RESUMO
Reaction of MBr2 with 3 equiv of [K(18-crown-6)][O2N2CPh3] generates the trityl diazeniumdiolate complexes [K(18-crown-6)][M(O2N2CPh3)3] (M = Co, 2; Fe, 3) in good yields. Irradiation of 2 and 3 using 371 nm light led to NO formation in 10 and 1% yields (calculated assuming a maximum of 6 equiv of NO produced per complex), respectively. N2O was also formed during the photolysis of 2, in 63% yield, whereas photolysis of 3 led to the formation of N2O, as well as Ph3CN(H)OCPh3, in 37 and 5% yields, respectively. These products are indicative of diazeniumdiolate fragmentation via both C-N and N-N bond cleavage pathways. In contrast, oxidation of complexes 2 and 3 with 1.2 equiv of [Ag(MeCN)4][PF6] led to N2O formation but no NO formation, suggesting that diazeniumdiolate fragmentation occurs exclusively via C-N bond cleavage under these conditions. While the photolytic yields of NO are modest, they represent a 10- to 100-fold increase compared to the previously reported Zn congener, suggesting that the presence of a redox-active metal center favors NO formation upon trityl diazeniumdiolate fragmentation.
RESUMO
The necessity of well-tuned reactivity for successful controlled polymer synthesis often comes with the price of limited monomer substrate scope. We demonstrate here the on-demand interconversion between living radical and cationic polymerization using two orthogonal stimuli and a dual responsive single catalyst. The dual photo- and electrochemical reactivity of 10-phenylphenothiazine catalyst provides control of the polymer's molar mass and composition by orthogonally activating the common dormant species toward two distinct chemical routes. This enables the synthesis of copolymer chains that consist of radically and cationically polymerized segments where the length of each block is controlled by the duration of the stimulus exposure. By alternating the application of photochemical and electrochemical stimuli, the on-demand incorporation of acrylates and vinyl ethers is achieved without compromising the end-group fidelity or dispersity of the formed polymer. The results provide a proof-of-concept for the ability to substantially extend substrate scope for block copolymer synthesis under mild, metal-free conditions through the use of a single, dual reactive catalyst.
RESUMO
We report the facile activation of aryl E-H (ArEH; E = N, O, S; Ar = Ph or C6F5) or ammonia N-H bonds via coordination-induced bond weakening to a redox-active boron center in the complex, (1-). Substantial decreases in E-H bond dissociation free energies (BDFEs) are observed upon substrate coordination, enabling subsequent facile proton-coupled electron transfer (PCET). A drop of >50 kcal mol-1 in H2N-H BDFE upon coordination was experimentally determined.
RESUMO
Redox flow batteries (RFBs) employing nonaqueous electrolytes could potentially operate at much higher cell voltages, and therefore afford higher energy and power densities, than RFBs employing aqueous electrolytes. The development of such high-voltage nonaqueous RFBs requires anolytes that are electrochemically stable, especially in the presence of traces of oxygen and/or moisture. The inherent atmospheric reactivity of anolytes mandates judicious molecular design with high electron affinity and electrochemical stability. In this study, diketopyrrolopyrrole (DPP)-based TDPP-Hex-CN4 is proposed as a stable redox-active molecule for anolytes in nonaqueous organic RFBs. We demonstrate organic RFBs using TDPP-Hex-CN4 as anolyte with unisol blue (UB) 1,4-bis(isopropylamino)anthraquinone and 1,4-di-tert-butyl-2,5-bis(2-methoxyethoxy)benzene (DBBB) as catholytes. Cyclic voltammetry measurements with scans repeated over 200 cycles were performed to establish the electrochemical stability of the redox pairs. Symmetric flow-cell studies show that TDPP-Hex-CN4 exhibits stable capacity up to 700 cycles. Redox flow cells employing TDPP-Hex-CN4 /UB and TDPP-Hex-CN4 /DBBB as redox pairs demonstrate that DPP derivatives are propitious materials for anolytes in all organic nonaqueous RFBs.