The role of size and protein shells in the toxicity to algal photosynthesis induced by ionic silver delivered from silver nanoparticles.

Because of their biocide properties, silver nanoparticles (AgNPs) are present in numerous consumer products. The biocidal properties of AgNPs are due to both the interactions between AgNP and cell membranes and the release of dissolved silver (Ag+). Recent studies emphasized the role of different nanoparticle coatings in complexing and storing Ag+. In this study, the availability of dissolved silver in the presence of algae was assessed for three AgNPs with different silver contents (59%, 34% and 7% of total Ag), silver core sizes and casein shell thicknesses. The impact of ionic silver on the photosynthetic yield of Chlamydomonas reinhardtii was used as a proxy to estimate the amount of ionic silver toxically active during in vivo assays. The results showed that cysteine, a strong silver ligand, mitigated the toxicity of AgNPs in all cases, demonstrating the key role of Ag+ in this toxicity. The results showed that the AgNPs presenting an intermediate level of silver (34%) were 10 times more effective in terms of total mass (EC50 ten times smaller) than those presenting more (59%) or less (7%) silver. The higher toxicity was due to the higher release of Ag+ under biotic conditions due to the high surface/mass ratio of the nanoparticle silver core. Protein shells played a minor role in altering the availability of Ag+, probably acting as intermediate reservoirs. This study highlighted the utility of a very sensitive biological endpoint (i.e., algal photosynthesis) for the optimization of ionic silver delivery by nanomaterials.

Electrospun Poly(ethylene-co-vinyl alcohol)/Graphene Nanoplatelets Composites of Interest in Intelligent Food Packaging Applications.

Graphene nanoplatelets (GNPs) were synthetized from graphite powder and, thereafter, embedded in poly(ethylene-co-vinyl alcohol) (EVOH) fibers by electrospinning in the 0.1⁻2 wt.-% range. The morphological, chemical, and thermal characterization performed on the electrospun nanocomposite fibers mats revealed that the GNPs were efficiently dispersed and rolled along the EVOH fibrilar matrix up to contents of 0.5 wt.-%. Additionally, the dielectric behavior of the nanocomposite fibers was evaluated as a function of the frequency range and GNPs content. The obtained results indicated that their dielectric constant rapidly decreased with the frequency increase and only increased at low GNPs loadings while the nanocomposite fiber mats became electrically conductive, with the maximum at 0.5 wt.-% GNPs content. Finally, the electrospun mats were subjected to a thermal post-treatment and dark films with a high contact transparency were obtained, suggesting that the nanocomposites can be used either in a nonwoven fibers form or in a continuous film form. This study demonstrates the potential of electrospinning as a promising technology to produce GNPs-containing materials with high electrical conductivity that can be of potential interest in intelligent packaging applications as "smart" labels or tags.

Nano selenium as antioxidant agent in a multilayer food packaging material.

Selenium nanoparticles (SeNPs) were incorporated in a flexible multilayer plastic material using a water-base adhesive as vehicle for SeNPs. The antioxidant performance of the original solutions containing spherical SeNPs of 50-60 nm diameter, the adhesive containing these SeNPs, and the final multilayer plastic material to be used as food packaging were quantitatively measured. The radical scavenging capacity due to SeNPs was quantified by a free radical assay developed in the laboratory and by the diphenyl-1-picrylhydrazyl (DPPH) method. DPPH was not efficient to measure the scavenging capacity in the multilayer when the free radical scavenger is not in the surface in contact with it. Several multilayer laminated structures composed by [PET (20 m)-adhesive-LDPE (with variable thickness from 35 to 90 µm)] were prepared and measured, demonstrating for the first time that free radicals derived from oxygen (OH·, O2·, and O2H) cross the PE layer and arrive at the adhesive. SeNPs remain as such after manufacture and the final laminate is stable after 3 months of storage. The antioxidant multilayer is a non-migrating efficient free radical scavenger, able to protect the packaged product versus oxidation and extending the shelf life without being in direct contact with the product. Migration tests of both Se and SeNPs to simulants and hazelnuts demonstrated the non-migrating performance of this new active packaging. Graphical abstract ᅟ.

