Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros

Base de dados
Tipo de documento
Intervalo de ano de publicação
1.
ACS Nano ; 12(4): 3083-3094, 2018 04 24.
Artigo em Inglês | MEDLINE | ID: mdl-29493218

RESUMO

Reducing the grain size of metals and ceramics can significantly increase strength and hardness, a phenomenon described by the Hall-Petch relationship. The many studies on the Hall-Petch relationship in metals reveal that when the grain size is reduced to tens of nanometers, this relationship breaks down. However, experimental data for nanocrystalline ceramics are scarce, and the existence of a breakdown is controversial. Here we show the Hall-Petch breakdown in nanocrystalline ceramics by performing indentation studies on fully dense nanocrystalline ceramics fabricated with grain sizes ranging from 3.6 to 37.5 nm. A maximum hardness occurs at a grain size of 18.4 nm, and a negative (or inverse) Hall-Petch relationship reduces the hardness as the grain size is decreased to around 5 nm. At the smallest grain sizes, the hardness plateaus and becomes insensitive to grain size change. Strain rate studies show that the primary mechanism behind the breakdown, negative, and plateau behavior is not diffusion-based. We find that a decrease in density and an increase in dissipative energy below the breakdown correlate with increasing grain boundary volume fraction as the grain size is reduced. The behavior below the breakdown is consistent with structural changes, such as increasing triple-junction volume fraction. Grain- and indent-size-dependent fracture behavior further supports local structural changes that corroborate current theories of nanocrack formation at triple junctions. The synergistic grain size dependencies of hardness, elasticity, energy dissipation, and nanostructure of nanocrystalline ceramics point to an opportunity to use the grain size to tune the strength and dissipative properties.

2.
Phys Chem Chem Phys ; 18(25): 16921-9, 2016 Jun 22.
Artigo em Inglês | MEDLINE | ID: mdl-27282392

RESUMO

Grain boundaries are effective sinks for radiation-induced defects, ultimately impacting the radiation tolerance of nanocrystalline materials (dense materials with nanosized grains) against net defect accumulation. However, irradiation-induced grain growth leads to grain boundary area decrease, shortening potential benefits of nanostructures. A possible approach to mitigate this is the introduction of dopants to target a decrease in grain boundary mobility or a reduction in grain boundary energy to eliminate driving forces for grain growth (using similar strategies as to control thermal growth). Here we tested this concept in nanocrystalline zirconia doped with lanthanum. Although the dopant is observed to segregate to the grain boundaries, causing grain boundary energy decrease and promoting dragging forces for thermally activated boundary movement, irradiation induced grain growth could not be avoided under heavy ion irradiation, suggesting a different growth mechanism as compared to thermal growth. Furthermore, it is apparent that reducing the grain boundary energy reduced the effectiveness of the grain boundary as sinks, and the number of defects in the doped material is higher than in undoped (La-free) YSZ.

3.
Sci Rep ; 5: 7746, 2015 Jan 13.
Artigo em Inglês | MEDLINE | ID: mdl-25582769

RESUMO

Materials for applications in hostile environments, such as nuclear reactors or radioactive waste immobilization, require extremely high resistance to radiation damage, such as resistance to amorphization or volume swelling. Nanocrystalline materials have been reported to present exceptionally high radiation-tolerance to amorphization. In principle, grain boundaries that are prevalent in nanomaterials could act as sinks for point-defects, enhancing defect recombination. In this paper we present evidence for this mechanism in nanograined Yttria Stabilized Zirconia (YSZ), associated with the observation that the concentration of defects after irradiation using heavy ions (Kr(+), 400 keV) is inversely proportional to the grain size. HAADF images suggest the short migration distances in nanograined YSZ allow radiation induced interstitials to reach the grain boundaries on the irradiation time scale, leaving behind only vacancy clusters distributed within the grain. Because of the relatively low temperature of the irradiations and the fact that interstitials diffuse thermally more slowly than vacancies, this result indicates that the interstitials must reach the boundaries directly in the collision cascade, consistent with previous simulation results. Concomitant radiation-induced grain growth was observed which, as a consequence of the non-uniform implantation, caused cracking of the nano-samples induced by local stresses at the irradiated/non-irradiated interfaces.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA