 mM Tris lost totally the activity at pH 7 just after 1 h of inactivation, while the reference at this time still kept around 61 % of the residual activity. These differences are most likely due to the homogeneous distribution of the Lys groups in PGA compared to trypsin and chymotrypsin (where almost 50% of Lys group are in a small percentage of the protein surface). The results suggest that Tris could be affecting the multipoint covalent immobilization in two different ways, on one hand, reducing the number of available glyoxyl groups of the support during immobilization, and on the other hand, generating some steric hindrances that difficult the formation of covalent bonds.

Effect of Concentrated Salts Solutions on the Stability of Immobilized Enzymes: Influence of Inactivation Conditions and Immobilization Protocol.

This paper aims to investigate the effects of some salts (NaCl, (NH4)2SO4 and Na2SO4) at pH 5.0, 7.0 and 9.0 on the stability of 13 different immobilized enzymes: five lipases, three proteases, two glycosidases, and one laccase, penicillin G acylase and catalase. The enzymes were immobilized to prevent their aggregation. Lipases were immobilized via interfacial activation on octyl agarose or on glutaraldehyde-amino agarose beads, proteases on glyoxyl agarose or glutaraldehyde-amino agarose beads. The use of high concentrations of salts usually has some effects on enzyme stability, but the intensity and nature of these effects depends on the inactivation pH, nature and concentration of the salt, enzyme and immobilization protocol. The same salt can be a stabilizing or a destabilizing agent for a specific enzyme depending on its concentration, inactivation pH and immobilization protocol. Using lipases, (NH4)2SO4 generally permits the highest stabilities (although this is not a universal rule), but using the other enzymes this salt is in many instances a destabilizing agent. At pH 9.0, it is more likely to find a salt destabilizing effect than at pH 7.0. Results confirm the difficulty of foreseeing the effect of high concentrations of salts in a specific immobilized enzyme.

Effect of amine length in the interference of the multipoint covalent immobilization of enzymes on glyoxyl agarose beads.

Trypsin, chymotrypsin, penicillin G acylase and ficin extract have been stabilized by immobilization on glyoxyl agarose, adding different aliphatic compounds bearing a primary amine group during the immobilization: ethyl amine, butyl amine, hexyl amine (at concentrations ranging from 0 to 20 mM) and octyl amine (from 0 to 10 mM) to analyze their effects on the immobilized enzyme stability. As expected, the presence of amines reduced the intensity of the enzyme-support multipoint covalent attachment, and therefore the enzyme stability. However, it is clear that this effect is higher using octyl amine for all enzymes (in some cases the enzyme immobilized in the presence of 10 mM octyl amine was almost inactivated while the reference kept over 50 % of the initial activity). This way, it seems that the most important effect of the presence of aminated compounds came from the generation of steric hindrances to the enzyme/support multi-reaction promoted by the ammines that are interacting with the aldehyde groups. In some instances, just 1 mM of aminated compounds is enough to greatly decrease enzyme stability. The results suggested that, if the composition of the enzyme extract is unknown, to eliminate small aminated compounds may be necessary to maximize the enzyme-support reaction.

Further Stabilization of Alcalase Immobilized on Glyoxyl Supports: Amination Plus Modification with Glutaraldehyde.

Alcalase was immobilized on glyoxyl 4% CL agarose beads. This permitted to have Alcalase preparations with 50% activity retention versus Boc-l-alanine 4-nitrophenyl ester. However, the recovered activity versus casein was under 20% at 50 °C, as it may be expected from the most likely area of the protein involved in the immobilization. The situation was different at 60 °C, where the activities of immobilized and free enzyme became similar. The chemical amination of the immobilized enzyme or the treatment of the enzyme with glutaraldehyde did not produce any significant stabilization (a factor of 2) with high costs in terms of activity. However, the modification with glutaraldehyde of the previously aminated enzyme permitted to give a jump in Alcalase stability (e.g., with most than 80% of enzyme activity retention for the modified enzyme and less than 30% for the just immobilized enzyme in stress inactivation at pH 7 or 9). This preparation could be used in the hydrolysis of casein at pH 9 even at 67 °C, retaining around 50% of the activity after 5 hydrolytic cycles when the just immobilized preparation was almost inactive after 3 cycles. The modified enzyme can be reused in hydrolysis of casein at 45 °C and pH 9 for 6 cycles (6 h) without any decrease in enzyme activity.