Assessing bio-available silver released from silver nanoparticles embedded in silica layers using the green algae Chlamydomonas reinhardtii as bio-sensors.

Silver nanoparticles (AgNPs) because of their strong antibacterial activity are widely used in health-care sector and industrial applications. Their huge surface-volume ratio enhances the silver release compared to the bulk material, leading to an increased toxicity for microorganisms sensitive to this element. This work presents an assessment of the toxic effect on algal photosynthesis due to small (size <20nm) AgNPs embedded in silica layers. Two physical approaches were originally used to elaborate the nanocomposite structures: (i) low energy ion beam synthesis and (ii) combined silver sputtering and plasma polymerization. These techniques allow elaboration of a single layer of AgNPs embedded in silica films at defined nanometer distances (from 0 to 7nm) beneath the free surface. The structural and optical properties of the nanostructures were studied by transmission electron microscopy and optical reflectance. The silver release from the nanostructures after 20h of immersion in buffered water was measured by inductively coupled plasma mass spectrometry and ranges between 0.02 and 0.49µM. The short-term toxicity of Ag to photosynthesis of Chlamydomonas reinhardtii was assessed by fluorometry. The obtained results show that embedding AgNPs reduces the interactions with the buffered water free media, protecting the AgNPs from fast oxidation. The release of bio-available silver (impacting on the algal photosynthesis) is controlled by the depth at which AgNPs are located for a given host matrix. This provides a procedure to tailor the toxicity of nanocomposites containing AgNPs.

Nanoclay migration from food packaging materials.

A recent trend is to use nanocomposites materials for food-packaging applications. Different kinds of nanoparticles are incorporated into the polymers to improve their characteristics, and, among them, nanoclay is used to improve their barrier properties to gases. In this work, the results of migration studies with different food simulants (ethanol 10% and acetic acid 3%), temperatures and times (40 ºC for 10 days and 70 ºC for 2 h) from two commercialised LDPE nanocomposite bags are presented. The migration solutions thus obtained were analysed by ICP-MS to evaluate the amount of aluminium which migrated into the solutions both in dissolved form and as a part of nanoparticles. Aluminium migration was observed for both samples with a maximum migration value of 51.65 ng cm(-)(2) for the Aisaika bags and 24.14 ng cm(-)(2) for the Debbie Meyer bags. The presence of spikes working in single-particle mode using ICP-MS indicated that part of this aluminium was present as nanoparticles. The size and morphology of the nanoclay, in both the original material and the migration solutions, was studied by scanning electron microscopy coupled to energy-dispersive X-ray diffraction (SEM-EDX). In this manner, nanoparticles of different morphologies and sizes were found to migrate into the food simulants.

Recent distribution of lead in the Indian Ocean reflects the impact of regional emissions.

Humans have injected lead (Pb) massively into the earth surface environment in a temporally and spatially evolving pattern. A significant fraction is transported by the atmosphere into the surface ocean where we can observe its transport by ocean currents and sinking particles. This study of the Indian Ocean documents high Pb concentrations in the northern and tropical surface waters and extremely low Pb levels in the deep water. North of 20°S, dissolved Pb concentrations decrease from 42 to 82 pmol/kg in surface waters to 1.5-3.3 pmol/kg in deep waters. South of 20°S, surface water Pb concentrations decrease from 21 pmol/kg at 31°S to 7 pmol/kg at 62°S. This surface Pb concentration gradient reflects a southward decrease in anthropogenic Pb emissions. The upper waters of the north and central Indian Ocean have high Pb concentrations resulting from recent regional rapid industrialization and a late phase-out of leaded gasoline, and these concentrations are now higher than currently seen in the central North Pacific and North Atlantic oceans. The Antarctic sector of the Indian Ocean shows very low concentrations due to limited regional anthropogenic Pb emissions, high scavenging rates, and rapid vertical mixing, but Pb still occurs at higher levels than would have existed centuries ago. Penetration of Pb into the northern and central Indian Ocean thermocline waters is minimized by limited ventilation. Pb concentrations in the deep Indian Ocean are comparable to the other oceans at the same latitude, and deep waters of the central Indian Ocean match the lowest observed oceanic Pb concentrations.

