Evaluation of nutritional, technological, oxidative, and sensory properties of low-sodium and phosphate-free mortadellas produced with bamboo fiber, pea protein, and mushroom powder.

This study examined the effects of replacing alkaline phosphate (AP) with bamboo fiber (BF), isolated pea protein (PP), and mushroom powder (MP) on the nutritional, technological, oxidative, and sensory characteristics of low-sodium mortadellas. Results indicated that this reformulation maintained the nutritional quality of the products. Natural substitutes were more effective than AP in reducing water and fat exudation. This led to decreased texture profile analysis (TPA) values such as hardness, cohesiveness, gumminess, and chewiness. The reformulation reduced the L* values and increased the b* values, leading to color modifications rated from noticeable to appreciable according to the National Bureau of Standards (NBS) index. Despite minor changes in oxidative stability indicated by increased values in TBARS (from 0.19 to 0.33 mg MDA/kg), carbonyls (from 2.1 to 4.4 nmol carbonyl/mg protein), and the volatile compound profile, the sensory profile revealed a beneficial increase in salty taste, especially due to the inclusion of MP, which was enhanced by the synergy with BF and PP. In summary, the results confirmed the potential of natural alternatives to replace chemical additives in meat products. Incorporating natural antioxidants into future formulations could address the minor oxidation issues observed and enhance the applicability of this reformulation strategy.

Pea Protein Isolate as a Meat Substitute in Canned Pork Pâté: Nutritional, Technological, Oxidative, and Sensory Properties.

This study investigated the feasibility of replacing pork meat with pea protein isolate in canned pâtés at proportions ranging from 12.5% to 50%. The results indicated that protein reformulation did not significantly impact the protein content and lipid oxidation of the pâtés. Reformulated products exhibited a decrease in a∗ values and an increase in b∗ values. These color changes were also sensorially identified in the Check-All-That-Apply (CATA) test, where the reformulated pâtés were associated with attributes such as 'yellow color' and 'unpleasant color', which were inversely related to product acceptance. The protein reformulation reduced the hardness, gumminess, and chewiness parameters of the pâtés. These textural changes were positively reflected in the CATA test, where the reformulated products were characterized by attributes like 'soft texture', 'pleasant texture', and 'good spreadability', which strongly correlated with higher consumer acceptance. Notably, pâtés with 37.5% and 50% substitutions of pork meat with pea protein showed acceptability levels comparable to the control, and those with up to a 25% substitution exhibited superior sensory acceptability. However, the color alteration suggests the need for future optimization, such as using natural colorants. In summary, the results of this study not only validate the feasibility of replacing pork meat with pea protein in pâtés but also offer valuable insights for future investigations to develop more innovative and sustainable meat products.

Replacing Animal Fat with Gels of Psyllium Fiber and Combined Linseed Oil-Psyllium Fiber in Salamis: Impacts on Technological, Nutritional, Oxidative, and Sensory Properties.

This study produced two gels: one solely using psyllium fiber (GP) and another combining this fiber with linseed oil (GL+P). Both gels replaced 15% and 30% of the animal fat content of salamis. The objective was to evaluate the impact of this lipid reformulation on the technological, nutritional, oxidative, and sensory properties of the salamis. The lipid reformulation did not alter the evolution of pH and lactic acid bacteria during processing. The addition of GL+P did not interfere with the product's drying process. However, replacing 30% of animal fat with the GP resulted in greater weight loss and a lower final Aw value. The lipid reformulation minimally affected the color of the salamis but significantly enhanced their nutritional profile. This improvement was marked by a decrease in fat content and an increase in protein. Specifically, in the samples with GL+P, there was a rise in linolenic acid content and a reduction in the n-6/n-3 PUFA ratio. Adding GP did not affect the salamis' oxidative stability and sensory profile. However, substituting 30% of the animal fat with GL+P increased the TBARS values, and volatile compounds derived from lipid oxidation hampered the products' sensory profiles. A reduction in these negative effects was observed when replacing 15% of the fat with GL+P, suggesting this to be the ideal dosage for balancing the nutritional benefits with maintaining the product's oxidative stability.

