Superhydrophobic conductive rubber band with synergistic dual conductive layer for wide-range sensitive strain sensor.

Wearable electronic devices have received increasing interests because of their excellent flexibility, stretchability, and human friendliness. As the core components, flexible strain sensors integrated with wide working range, high sensitivity, and environment stability, especially in moisture or corrosive environments, remain a huge challenge. Herein, synergistic carbon nanotubes (CNTs)/reduced graphene oxide (rGO) dual conductive layer decorated elastic rubber band (RB) was successfully developed and treated with hydrophobic fumed silica (Hf-SiO2) for preparing superhydrophobic strain sensor. As expected, stable entangled CNTs layer and ultrasensitive microcracked rGO layer endow the sensor with extremely low detection limit (0.1%), high sensitivity (gauge factor is 685.3 at 482% strain), wide workable strain range (0-482%), fast response/recovery (200 ms/200 ms) and favorable reliability and reproducibility over 1000 cycles. Besides, the constructed Hf-SiO2 coating also makes the sensor exhibit excellent superhydrophobicity, self-cleaning property, and corrosion-resistance. As a proof of concept, our prepared high-performance strain sensor can realize the full-range monitoring of human motions and physiological signals even in the water environment, including pulse, vocalization, joint bending, running, and gesture recognition. Interestingly, it can also be knitted into a tactile electronic textile for spatial pressure distribution measurement. Thus, this study provides a universal technique for the preparation of high-performance strain sensors with great potential applications in the field of next-generation intelligent wearable electronics.

Ultrasensitive strain sensor based on superhydrophobic microcracked conductive Ti3C2Tx MXene/paper for human-motion monitoring and E-skin.

With the rapid development of wearable intelligent devices, low-cost wearable strain sensors with high sensitivity and low detection limit are urgently demanded. Meanwhile, sensing stability of sensor in wet or corrosive environments should also be considered in practical applications. Here, superhydrophobic microcracked conductive paper-based strain sensor was fabricated by coating conductive Ti3C2Tx MXene on printing paper via dip-coating process and followed by depositing superhydrophobic candle soot layer on its surface. Owing to the ultrasensitive microcrack structure in the conductive coating layer induced by the mismatch of elastic modulus and thermal expansion coefficient between conductive coating layer and paper substrate during the drying process, the prepared paper-based strain sensor exhibited a high sensitivity (gauge factor, GF = 17.4) in the strain range of 0-0.6%, ultralow detection limit (0.1% strain) and good fatigue resistance over 1000 cycles towards bending deformation. Interestingly, it was also applicable for torsion deformation detection, showing excellent torsion angle dependent, repeatable and stable sensing performances. Meanwhile, it displayed brilliant waterproof, self-cleaning and corrosion-resistant properties due to the existence of micro/nano-structured and the low surface energy candle soot layer. As a result, the prepared paper-based strain sensor can effectively monitor a series of large-scale and small-scale human motions even under water environment, showing the great promising in practical harsh outdoor environments. Importantly, it also demonstrated good applicability for spatial strain distribution detection of skin upon body movement when assembled into electronic-skin (E-skin). This study will provide great guidance for the design of next generation wearable strain sensor.