RESUMO
Few-layer black phosphorus (FLBP) is a highly promising material for high sensitivity label-free surface plasmon resonance (SPR) sensors due to its exceptional electrical, optical, and mechanical properties. FLBP exhibits inherent anisotropy with different refractive indices along its two main crystal orientations, the zigzag and armchair axes. However, this anisotropic property is often overlooked in FLBP-based sensors. In this study, we conducted a comprehensive investigation of the SPR reflectivity and phase in a BK7-Ag-FLBP structure to understand the influence of the stacking sequence and the number of FLBP layers on the sensing performance. Clear resonant angle shifts caused by different stacking sequences of FLBP could be observed both theoretically and experimentally. In the theoretical study, the highest reflective and phase sensitivities were achieved with a 12-layer black phosphorus (BP) structure. The reflectivity sensitivity reached 287.9°/refractive index units (RIU) with the zz stacking 12-layer BP film exhibiting a sensitivity 76°/RIU higher than the ac stacking structure. Similarly, the phase sensitivity reached 1162°/RIU with the zz stacking 12-layer BP structure showing a sensitivity 276.9°/RIU higher than the ac stacking structure. The electric field distribution of the 12-layer BP structure with four different stacking sequences has also been analyzed. In the experiment study, the well-known Attenuated Total Reflection (ATR) θ-2θ SPR setup is utilized to detect the reflectivity and phase of BK7-Ag-FLBP structures. The FLBP samples with the same thickness but different stacking sequences show significant resonant angle shift (0.275°) and maximum phase difference variation (34.6°). The FLBP sample thickness and crystal orientations have been demonstrated using the angular-resolved polarized Raman spectroscopy (ARPRS). These theoretical and experimental results provide strong evidence that the stacking sequences of FLBP have a significant impact on the sensing performance of SPR sensors. By harnessing the anisotropic properties of materials like FLBP, novel structures of anisotropic-2D material-based SPR sensors could open up exciting possibilities for innovative applications.
RESUMO
Lossy mode resonance (LMR) sensors offer a promising avenue to surpass the constraints of conventional surface plasmon resonance (SPR) sensors by delivering enhanced label-free detection capabilities. A notable edge of LMR over SPR is its excitation potential by both transverse electric (TE) and transverse magnetic (TM) polarized light. Yet this merit remains underexplored due to challenges to achieving high sensing performance under both TM and TE polarization within a singular LMR model. This study introduces a theoretical model for an LMR prism refractive index sensor based on a MgF2-few layer black phosphorus-MgF2 configuration, which can achieve angular sensitivity nearing 90° refractive index unit-1 (RIU-1) for both polarizations. Leveraging the distinct anisotropic nature of black phosphorus, the figure of merit (FOM) values along its two principal crystal axes (zigzag and armchair) show great difference, achieving an impressive FOM of 1.178 × 106 RIU-1 along the zigzag direction under TE polarized light and 1.231 × 104 RIU-1 along the armchair direction under TM polarized light. We also provide an analysis of the electric field distribution for each configuration at its respective resonant conditions. The proposed structure paves the way for innovative applications of anisotropic-material-based LMR sensors in various applications.
RESUMO
Here, a silicon nanopillar array (Si-NPA) was fabricated. It was studied as a room-temperature organic vapour sensor, and the ethanol and acetone gas sensing properties were detected with I-V curves. I-V curves show that these Si-NPA gas sensors are sensitive to ethanol and acetone organic vapours. The turn-on threshold voltage is about 0.5 V and the operating voltage is 3 V. With 1% ethanol gas vapour, the response time is 5 s, and the recovery time is 15 s. Furthermore, an evaluation of the gas sensor stability for Si-NPA was performed. The gas stability results are acceptable for practical detections. These excellent sensing characteristics can mainly be attributed to the change of the overall dielectric constant of Si-NPA caused by the physisorption of gas molecules on the pillars, and the filling of the gas vapour in the voids.
RESUMO
A technique for simultaneous beam combination and aperture filling of a coherent laser array that uses a conjugate Dammann grating is proposed. It can convert light from a coherent laser array into a single-lobed far field with high quality. An experiment with a simulated 5x5 2D coherent laser array using an aperture mask has been performed. The feasibility of the proposed scheme is verified. It provides an important basis for achieving a high-power and high-brightness laser beam from an actual coherent laser array.
