RESUMO
Ag50Cu50 films were deposited on glass substrates by a sputtering system. Effects of accumulated energy on nanoparticle formation in pulse-laser dewetting of AgCu films were investigated. The results showed that the properties of the dewetted films were found to be dependent on the magnitude of the energy accumulated in the film. For a low energy accumulation, the two distinct nanoparticles had rice-shaped/Ag60Cu40 and hemispherical/Ag80Cu20. Moreover, the absorption spectra contained two peaks at 700 nm and 500 nm, respectively. By contrast, for a high energy accumulation, the nanoparticles had a consistent composition of Ag60Cu40, a mean diameter of 100 nm and a peak absorption wavelength of 550 nm. Overall, the results suggest that a higher Ag content of the induced nanoparticles causes a blue shift of the absorption spectrum, while a smaller particle size induces a red shift.
RESUMO
Alloys with ultra-high strength and sufficient ductility are highly desired for modern engineering applications but difficult to develop. Here we report that, by a careful controlling alloy composition, thermomechanical process, and microstructural feature, a Co-Cr-Ni-based medium-entropy alloy (MEA) with a dual heterogeneous structure of both matrix and precipitates can be designed to provide an ultra-high tensile strength of 2.2 GPa and uniform elongation of 13% at ambient temperature, properties that are much improved over their counterparts without the heterogeneous structure. Electron microscopy characterizations reveal that the dual heterogeneous structures are composed of a heterogeneous matrix with both coarse grains (10â¼30 µm) and ultra-fine grains (0.5â¼2 µm), together with heterogeneous L12-structured nanoprecipitates ranging from several to hundreds of nanometers. The heterogeneous L12 nanoprecipitates are fully coherent with the matrix, minimizing the elastic misfit strain of interfaces, relieving the stress concentration during deformation, and playing an active role in enhanced ductility.
RESUMO
AIM: To evaluate efficacy of T2-weighted (T2W) iterative decomposition of water and fat with echo asymmetry and least-squares estimation (IDEAL)-fast spin echo (FSE) imaging of the cervical spine. MATERIALS AND METHODS: The cervical spine of 100 symptomatic patients was imaged using routine magnetic resonance imaging (MRI) versus IDEAL-FSE imaging. The signal-to-noise ratios (SNRs), contrast-to-noise ratios (CNRs), and image quality were analysed. To compare the diagnostic efficiency of degenerative spondylopathy, evaluations of spondylolisthesis, retrolisthesis, disc herniation, myelopathy, disc degeneration, and bone marrow oedema were also performed. RESULTS: IDEAL-FSE showed significantly higher SNRs and CNRs (all p<0.001) than fat-suppressed (FS) T2W-FSE. Sixteen of 100 patients had cervical spine instrumentation; in those patients, IDEAL-FSE provided significantly better uniformity of fat suppression (p<0.001) and fewer metallic artefacts (p<0.001). For patients without instrumentation, FS T2W-FSE showed significantly better overall image quality (p<0.001) and homogeneity of the cerebrospinal fluid (CSF; p<0.001) with fewer motion artefacts (p<0.001). IDEAL-FSE, however, provided significantly better uniformity of fat suppression (p<0.001). There were no significant differences in the diagnoses of spondylolisthesis, retrolisthesis, disc herniation, or myelopathy between IDEAL and FS T2W images. The only significant differences between the IDEAL and FS T2W images were noted when diagnosing degenerative disc disease at the C2-3 and C5-6 disc levels (p=0.019, p=0.002, respectively) and bone marrow oedema at C3 vertebral body (p=0.029). CONCLUSION: T2W IDEAL-FSE imaging should only be considered as an additional sequence to conventional FS T2W images in patients with poor fat suppression or severe metallic artefacts.