Solution behavior of iron(III) and iron(II) porphyrins in DMSO and reaction with superoxide. Effect of neighboring positive charge on thermodynamics, kinetics and nature of iron-(su)peroxo product.

The solution behavior of iron(III) and iron(II) complexes of 5(4),10(4),15(4),20(4)-tetra-tert-butyl-5,10,15,20-tetraphenylporphyrin (H(2)tBuTPP) and the reaction with superoxide (KO(2)) in DMSO have been studied in detail. Applying temperature and pressure dependent NMR studies, the thermodynamics of the low-spin/high-spin equilibrium between bis- and mono-DMSO Fe(II) forms have been quantified (K(DMSO) = 0.082 ± 0.002 at 298.2 K, ΔH° = +36 ± 1 kJ mol(-1), ΔS° = +101 ± 4 J K(-1) mol(-1), ΔV° = +16 ± 2 cm(3) mol(-1)). This is a key activation step for substitution and inner-sphere electron transfer. The superoxide binding constant to the iron(II) form of the studied porphyrin complex was found to be (9 ± 0.5) × 10(3) M(-1), and does not change significantly in the presence of the externally added crown ether in DMSO (11 ± 4) × 10(3) M(-1). The rate constants for the superoxide binding (k(on) = (1.30 ± 0.01) × 10(5) M(-1) s(-1)) and release (k(off) = 11.6 ± 0.7 s(-1)) are not affected by the presence of the external crown ether in solution. The resulting iron(II)-superoxide adduct has been characterized (mass spectrometry, EPR, high-pressure UV/Vis spectroscopy) and upon controlled addition of a proton source it regenerates the starting iron(II) complex. Based on DFT calculations, the reaction product without neighboring positive charge has iron(II)-superoxo character in both high-spin side-on and low-spin end-on forms. The results are compared to those obtained for the analogous complex with covalently attached crown ether, and more general conclusions regarding the spin-state equilibrium of iron(II) porphyrins, their reaction with superoxide and the electronic structure of the product species are drawn.

Gas-phase methylation of [60]fullerene.

Direct methylation of [60]fullerene via a gas-phase reaction in a CH4/H2 atmosphere was performed using a modified hot filament chemical vapor deposition method. Pressures were varied from 10 to 60 mbar and the substrate was maintained at 690 degrees C. High-resolution matrix-assisted laser desorption ionization (MALDI) mass spectrometry analysis showed signals corresponding to C60H18-2n(H,CH3)n. Collision-induced dissociation experiments confirmed a maximum of 18 ligands possible to the [60]fullerene cage.

Reactions of nitric oxide on Rh6+ clusters: abundant chemistry and evidence of structural isomers.

We report the first results of a new instrument for the study of the reactions of naked metal cluster ions using techniques developed by Professor Bondybey to whom this issue is dedicated. Rh6+ ions have been produced using a laser vaporization source and injected into a 3 T Fourier transform ion cyclotron resonance (FT-ICR) mass spectrometer where they are exposed to a low pressure (< 10(-8) mbar) of nitric oxide, NO. This system exhibits abundant chemistry, the first stages of which we interpret as involving the dissociative chemisorption of multiple NO molecules, followed by the liberation of molecular nitrogen. This yields key intermediates such as [Rh6O2]+ and [Rh6O4]+. The formation of the latter, after adsorption of four NO molecules, marks a change in the chemistry observed with further NO molecules adsorbed (presumably molecularly) without further N2 evolution until saturation is apparently reached with the [Rh6O4(NO)7]+ species. We analyse the data in terms of a simple 12-stage reaction mechanism, and we report the relative rate constants for each step. The trends in reactivity are assessed in terms of conceivable structures and the results are discussed where appropriate by comparison with extended surface studies of the same system. Particular attention is paid to the first step in the reaction (Rh6(+) + NO --> [Rh6NO]+) which exhibits distinctly bi-exponential kinetics, an observation we interpret as evidence for two different structural isomers of the Rh6+ cluster with one reacting more than an order of magnitude faster than the other.

Groundwork for a rational synthesis of C60: cyclodehydrogenation of a C60H30 polyarene.

A C60H30 polycyclic aromatic hydrocarbon (PAH) that incorporates all 60 carbon atoms and 75 of the 90 carbon-carbon bonds required to form the fullerene C60 has been synthesized in nine steps by conventional laboratory methods. Laser irradiation of this C60H30 PAH at 337 nanometers induces hydrogen loss and the formation of C60, as detected by mass spectrometry. A specifically labeled [13C3]C60H30 retains all three 13C atoms during the cage formation process. A structurally related C48H24 PAH that lacks the three peripheral benzene rings cannot be transformed into C60, whereas the next higher homolog, a C80H40 PAH, degrades to the C60H30 PAH, which then loses hydrogen to give [60]fullerene. These control experiments verify that the C60 is formed by a molecular transformation directly from the C60H30 PAH and not by fragmentation and recombination in the gas phase.