RESUMO
We propose a miniature pulse compressor that can be used to compensate the group velocity dispersion that is produced by a commercial femtosecond laser cavity. The compressor is composed of two identical highly efficient deep-etched transmissive gratings. Compared with prism pairs, highly efficient deep-etched transmissive grating pairs are lightweight and small. With an optimized groove depth and a duty cycle, 98% diffraction efficiency of the -1 transmissive order can be achieved at a wavelength of 800 nm under Littrow conditions. The deep-etched gratings are fabricated in fused silica by inductively coupled plasma etching. With a pair of the fabricated gratings, the input positively chirped 73.9 fs pulses are neatly compressed into the nearly Fourier transform-limited 43.2 fs pulses. The miniature deep-etched grating-based pulse compressor should be of interest for practical applications.
Assuntos
Óptica e Fotônica , Algoritmos , Desenho de Equipamento , Lasers , Distribuição Normal , Fótons , Física/métodos , Fatores de TempoRESUMO
When a Dammann grating is used to split a beam of femtosecond laser pulses into multiple equal-intensity beams, chromatic dispersion will occur in beams of each order of diffraction and with different scale of angular dispersion because the incident ultrashort pulse contains a broad range of spectral bandwidths. We propose a novel method in which the angular dispersion can be compensated by positioning an m-time-density grating to collimate the mth-order beam that has been split, producing an array of beams that are free of angular dispersion. The increased width of the compensated output pulses and the spectral walk-off effect are discussed. We have verified this approach theoretically and validated it through experiments. It should be highly interesting in practical applications of splitting femtosecond laser pulses for pulse-width measurement, pump-probe measurement, and micromachining at multiple points.
RESUMO
Writing computer-generated holograms have been achieved by using a near infrared femtosecond laser selective ablation of metal film deposited on glass substrate. The diffraction features with data reconstruction of the fabricated computer-generated holograms were evaluated. Both transmission and reflection holograms can be fabricated in a single process. The process requires no mask, no pre- or post-treatment of the substrate.
RESUMO
In this paper we propose a very simple layout of multi-shot second-harmonic-generation (SHG) frequency-resolved optical gating (FROG) using three reflective Dammann gratings (Dammann SHG-FROG ) for characterization of the ultrashort optical pulses. One reflective Dammann gratings is used as the beamsplitter and the other two compensate the angular dispersion. Both theoretical and experimental results show that the distortions of the optical pulses introduced by the reflective Dammann gratings are very small. This device should be highly interesting for characterizing the ultrashort pulse.
RESUMO
Diode-pumped passively mode-locked laser operation of Yb3+,Na+:CaF2 single crystal has been demonstrated for the first time. By using a SESAM (semiconductor saturable mirror), simultaneous transform-limited 1-ps passively mode-locked pulses, with the repetition rate of 183MHz, were obtained under the self-Q-switched envelope induced by the laser medium. The average output power of 360mW was attained at 1047nm for 3.34W of absorbed power at 976nm, and the corresponding pulse peak power arrived at 27kW, indicating the promising application of Yb3+,Na+ - codoped CaF2 crystals in achieving ultra-short pulses and high pulse peak power.
RESUMO
We propose a novel multifunctional double-layered diffractive optical element (DOE) based on the fractional Talbot effect. This DOE consists of two layers: one is the encoding layer, in which multiple sub-DOEs, i.e., multiple optical functions, are encoded; the other is the decoding layer, which is a properly designed Talbot illuminator. This DOE can perform each of the multiple optical functions one by one by shifting the encoding layer. Experimental results demonstrate that this method is efficient. This device should be highly interesting for integrated optics, optical interconnection, secure optical storage, and dynamic optical fiber communications.
RESUMO
A hexagonal array not only is a nature-preferred pattern but also is widely used in optoelectronical materials and devices. We report a simple method of hexagonal array illumination based on the Talbot effect that has a theoretical efficiency of 100%. An experimental efficiency of 90.6% with a binary phase (0, pi) hexagonal grating is given. This method should be highly interesting for applications of hexagonal array illumination in optical devices as well as in other hexagonal cells.
RESUMO
Previous pulse-width measurement methods for ultrashort laser pulses have broadly employed nonlinear effects; thus any of these previous methods may experience problems relating to nonlinear effects. Here we present a new pulse-width measuring method based on the linear selfdiffraction effect. Because the Talbot effect of a grating with ultrashort laser pulse illumination is different from that with continuous laser illumination, we are able to use this difference to obtain information about the pulse width. Three new techniques - the intensity integral technique, the intensity comparing ratio technique, and the two-dimensional structure technique - are introduced to make this method applicable. The method benefits from the simple structure of the Talbot effect and offers the possibility to extend the measurement of infrared and x-ray waves, for which currently used nonlinear methods do not work.