Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros

Base de dados
Ano de publicação
Tipo de documento
Intervalo de ano de publicação
1.
Health Phys ; 99(6): 780-7, 2010 Dec.
Artigo em Inglês | MEDLINE | ID: mdl-21068596

RESUMO

A study of the uncertainty of dosimeter results is required by the national accreditation programs for each dosimeter model for which accreditation is sought. Typically, the methods used to determine uncertainty have included the partial differentiation method described in the U.S. Guide to Uncertainty in Measurements or the use of Monte Carlo techniques and probability distribution functions to generate simulated dose results. Each of these techniques has particular strengths and should be employed when the areas of uncertainty are required to be understood in detail. However, the uncertainty of dosimeter results can also be determined using a Model II One-Way Analysis of Variance technique and accreditation testing data. The strengths of the technique include (1) the method is straightforward and the data are provided under accreditation testing and (2) the method provides additional data for the analysis of long-term uncertainty using Statistical Process Control (SPC) techniques. The use of SPC to compare variances and standard deviations over time is described well in other areas and is not discussed in detail in this paper. The application of Analysis of Variance to historic testing data indicated that the accuracy in a representative dosimetry system (Panasonic® Model UD-802) was 8.2%, 5.1%, and 4.8% and the expanded uncertainties at the 95% confidence level were 10.7%, 14.9%, and 15.2% for the Accident, Protection Level-Shallow, and Protection Level-Deep test categories in the Department of Energy Laboratory Accreditation Program, respectively. The 95% level of confidence ranges were (0.98 to 1.19), (0.90 to 1.20), and (0.90 to 1.20) for the three groupings of test categories, respectively.


Assuntos
Acreditação/métodos , Radiometria/métodos , Gestão da Qualidade Total/métodos , Guias como Assunto , Método de Monte Carlo , Probabilidade , Reprodutibilidade dos Testes , Sensibilidade e Especificidade , Incerteza
2.
Health Phys ; 98(4): 584-90, 2010 Apr.
Artigo em Inglês | MEDLINE | ID: mdl-20220365

RESUMO

In 2010, the U.S. Department of Energy will adopt a new set of radiation weighting factors and quality factors to be consistent with values recommended by the International Commission on Radiological Protection. The change will affect the magnitude of occupational exposure assigned to radiation workers exposed to neutron radiation. Understanding the energy response of the dosimeter and the effect of the new quantities is critical to accurately ensuring that occupational exposure remains below the established regulatory limits. Therefore, the factors used to interpret dosimeter readings must be re-evaluated for each irradiation field over the range of neutron energies in which the dosimeter is used. This paper describes one method of determining the neutron response of the dosimeter. A Monte Carlo approach was used to model the energy response of the Panasonic Model 809 dosimeter over the range of energies from 1.0 x 10(-8) to 20 MeV. The response, normalized to the response at 2.1 MeV, ranged from approximately 0.5 at 20 MeV to approximately 26 at 1 eV. The response was then divided at each energy by the appropriate dose conversion coefficient to determine the dose response of the dosimeter. The dose responses, normalized to the response at 2.1 MeV, ranged from approximately 0.4 at 20 MeV to 765 at 1 eV. Dose conversion factors were determined for various reference neutron spectra and plotted on the dose response curve. Good agreement was observed except for the case of D2O-moderated (252)Cf.


Assuntos
Nêutrons/efeitos adversos , Exposição Ocupacional/análise , Proteção Radiológica/métodos , Radiometria/métodos , Carga Corporal (Radioterapia) , Humanos , Modelos Biológicos , Método de Monte Carlo , Exposição Ocupacional/efeitos adversos , Doses de Radiação , Medição de Risco/métodos , Espalhamento de Radiação
3.
Int J Dev Biol ; 50(2-3): 193-208, 2006.
Artigo em Inglês | MEDLINE | ID: mdl-16479488

RESUMO

The 'Cambrian explosion', about 540 million years ago, may have occurred within 10 to 50 million years. Almost all of the modern phyla, a very restricted group and many groups that may represent extinct phyla, suddenly appear near that time in the fossil record. Numerous extensive periods of mass extinction since that time led to no new phyla. This is taken as an impetus to examine a possible source, beyond Darwinian adaptation, of the apparently restricted number of phyla. Such a postulated constraint or restriction beyond adaptation is proposed to be based on a mutation or mutations allowing single celled or colonial precursors to begin forming into epithelial sheets and gene activation patterns of a particular kind, those giving rise to the very earliest metazoans. The interaction of signaling pathways in pairs, with different pairs acting sequentially are proposed as key to this earliest patterning, such patterning being extensively elaborated over the last approximately 550 million years. Restrictions on the very large set of possible forms and patterns on which adaptation acts are discussed.


Assuntos
Evolução Biológica , Padronização Corporal/fisiologia , Morfogênese/fisiologia , Animais , Padronização Corporal/genética , Morfogênese/genética , Transdução de Sinais/genética , Transdução de Sinais/fisiologia
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA