Biphasic alcoholysis coupled with high-speed countercurrent chromatography for high performance on separating phorbol from Croton tiglium Linn extracts.

Phorbol is a tetracyclic diterpenoid found in Euphorbia tirucalli, Croton tiglium, and Rehmannia glutinosa, and is nuclear of various phorbol esters. The rapid obtaining of phorbol with high purity highly contributes to its application, such as synthesizing phorbol esters with designable side chains and particular therapeutic efficacy. This study introduced a biphasic alcoholysis method for obtaining phorbol from croton oil by using polarity imparity organic solvents in both phases and established a high-speed countercurrent chromatography method for simultaneous separation and purification of phorbol. The optimized operation conditions of biphasic alcoholysis were a reaction time of 91 min, a temperature of 14°C, and a croton oil-methanol ratio of 1:30 (g:ml). The phorbol during the biphasic alcoholysis was 3.2-fold higher in content than that obtained in conventional monophasic alcoholysis. The optimized high-speed countercurrent chromatography method was using the ethyl acetate/n-butyl alcohol/water at 4.7:0.3:5 (v:v:v) with Na2 SO4 at 0.36 g/10 ml as the solvent system, using the mobile phase flow rate of 2 ml/min, the revolution of 800 r/min, under which the retention of the stationary phase was achieved at 72.83%. The crystallized phorbol following high-speed countercurrent chromatography was obtained as high purity of 94%.

Preparation and Characterization of Protein Molecularly Imprinted Poly (Ionic Liquid)/Calcium Alginate Composite Cryogel Membrane with High Mechanical Strength for the Separation of Bovine Serum Albumin.

In order to improve the mechanical strength and imprinting efficiency, a novel bovine serum albumin (BSA) molecularly imprinted poly(ionic liquid)/calcium alginate composite cryogel membrane (MICM) was prepared. The results of the tensile test indicated that the MICM had excellent mechanical strength which could reach up to 90.00 KPa, 30.30 times higher than the poly (ionic liquid) membrane without calcium alginate; the elongation of it could reach up to 93.70%, 8.28 times higher than the poly (ionic liquid) membrane without calcium alginate. The MICM had a very high welling ratio of 1026.56% and macropore porosity of 62.29%, which can provide effective mass transport of proteins. More remarkably, it had a very high adsorption capacity of 485.87 mg g-1 at 20 °C and 0.66 mg mL-1 of the initial concentration of BSA. Moreover, MICM also had good selective and competitive recognition toward BSA, exhibiting potential utility in protein separation. This work can provide a potential method to prepare the protein-imprinted cryogel membrane with both high mechanical strength and imprinting efficiency.

Overcoming Electrostatic Interaction via Strong Complexation for Highly Selective Reduction of CN- into N2.

Limited by the electrostatic interaction, the oxidation reaction of cations at the anode and the reduction reaction of anions at the cathode in the electrocatalytic system nearly cannot be achieved. This study proposes a novel strategy to overcome electrostatic interaction via strong complexation, realizing the electrocatalytic reduction of cyanide (CN- ) at the cathode and then converting the generated reduction products into nitrogen (N2 ) at the anode. Theoretical calculations and experimental results confirm that the polarization of the transition metal oxide cathodes under the electric field causes the strong chemisorption between CN- and cathode, inducing the preferential enrichment of CN- to the cathode. CN- is hydrogenated by atomic hydrogen at the cathode to methylamine/ammonia, which are further oxidized into N2 by free chlorine derived from the anode. This paper provides a new idea for realizing the unconventional and unrealizable reactions in the electrocatalytic system.

Mineralization of cyanides via a novel Electro-Fenton system generating •OH and •O2.

Traditional methods of cyanides' (CN-) mineralization cannot overcome the contradiction between the high alkalinity required for the inhibition of hydrogen cyanide evolution and the low alkalinity required for the efficient hydrolysis of cyanate (CNO-) intermediates. Thus, in this study, a novel Electro-Fenton system was constructed, in which the free cyanides released from ferricyanide photolysis can be efficiently mineralized by the synergy of •OH and •O2-. The complex bonds in ferricyanide (100 mL, 0.25 mM) were completely broken within 80 min under ultraviolet radiation, releasing free cyanides. Subsequently, in combination with the heterogeneous Electro-Fenton process, •OH and •O2- were simultaneously generated and 92.9% of free cyanides were transformed into NO3- within 120 min. No low-toxic CNO- intermediates were accumulated during the Electro-Fenton process. A new conversion mechanism was proposed that CN- was activated into electron-deficient cyanide radical (•CN) by •OH, and then the •CN intermediates reacted with •O2- via nucleophilic addition to quickly form NO3-, preventing the formation of CNO- and promoting the mineralization of cyanide. Furthermore, this new strategy was used to treat the actual cyanide residue eluent, achieving rapid recovery of irons and efficient mineralization of cyanides. In conclusion, this study proposes a new approach for the mineralization treatment of cyanide-containing wastewater.