Jabuticaba peel extract and nisin: A promising combination for reducing sodium nitrite in Bologna-type sausages.

This study investigated the effect of a 50% reduction in sodium nitrite and the addition of nisin (200 mg/kg) and different concentrations (0, 0.5%, 0.75%, and 1%) of jabuticaba peel extract (JPE) on the main attributes affected by this chemical additive in Bologna-type sausages. The modified treatments showed approximately 50% lower residual nitrite than the control throughout the storage (60 days at 4 °C). The proposed reformulation did not affect the color (L*, a*, and b*), and the ΔE values (< 2) demonstrated high color stability during storage. Physicochemical (TBARS and volatile compounds) and sensory analyses performed to evaluate oxidative stability indicated that JPE exhibited antioxidant activity comparable to sodium nitrite. The microbiological quality of the reformulated products was similar to the control, but further studies should be conducted to assess the effect of this reformulation strategy on the growth of pathogenic microorganisms impacted by nitrite.

Raspberry Extract as a Strategy to Improve the Oxidative Stability of Pork Burgers Enriched with Omega-3 Fatty Acids.

Hydrogelled emulsions (HEs) of linseed oil and pea protein (PP) were produced with four levels (0, 5, 7.5, and 10%) of raspberry extract obtained by a green extraction technique (microwave hydrodiffusion and gravity-MHG). HEs were applied in burgers to replace 50% of pork backfat content. The products' technological, nutritional, oxidative, microbiological, and sensory properties were evaluated. Besides reducing the fat level by approximately 43%, the reformulation reduced the n-6/n-3 PUFA ratio to healthy levels, decreased the diameter reduction by 30%, and increased the cooking yield by 11%. Including 7.5 and 10% of raspberry extract in the HEs decreased the oxidative defects caused by the enrichment of the burgers with omega-3 fatty acids. In addition, the raspberry extract did not cause alterations in the mesophilic aerobic count and the burgers' sensory profile.

High-power ultrasound, micronized salt, and low KCl level: An effective strategy to reduce the NaCl content of Bologna-type sausages by 50.

This study evaluated the combination of high-power ultrasound (HPU), micronized salt (MS), and low KCl levels as a strategy to produce reduced sodium Bologna-type sausages. Samples with 50% NaCl reduction were produced with regular salt (RS) or MS and 0.5% KCl. The sausages were sonicated for 0 or 27 min in an ultrasonic bath (25 kHz, 60% amplitude, normal mode, 20 °C) immediately after filling. The sodium reformulation strategy was effective in compensating for the defects in the emulsion stability and texture profile caused by the NaCl reduction. Besides, the combination of HPU, MS, and KCl did not cause major impacts on the evolution of pH, Eh, and TBARS values of the sausages during storage (21 days at 4 °C). The use of MS and KCl also allowed a reduction by 50% of the NaCl content (< 42% Na; Na/K ratio: 1.2 to 1.3) of the samples without affecting the salty taste, which was enhanced by the HPU treatment.

Hydrogelled emulsion from linseed oil and pea protein as a strategy to produce healthier pork burgers with high technological and sensory quality.

Hydrogelled emulsions (HEs) produced with linseed oil and different levels of pea protein (PP) (0, 5, 10, 15, and 20%) were used to replace 50% of animal fat in burgers. The effect of this lipid reformulation on the nutritional, technological, oxidative, microbiological, and sensory quality of the burgers was evaluated during their refrigerated storage (4 °C for 12 days). The reformulated burgers displayed a reduction of >40% in fat and an increase of up to 10% in protein content. Lipid reformulation also increased the PUFA/SFA ratio and reduced the n-6/n-3 PUFAs ratio and the atherogenicity and thrombogenicity indices of the lipid fraction of the burgers. Including 5 and 10% of PP in the HEs made it possible to obtain burgers of high technological quality and with a sensory profile similar to full-fat products. PP was also efficient in reducing the increase in the lipid oxidation caused by the enrichment with n-3 PUFAs.

