Three Dimensional Printed Surgical Guides: Effect of Time on Dimensional Stability.

PURPOSE: To analyze, in vitro, the dimensional stability over time of 3D-printed surgical guides. MATERIALS AND METHODS: Ten surgical guides, manufactured by digital light processing 3D-printing technology, were scanned immediately after post-processing and then after 5, 10, 15, and 20 days. The corresponding standard tessellation language (STL) files were used for comparison with the reference CAD project. Mean absolute deviation (MAD) of the intaglio surface, axial, and linear deviations of the sleeves' housings were measured. Generalized estimated equations models (α = 0.05) were used to investigate the effect of time. RESULTS: MAD of the teeth intaglio surface showed less variation (minimum: 0.002, maximum: 0.014 mm) than that of the mucosa (minimum: 0.026, maximum: 0.074 mm). Axial variations of the sleeves' housings on the sagittal (minimum: -0.008°, maximum: -0.577°) and frontal plane (minimum: -0.193°, maximum: 0.525°) changed with similar patterns, but opposite trends (decreasing for the former). Linear deviations of center points of the sleeves' housings had a shifting (minimum: -0.074, maximum: 0.02 mm) pattern with a decreasing tendency. Time after processing had a significant effect, either alone or nested with guides volume, on all outcomes of interest, except for MAD of the mucosa intaglio surface (p < 0.001), which was significantly affected only by the time-volume nested effect (p = 0.012). CONCLUSIONS: Within the limitations of the experimental design, postmanufacturing dimensional variations of surgical guides were statistically significant. Although limited, they are an additional source of variability affecting the overall accuracy of computer-guided surgery. As such, they should be addressed by further research.

Aerosol transmission for SARS-CoV-2 in the dental practice. A review by SIdP Covid-19 task-force.

Current evidence suggests that SARS-CoV-2, the virus that causes COVID-19, is predominantly spread from person to person. Aim of this narrative review is to explore transmission modality of SARS-CoV-2 to provide appropriate advice to stakeholders, in order to support the implementation of effective public health measures and protect healthcare workers that primary face the disease. "In vivo" and "in vitro" studies from laboratories and hospitals confirmed the presence of surface contamination and provided insight of SARS-CoV-2 detection in the air, particularly in indoor settings with poor ventilation where aerosol-generating procedures were performed. Measures for aerosol reduction, in conjunction with other effective infection control strategies, are needed to prevent the spread of SARS-CoV-2 in dental setting.

Surface disinfection and protective masks for SARS-CoV-2 and other respiratory viruses: A review by SIdP COVID-19 task force.

OBJECTIVES: Primary focused question for this systematic review (SR) was "Which is the evidence about surfaces decontamination and protection masks for SARS-Cov-2 in dental practice?" Secondary question was "Which is the evidence about surfaces decontamination and protection masks against airborne pathogens and directly transmitted viral pathogens causing respiratory infections?" MATERIALS AND METHODS: PRISMA guidelines were used. Studies on surface decontamination and protective masks for SARS-CoV-2 in dental practice were considered. Studies on other respiratory viruses were considered for the secondary question. RESULTS: No studies are available for SARS-CoV-2. Four studies on surface disinfection against respiratory viruses were included. Ethanol 70% and sodium hypochlorite 0,5% seem to be effective in reducing infectivity by > 3log TCID. Four RCTs compared different types of masks on HCW. The single studies reported no difference for laboratory-diagnosed influenza, laboratory-diagnosed respiratory infection, and influenza-like illness. A meta-analysis was not considered appropriate. CONCLUSIONS: There is lack of evidence on the efficacy of surface disinfection and protective masks to reduce the spread of SARS-CoV-2 or other respiratory viruses in dentistry. However, the consistent use of respirator and routine surface disinfection is strongly suggested. There is urgent need of data on the efficacy of specific protection protocols for dental HCW against viral infections.

Integrating intraoral, perioral, and facial scans into the design of digital dentures.

Digital technologies offer the opportunity to integrate facial scans into the design of digital dentures and provide a beneficial 3D preview and simulation of the tooth arrangement for both treatment planning and communication. The presented technique describes a procedure of merging and aligning the intraoral scans of edentulous arches, the scans of the perioral area, and the scan of the nose made by using an intraoral scanner, as well as facial scans made by using a mobile phone. Thus, a digital patient can be obtained and used to optimize individual tooth arrangement during the design of the digital denture.

Efficacy of aerobic physical retraining in a case of combined pulmonary fibrosis and emphysema syndrome: a case report.

INTRODUCTION: Combined pulmonary fibrosis and emphysema has recently been recognized as a syndrome but remains under-diagnosed. Neither clinical management nor therapeutic approaches have been clearly defined. Pulmonary rehabilitation has not been considered within the therapeutic options for combined pulmonary fibrosis and emphysema. In this case we explored the potential benefits of a specific aerobic physical retraining program in the management of combined pulmonary fibrosis and emphysema. CASE PRESENTATION: We describe the case of a 65-year-old Caucasian man with combined pulmonary fibrosis and emphysema and respiratory failure who was receiving long-term oxygen therapy. Our patient underwent physical retraining with moderate intensity aerobic and breathing exercises for four weeks. Clinical and motor tests, as well as questionnaires assessing quality of life and depression levels, were performed prior to and following the retraining. At the end of the retraining program a relevant reduction of long-term oxygen therapy requirement was registered; improvements in terms of physical performance, quality of life, and mood were observed in our patient but no change in respiratory parameters. CONCLUSIONS: A program of aerobic physical retraining appears to be beneficial to patients with combined pulmonary fibrosis and emphysema and may be considered as an additional therapeutic option.