Barrier properties to surrogates of hydrogenated carbon nano-films deposited on PET by plasma-enhanced chemical vapour deposition.

Poly(ethylene terephthalate) resin was contaminated with a series of surrogates using a US Food and Drug Administration protocol. The contaminated samples were coated with two different kinds of hydrogenated amorphous carbon thin films (a-C:H): one with diamond-like hydrogenated amorphous carbon and another with polymer-like hydrogenated carbon (PLCH) phases. To evaluate the barrier properties of the a-C:H films, migration assays were performed using food simulants. After the tests, analysis by gas chromatography with different detectors was carried out. The appearance of the films before and after the migration experiments was studied by field emission scanning electron microscopy. The results showed that a-C:H films have good barrier properties for most of the evaluated compounds, mainly when they are deposited as PLCH phase.

Comparison between solid phase microextraction (SPME) and hollow fiber liquid phase microextraction (HFLPME) for determination of extractables from post-consumer recycled PET into food simulants.

Hollow fiber liquid phase microextraction (HFLPME) and solid phase microextraction (SPME) methods for pre-concentration of contaminants (toluene, benzophenone, tetracosane and chloroform) in food simulants were investigated. For HFLPME 1-heptanol, 2-octanone and dibutyl-ether were studied as extracting solvents. Analysis by gas chromatography coupled to mass spectrometry (GC-MS), flame ionization (GC-FID) and electron capture detectors (GC-ECD) were carried out. In addition, the methods were employed to evaluate the safety in use of a PET material after the recycling process (comprising washing, extrusion and solid state polymerization (SSP)) through extractability studies of the contaminants using 10% (v/v) ethanol in deionized water and 3% (w/v) acetic acid in deionized water as food simulants in different conditions: 10 days at 40°C and 2h at 70°C. The HFLPME preconcentration method provided increased sensitivity when compared to the SPME method and allowed to analyze concentration levels below 10 µg surrogate per kg food simulant. The results of the extractability studies showed considerable reductions after the extrusion and SSP processes and indicated the compliance with regulations for using recycled PET in contact with food.

Nanoparticle release from nano-silver antimicrobial food containers.

Polymer nanocomposites incorporating metal or metal oxide nanoparticles have been developed to improve their characteristics (flexibility, gas barrier properties, antimicrobial or antioxidant properties, etc.). Among them silver nanoparticles are used because of their antimicrobial effect in many daily life materials, i.e. food packaging. However, there is not any reference to the migration of nanoparticles to the food. In this paper the results of migration studies (with different simulant solutions and times) in three commercial nanosilver plastic food containers are shown. Migration solutions were evaluated by ICP-MS and SEM-EDX analysis and silver in dissolved form and silver as nanoparticles were analyzed, a key aspect for the toxicity. Silver migration was observed for all samples studied, with the total silver migration values ranging between 1.66 and 31.46 ng/cm(2) (lower than the permissible limits). Size and morphology of the silver nanoparticles changed for the different samples (ranging between 10 and 60 nm) and migration of other nanosized materials was also confirmed.

Convective assembly and dry transfer of nanoparticles using hydrophobic/hydrophilic monolayer templates.

A convective directed-assembly process on a flat substrate that does not require motion and is followed by a dry-transfer process of nanoparticles is presented. The convective assembly process was achieved using Au nanoparticles on hydrophobic/hydrophilic-surface-patterned Si substrates as functions of temperature, gap height, and particle size. An investigation of the particle assembly mechanism showed that the effects of temperature, gap height, and particle size were responsible for controlling the evaporation time, the evaporation length, and the assembly speed, respectively. To ensure conformal contact during the dry-transfer process, chemically patterned hybrid templates with elastic and flexible properties were fabricated and used. The hybrid templates provided conformal contact with a target silicon substrate coated with MPTMS (3-mercaptopropyltrimethoxysilane) and successfully transferred Au particles to the target substrates.