Effect of high-power ultrasound and bamboo fiber on the technological and oxidative properties of phosphate-free meat emulsions.

The combination of high-power ultrasound (HPU) and bamboo fiber (BF) was investigated as a strategy to produce phosphate-free meat emulsions. The samples were made with the addition of 0 and 0.25% of alkaline phosphate and 0, 2.5, and 5% BF. Immediately after filling, the samples were sonicated for 0 or 27 min at normal mode, 25 kHz, 60% amplitude, and 20 °C. The samples made with BF and without phosphate showed higher emulsion stability compared to the control made with phosphate. The addition of 2.5% BF effectively compensated for the texture changes due to the absence of phosphate. HPU improved the effect of BF on the texture of meat emulsions by increasing cohesiveness. No significant impact of HPU and BF was observed on the oxidative quality of the samples. However, the instrumental assays and the sensory evaluation demonstrated that the absence of phosphate increased the lipid oxidation of the samples from the beginning of storage.

Ultrasound and low-levels of NaCl replacers: A successful combination to produce low-phosphate and low-sodium meat emulsions.

Meat emulsions were made with 50% of phosphate level commonly used in the meat industry, and 0, 25, and 50% NaCl reduction. In addition, salt replacers (KCl, CaCl2, or MgCl2) were used in the formulations with 25 and 50% salt reduction, corresponding to 10 and 20% of the total amount of salts added, respectively. After embedding in casings, the samples were sonicated (25 kHz and 230 W) in an ultrasonic bath (US) at 20 °C for 0, 18, and 27 min. The addition of CaCl2 or MgCl2 impaired (P < .05) the technological properties of the low-sodium samples. Defects caused by NaCl reduction were not eliminated by 18-min US. However, the combination of KCl and 27-min US eliminated the technological defects caused by the 50% NaCl reduction, with no major impact on lipid oxidation during storage (21 days/4 °C), as observed in the TBARS and sensory profile results. Therefore, it is possible to produce low-phosphate and low-sodium meat emulsions.

Hydrogelled emulsion from chia and linseed oils: A promising strategy to produce low-fat burgers with a healthier lipid profile.

Burgers (20% pork back fat) were produced with the replacement of 0, 20, 40, 60, 80, and 100% of pork back fat by hydrogelled emulsion (HE) from chia and linseed oils. No changes (P > .05) were observed for the moisture retention, diameter reduction, and cooking loss of the treatments, with a significant increase in the lipid retention (P < .05). Hardness increased (P < .05) with increasing the lipid replacement level, and a significant color difference (ΔE) was detected between the treatments and the control. In addition to reducing animal fat, a healthier fatty acid profile was reached after the lipid reformulation of the burgers, thus allowing the burgers to be labeled with health claims. The sensory tests (acceptance and Check-All-That-Apply) indicated that it is possible to replace up to 60% of pork back fat by HE.

Ultrasound: A new approach to reduce phosphate content of meat emulsions.

Meat emulsions with a reduction of 0, 25, 50, 75, and 100% of phosphate levels were produced. Soon after filling, the pieces were sonicated in an ultrasonic bath (normal mode, 60% amplitude, 25 KHz frequency, 230 W acoustic power, and 33 W L-1 volumetric power) for 0, 9, and 18 min. The technological, oxidative, and sensory quality was evaluated. The reduction of the phosphate content in the non-sonicated samples led to a decrease in the cooking yield and emulsion stability and impaired the texture profile, and the oxidative and sensory quality of the samples. Although the 9-min ultrasound treatment was not effective to compensate for defects caused by the phosphate reduction, the application for 18 min improved the technological quality and did not increase the lipid oxidation. In addition, it allowed reducing most of the sensory defects caused by the reduction of 50% of the phosphate level. Therefore, the US can be useful to produce low-phosphate meat emulsions.