Preparation and Characterization of Oleanolic Acid-Based Low-Molecular-Weight Supramolecular Hydrogels Induced by Heating.

The natural-product-based low-molecular-weight supramolecular hydrogels (LMWSHs) induced by heating are rarely reported. In this work, a simple salt of oleanolic acid (OA) and choline ([choline][OA]) was used as the natural product hydrogelator (NPHG) to form LMWSHs. Unlike common sol-gel transitions, the OA-based LMWSH displayed a unique property with which the system could undergo a phase transition from the sol state to the gel state upon heating. Moreover, the phase separation was observed in sol and gel states when the temperature was elevated with nonreversible transparent-turbid transitions. LMWSHs showed good stability and injectability and the potential to be a drug delivery vehicle for sustained release of drugs. In this regard, this work provided a facile approach to designing an OA-based NPHG for preparing heat-induced LMWSHs.

Chemical dual-site capture of NH3 by unprecedentedly low-viscosity deep eutectic solvents.

It is unprecedentedly found that ethylamine hydrochloride (EaCl) and phenol (PhOH) can form a new type of deep eutectic solvent (DES) with quite low viscosity. The strong hydrogen-bond donating abilities of EaCl and PhOH provide two active sites for robust interaction with NH3. Thus, the capacities of EaCl + PhOH DESs for NH3 absorption are notably high even at low pressures.

Open and Hierarchical Carbon Framework with Ultralarge Pore Volume for Efficient Capture of Carbon Dioxide.

Amine-impregnated adsorbents are promising candidates for the selective capture of CO2 from flue gas. The key is to develop suitable supports possessing large pore sizes and very large pore volumes, and the material has to be facilely synthesized from readily available reagents. In this work, hierarchical carbon nanosheet (CNS) featuring large pore width (30-100 nm) and extraordinarily huge pore volume (8.41 cm3/g) was prepared through controlled carbonization of glucose and dicyandiamide. The CNS was physically impregnated with pentaethylenehexamine (PEHA) to act as adsorbents for selective capture of CO2. Owing to the unique porosity of CNS, the amount of amine loading in CNS can be ultrahigh (6 g PEHA/g CNS) in comparison with those of known amine-impregnated adsorbents, and the CO2 capacity in a flow of 15 v/v % of CO2 balanced in N2 was up to 5.0 mmol/g at 75 °C. The synthesized PEHA-CNS composite materials perform well in capturing CO2 under humid condition and display good stability in a test of 10 adsorption-desorption cycles. It is believed that the CNS synthesized in this work has great potential to act as a support material for CO2 adsorption.

A novel molecularly imprinted polymer of the specific ionic liquid monomer for selective separation of synephrine from methanol-water media.

A novel molecularly imprinted polymer (MIP) using the specific ionic liquid (i.e. 1-vinyl-3-carboxymethylimidazolium bromide, 1-vinyl-3-carboxyethylimidazolium bromide, 1-viny-3-carboxybutylimidazolium bromide, or 1-vinyl-3-carboxypentylimidazolium bromide) as functional monomer was prepared via precipitation polymerization, which can be used to selectively separate synephrine (SYN) from methanol-water media. Ionic liquids are facile to be designed with varying the cation or anion, which enables the specific ionic liquid to be effectively designed to be a functional monomer for the preparation of MIP. The MIP showed a good selectivity and high adsorption capacity for SYN in methanol-water media. The adsorption process could be described by the pseudo-first-order model, which meant that the adsorption kinetics described a diffusion-controlled process. The equilibrium data fitted well to the Freundlich model, indicating multilayer adsorption. Finally, the MIP were successfully applied as sorbent to selectively enrich and separate SYN from the extracts of Aurantii Fructus Immaturus with a relatively high recovery (80-90%).

Optimization of ionic liquid based ultrasonic assisted extraction of puerarin from Radix Puerariae Lobatae by response surface methodology.

