Unique potentiometric detection systems for HPLC determination of some steroids in human urine.

Isocratic HPLC with potentiometric detection is used for the determination of some 17-ketosteroids (17-KS), e.g., androsterone, dehydroepiandrosterone and estrone, and their respective sulfated conjugates (17-KSS). Glassy carbon or composite electrodes containing a mixture of graphite and poly(vinyl chloride), PVC, were used as substrate electrodes. These substrates were covered either by montmorillonite or potassium tetrakis(p-chlorophenyl) borate containing PVC-based rubber phase membranes. The neutral 17-KS compounds were derivatized with Girard's reagent P (GP) to obtain cationic pyridinium acetohydrazones prior to the HPLC/potentiometric detection assay. No side reactions were observed, and the GP itself was not interfering. The method yielded accurate and reproducible results and was applicable to samples containing down to micromolar concentrations. Next, the 17-KSS compounds, acting as anionic charged molecules, were determined directly in human urine samples with the HPLC/potentiometry combination without preliminary derivatization. For this purpose, a new anion-sensitive potentiometric electrode was developed using a macrocyclic polyamine containing, PVC-based, rubber phase membrane. The three 17-KSS compounds were also determined accurately down to micromolar concentrations. Especially, the main androgen metabolites as dehydroepiandrosterone sulfate and androsterone sulfate could be selectively determined with a developed potentiometric sensor in human urine samples without time-consuming cleanup and preconcentration step.

Hydrophobicity-aided potentiometric detection of catecholamines, beta-agonists, and beta-blockers in a mixed-solvent capillary electrophoresis system.

A series of cationic drug-like substances with distinct basicity, hydrogen-bonding ability, and hydrophobicity, including three catecholamines, two beta-agonists, and thirteen beta-blockers, was successfully detected in a capillary electrophoresis system using an end-capillary coupled potentiometric sensor consisting of a PVC-based liquid membrane deposited directly on a 100 mum diameter copper rod. The electrophoretic separation was performed on a 72 cm x 75 microm id uncoated fused-silica capillary with an acidic background electrolyte containing phosphoric acid in a water-acetonitrile mixture, pH* 2.8. Samples were injected electrokinetically at 5.0 kV for 10 s and a running voltage of 19.5 kV was applied. Excluding the bufuralol/practolol pair, baseline separation of all substances was achieved in the developed CE system within 9 minutes. A linear relationship (R(2) 0.8752) between the sensitivity of the applied potentiometric detector and the parameter log P characterising the hydrophobicity of the analytes was demonstrated. The best observable limits of detection (LODs) were obtained for the highly hydrophobic substances, i. e. bufuralol (8.10 x 10(-8) M injected concentration, S/N = 3), propranolol, alprenolol, and clenbuterol (ca. 1.10 x 10(-7) M). In the case of hydrophilic catecholamines and carbuterol their LODs with potentiometric detection were lowered by a factor of almost one thousand, reaching a value of 6.6 x 10(-5) M.

Response of DNA fragments to potentiometric sensors studied using HPLC.

Potentiometric sensors are studied as viable candidates for the construction of high throughput DNA arrays. For preliminary investigations, such sensors were used in an HPLC setup in the present work. This avoided errors due to ionic contaminants or additives in the commercial samples. The oligonucleotides dT(10), dT(20) and dT(30) were used as test substances. The potentiometric sensors were of the coated wire type, containing PVC, DOP, MTDDACl and a synthetic podand urea receptor. The HPLC system consisted of a reversed phase column eluted with a phosphate buffer, triethylammoniumacetate (TEAA), and an acetonitrile gradient. Molar responses and sensitivities increased with increasing chain length of oligonucleotides, yielding detection limits as low as 10(-6)M (dT(30), injected concentration). The slopes of the calibration graphs were at least 23 mV/decade (dT(10)), which was much higher than expected. The results are discussed in view of the potential use of this sensor type in high throughput microarrays.

Coated wire potentiometric detection for capillary electrophoresis studied using organic amines, drugs, and biogenic amines.

Capillary electrophoresis was coupled successfully and reliably to potentiometric sensors, which are based on an ionically conductive rubber phase coating, applied on a 250 microm diameter metal substrate. The membrane components included potassium tetrakis(p-chlorophenyl)borate (TCPB), bis(2-ethylhexyl)sebacate (DOS), and high molecular mass poly(vinyl chloride) (PVC). Potentiometry reveals a very sensitive CE detection mode, with sub-micromolar detection limits for amines and the randomly chosen drugs quinine, clozapine, cocaine, heroine, noscapine, papaverine, and ritodrine. The lowest detection limit, 1 x 10(-8) M injected concentration, was obtained for the quaternary ammonium compound tetrahexylammonium chloride. The more polar lower aliphatic amines and the biogenic amines dopamine, adrenaline, and cadaverine have much higher detection limits. The detection limits are log P dependent. Addition of a commercially available calixarene molecule or a synthetic macrocyclic amphiphilic receptor molecule to the electrode coatings enhanced the sensitivity respectively for the lower aliphatic amines and for the biogenic amines. A transpose of the Nikolskii-Eisenman-type function was suggested and used to convert the signal of the detector to a concentration-dependent signal.