Evaluation of silicon and indium gallium arsenide photodiodes as direct timing detectors for pulsed x-ray systems.

Benchtop pulsed x-ray systems are commonly used to record dynamic material data on the order of nanoseconds, but pulse timing is often difficult to accurately determine. This study demonstrates that commercially available photodiodes can be used effectively for direct x-ray pulse detection without the need for visible light scintillators. X-ray pulses from four commercially available flash x-ray systems were quantified using one silicon and two indium gallium arsenide (InGaAs) photodiodes. The measured InGaAs pulse durations were strongly dependent on radiation dose in the non-linear operating regime, so the photodiodes were shielded to operate below the 2.5 V non-linear regime threshold. The average pulse duration and pulse arrival time jitter of the photodiodes for each x-ray source were within several nanoseconds with the exception of two sets of measurements that were affected by low instrument sensitivity and electrical noise. These results show that InGaAs photodiodes can be used as effective and repeatable stand-alone timing diagnostics for x-ray pulses as short as 20 ns or less.

Switchable Explosives: Performance Tuning of Fluid-Activated High Explosive Architectures.

We present our discovery of switchable high explosives (HEs) as a new class of energetic material that cannot detonate unless filled with a fluid. The performance of fluid-filled additive-manufactured HE lattices is herein evaluated by analysis of detonation velocity and Gurney energy. The Gurney energy of the unfilled lattice was 98% lower than that of the equivalent water-filled lattice and changing the fluid mechanical properties allowed tuning of the Gurney energy and detonation velocity by 8.5% and 13.4%, respectively. These results provide, for the first time since the development of HEs, a method to completely remove the hazard of unplanned detonations during storage and transport.