Controls of wellbore flow regimes on pump effluent composition.

Where well water and formation water are compositionally different or heterogeneous, pump effluent composition will vary due to partial mixing and transport induced by pumping. Investigating influences of purging and sampling methodology on composition variability requires quantification of wellbore flow regimes and mixing. As a basis for this quantification, analytical models simulating Poiseuille flow were developed to calculate flow paths and travel times. Finite element modeling was used to incorporate influences of mixing. Parabolic velocity distributions within the screened interval accelerate with cumulative inflow approaching the pump intake while an annulus of inflowing formation water contracts uniformly to displace an axial cylinder of pre-pumping well water as pumping proceeds. Increased dispersive mixing forms a more diffuse formation water annulus and the contribution of formation water to pump effluent increases more rapidly. Models incorporating viscous flow and diffusion scale mixing show that initially pump effluent is predominantly pre-pumping well water and compositions vary most rapidly. After two screen volumes of pumping, 94% of pump effluent is inflowing formation water. Where the composition of formation water and pre-pumping well water are likely to be similar, pump effluent compositions will not vary significantly and may be collected during early purging or with passive sampling. However, where these compositions are expected to be considerably different or heterogeneous, compositions would be most variable during early pumping, that is, when samples are collected during low-flow sampling. Purging of two screen volumes would be required to stabilize the content and collect a sample consisting of 94% formation water.

A downhole passive sampling system to avoid bias and error from groundwater sample handling.

A new downhole groundwater sampler reduces bias and error due to sample handling and exposure while introducing minimal disturbance to natural flow conditions in the formation and well. This "In Situ Sealed", "ISS", or "Snap" sampling device includes removable/lab-ready sample bottles, a sampler device to hold double end-opening sample bottles in an open position, and a line for lowering the sampler system and triggering closure of the bottles downhole. Before deployment, each bottle is set open at both ends to allow flow-through during installation and equilibration downhole. Bottles are triggered to close downhole without well purging; the method is therefore "passive" or "nonpurge". The sample is retrieved in a sealed condition and remains unexposed until analysis. Data from six field studies comparing ISS sampling with traditional methods indicate ISS samples typically yield higher volatile organic compound (VOC) concentrations; in one case, significant chemical-specific differentials between sampling methods were discernible. For arsenic, filtered and unfiltered purge results were negatively and positively biased, respectively, compared to ISS results. Inorganic constituents showed parity with traditional methods. Overall, the ISS is versatile, avoids low VOC recovery bias, and enhances reproducibility while avoiding sampling complexity and purge water disposal.