Ionic liquid (IL) based ultrasonic assisted extraction (ILUAE) was developed for the effective extraction of puerarin from Radix Puerariae Lobatae (RPL). The ILUAE parameters including the type of ILs, IL concentration, RPL amount, ultrasonic power and time were optimized by single-factor experiment and response surface methodology. Under the optimized experimental conditions, the best results were obtained using RPL amount 0.43 g in 10 mL 1.06 molL(-1) 1-butyl-3-methylimidazolium bromide aqueous solution, ultrasonic time 27.43 min and ultrasonic power 480 W. Scanning electron microscope images of RPL samples were obtained to provide visual evidence of the sonication effect. Compared with the conventional ultrasonic assisted extraction and refluent extraction, the proposed ILUAE offered shorter extraction time and remarkable higher efficiencies due to the higher penetration ability and solubility of IL and the cavitation phenomenon produced in the solvent by the passage of an ultrasonic wave, which further supported the suitability of the proposed approach.

Molecularly imprinted polymers for selective extraction of synephrine from Aurantii Fructus Immaturus.

In this work, molecularly imprinted solid-phase extraction (MISPE) has been used to selectively enrich, purify, or remove synephrine from Aurantii Fructus Immaturus. To this end, a molecularly imprinted polymer (MIP) was prepared by self-assembly from the template synephrine, the functional monomer methacrylic acid, and the crosslinker ethylene glycol dimethacrylate in 1:4:20 molar ratio. Subsequent molecular interrogation of the MIP binding sites revealed preferential structural selectivity for synephrine relative to other structurally related naturally occurring compounds (i.e. octopamine and tyramine ). This selectivity was subsequently exploited to achieve substantial sample clean-up of extracts of crude Aurantii Fructus Immaturus and Aurantii Fructus Immaturus stir-baked with bran. The purity of synephrine in the extracts after MISPE represented approximately 24.21-fold enrichment of the synephrine in the untreated extracts of Aurantii Fructus Immaturus stir-baked with bran. High recoveries (85-90%) from the samples proved that the method was valid for selective enrichment, purification, or removal of synephrine from Aurantii Fructus Immaturus.

Feasibility of biogas production from anaerobic co-digestion of herbal-extraction residues with swine manure.

The objective of this work was to examine the feasibility of biogas production from the anaerobic co-digestion of herbal-extraction residues with swine manure. Batch and semi-continuous experiments were carried out under mesophilic anaerobic conditions. Batch experiments revealed that the highest specific biogas yield was 294 mL CH(4) g(-1) volatile solids added, obtained at 50% of herbal-extraction residues and 3.50 g volatile solids g(-1) mixed liquor suspended solids. Specific methane yield from swine manure alone was 207 mL CH(4) g(-1) volatile solid added d(-1) at 3.50 g volatile solids g(-1) mixed liquor suspended solids. Furthermore, specific methane yields were 162, 180 and 220 mL CH(4) g (-1) volatile solids added d(-1) for the reactors co-digesting mixtures with 10%, 25% and 50% herbal-extraction residues, respectively. These results suggested that biogas production could be enhanced efficiently by the anaerobic co-digestion of herbal-extraction residues with swine manure.

Simultaneous quantification of three major bioactive triterpene acids in the leaves of Diospyros kaki by high-performance liquid chromatography method.

The leaf of Diospyros kaki, which is a traditional Chinese medicine, has been used for the treatment of various diseases. In order to improve the quality assurance of the leaves of D. kaki, derived extracts and phytomedicines, a simple, rapid and accurate high-performance liquid chromatography (HPLC) method was developed to simultaneously assess the three bioactive triterpene acids: barbinervic acid (BA) and its epimer, rotungenic acid (RA), along with 24-hydroxy ursolic acid (HA). This HPLC assay was performed on a reversed-phase C18 column with methanol and aqueous H3PO4 as the mobile phase and using a monitoring wavelength at 210 nm. This method was successfully applied to quantify these three bioactive triterpene acids in five different solvent extracts of the leaves of D. kaki and in the leaves from six different locations in China. The results demonstrated the total content and quantity of each of the main bioactive compounds were strongly dependent on the extraction solvents and locations, indicating that the quality control of the bioactive ingredients in the leaves of D. kaki, derived extracts and phytomedicines is critical to ensure its clinical benefits. The content of the total triterpenoids was also determined by the less selective colorimetric method, and the comparison with the HPLC method was given.