RESUMO
Pumping experiments were performed in a 2D tank in order to estimate the recovery yield of pure heavy chlorinated organic compounds (DNAPL; dense non-aqueous phase liquids) by varying different parameters: permeability of the saturated zone, pumping flow rates, addition of surfactant and heating. Surfactant was added to decrease capillary forces involved in the entrapment of DNAPL in porous media while temperature was increased to reduce DNAPL viscosity (and hence increase its mobility). Chemical enhancement was performed with the addition of Sodium Dodecyl Benzene Sulfonate (SDBS) (at its Critical Micelle Concentration, to avoid DNAPL dissolution) and thermal enhancement was performed at 50 °C (to avoid DNAPL volatilization). The experiments were monitored with photography allowing, on the basis of image interpretation, to convert optical densities (OD) into water saturations (Sw). Image interpretations were compared with modelling results. The two-phase flow modelling was performed with the pressure-pressure formulation using capillary pressure and relative permeability functions based on the van Genuchten-Mualem equations. Measured volumes of DNAPL recovered as well as the displacement of the DNAPL-water interface (radius and height of the cone of depression) are consistent with the modelling results. Furthermore, chemical enhancement results in a significant increase in the recovery rates of DNAPL. The observed improvement in the recovery of DNAPL with chemical enhancement is due to the fact that: (i) the residual saturation inside the cone of depression is lower and (ii) the cone of depression radius and height increase. Thermal enhancement had no beneficial effect on DNAPL recovery rate or yield. This study shows that it is possible to accurately determine water and DNAPL saturations by image interpretation during pumping tests in a 2D tank in the laboratory. For field-scale applications, the two-phase flow model allows to determine remediation yields as well as the volumes of the cone of depression according to the different operating conditions.
RESUMO
Chemical and thermal enhanced recovery of pure heavy chlorinated organic compounds (DNAPL; dense non-aqueous phase liquids) was investigated by using lab-scale 1D cells. Temperature was increased to reduce DNAPL viscosity (and hence increase its mobility), while surfactant was added to decrease capillary forces involved in the entrapment of DNAPL in porous media. Laboratory scale experiments, based on mass balance and indirect monitoring methods (i.e., permittivity, electrical resistivity and optical density), were conducted to quantify the effects of these enhancements. Heating the DNAPL up to 50 °C decreased its viscosity by a factor of two. The addition of a surfactant; i.e., Sodium Dodecyl Benzene Sulfonate (SDBS), at its Critical Micelle Concentration (to prevent DNAPL solubilization), decreased interfacial tensions by a factor of 12. Drainage-imbibition experiments performed in 1D cells provided retention curves (capillary pressure as a function of water saturation) of a two-phase (DNAPL-water) system in experimental glass bead porous media. The observed reduction of residual saturation (Srn) obtained with SDBS was 28% for 0.5 mm-diameter glass beads (GB) and 46% for 0.1 mm GB. No significant decrease in Sm was observed with thermal enhancement. The van Genuchten - Mualem model was found to satisfactorily reproduce the measured retention curves. Indirect measurements of water saturations (Sw) showed that: i. measured permittivities were very close to values modeled with the Complex Refractive Index Model (CRIM); ii. Archie's Law was less successful in reproducing measured electrical resistivities; iii. optical densities provide accurate estimations of Sw. At field scale, the combined monitoring of electrical resistivity (which provides a global picture) and permittivity (which yields locally precise but spatially limited information) is expected to significantly improve the collection of information on residual saturations Srn.