Pinch Grip per SE Is Not an Occupational Risk Factor for the Musculoskeletal System: An Experimental Study on Field.

INTRODUCTION: Some ergonomic evaluation methods define pinch grip as a risk factor independent of the exerted force. The present experimental study was performed with the main aim of objectively measuring the muscle engagement during the execution of pinch grip. METHODS: the participants of the study were healthy workers occupationally involved in a high-intensity repetitive job related to the sorting of letters and small packages. Surface electromyography (sEMG) was used to study the activity of the abductor pollicis brevis and first dorsal interosseous fibers related to the execution of the required working tasks, while the force exerted during voluntary muscle contraction for pinch grip was measured by a portable acquisition system. The subjects were specifically asked to exert the maximum voluntary isometric contraction (MVIC) and further voluntary isometric contractions with a spontaneous force (SF) equal to 10%,20% and 50% of the MVIC; finally, the workers were asked to hold in pinch grip two types of envelopes, weighing 100 g and 500 g, respectively. RESULTS: The force required to pinch 100 and 500 g envelopes by the fifteen subjects of the study corresponded to 4 and 5% MVIC, respectively. The corresponding sEMG average rectified values (ARV) were approximately 6% of that at MVIC for first dorsal interosseus (FDI) fibers and approximately 20-25% of MVIC for abductor pollicis brevis (ABP) fibers. Bivariate correlation analysis showed significant relationships between force at MVIC and FDI ARV at MCV. CONCLUSIONS: The obtained results demonstrate that muscle recruitment during pinch grip varies as a function of the SF: not only the position but also the exerted force should be considered when assessing the pinch grip as risk factor for biomechanical overload of the upper limb.

Seroepidemiology of Measles, Mumps, Rubella and Varicella in Italian Female School Workers: A Cross-Sectional Study.

BACKGROUND: Determining the proportion of susceptible workers can represent a first step to the biological risk assessment related to measles, mumps, rubella and varicella exposure. This study aimed to assess the immunity against measles, mumps, rubella and varicella viruses in a cohort of female school workers. METHODS: A cross-sectional seroepidemiological study in a sample of 263 school workers undergoing routine annual workplace health surveillance program was conducted. As part of the health surveillance program, serum samples were collected and tested for measles, mumps, rubella and varicella IgG antibodies. RESULTS: Overall seropositivity was 90.5%, 85.2%, 94.7% and 97.3% for measles, mumps, rubella and varicella, respectively. In relation to mumps occupation-specific seropositivity, a statistically significant difference was observed, showing the lowest prevalence of protected individuals in other occupation groups. Moreover, in relation to rubella, school workers born in Centre Italy had the lowest seropositivity of protective antibodies and the difference between groups was statistically significant. Measles and rubella seropositivity showed a significant decrease after 2015. CONCLUSIONS: This study showed a relevant proportion of school workers susceptible to the aforementioned diseases. These results highlighted the need for proper health surveillance and immunological controls in school workers, especially for females, and provided useful insights to policymakers to select effective strategies aimed at containing the risk of vaccine-preventable diseases at schools.

Reply to Comment on Lecca, L.I.; Portoghese, I.; Mucci, N.; Galletta, M.; Meloni, F.; Pilia, I.; Marcias, G.; Fabbri, D.; Fostinelli, J.; Lucchini, R.G.; Cocco, P.; Campagna, M. Association between Work-Related Stress and QT Prolongation in Male Workers.

We appreciate the interest raised by our paper on the association between conditions linked to work-related stress and the prolongation of the QT interval on the electrocardiogram [...].

Association between Work-Related Stress and QT Prolongation in Male Workers.

: Background: Work-related stress is a potential cardiovascular risk factor, but the underlying mechanism is not fully explained. The autonomic nervous system control of cardiac function might play a specific role; therefore, monitoring the QT interval in the electrocardiogram can highlight an autonomic imbalance induced by occupational stressors. The aim of our study was to explore the QT interval parameters as early indicators of imbalance of the autonomic cardiac function in relation to work-related stress. METHODS: During 2015-2016 annual workplace health surveillance, we measured work-related stress in 484 workers of a logistic support company using the Health and Safety Executive (HSE) tool. We assessed the frequency-corrected QT (QTc) interval and the QT index (QTi) on the electrocardiogram of each participant, and collected demographic and clinical data. We compared the QTc values by the four Karasek's categories (active/passive jobs, low/high strain job), and by job support (present/lacking), and conducted multivariate analysis to adjust for possible confounders. RESULTS: The results of the multivariate regression analysis showed that QTc was prolonged among workers operating at a specific site where stress level was found to be elevated. Regular physical activity showed a beneficial effect against QTc prolongation. We did not observe an effect on QTc length by the cross-combined Karasek's categories of job control, job demand, and job support. CONCLUSIONS: Our study suggests subclinical effects of conditions associated with work-related stress on the autonomic regulation of cardiac function. Further research is warranted to elucidate the combined effect of work organization and lifestyle factors on autonomic cardiac function.

Erratum to "Development of a New Sequential Extraction Procedure of Nickel Species on Workplace Airborne Particulate Matter: Assessing the Occupational Exposure to Carcinogenic Metal Species".

[This corrects the article DOI: 10.1155/2018/3812795.].

Composition of Metallic Elements and Size Distribution of Fine and Ultrafine Particles in a Steelmaking Factory.

BACKGROUND: The characteristics of aerosol, in particular particle size and chemical composition, can have an impact on human health. Particle size distribution and chemical composition is a necessary parameter in occupational exposure assessment conducted in order to understand possible health effects. The aim of this study was to characterize workplace airborne particulate matter in a metallurgical setting by synergistically using two different approaches; Methodology: Analysis of inhalable fraction concentrations through traditional sampling equipment and ultrafine particles (UFP) concentrations and size distribution was conducted by an Electric Low-Pressure Impactor (ELPI+™). The determination of metallic elements (ME) in particles was carried out by inductively coupled plasma mass spectrometry; Results: Inhalable fraction and ME concentrations were below the limits set by Italian legislation and the American Conference of Governmental Industrial Hygienists (ACGIH, 2017). The median of UFP was between 4.00 × 104 and 2.92 × 105 particles/cm³. ME concentrations determined in the particles collected by ELPI show differences in size range distribution; Conclusions: The adopted synergistic approach enabled a qualitative and quantitative assessment of the particles in steelmaking factories. The results could lead to a better knowledge of occupational exposure characterization, in turn affording a better understanding of occupational health issues due to metal fumes exposure.

Environmental and biological monitoring of occupational exposure to polynuclear aromatic hydrocarbons during highway pavement construction in Italy.

OBJECTIVES: We performed a cross-sectional study with the main aim of evaluating occupational exposure to polycyclic aromatic hydrocarbons (PAHs) in workers involved in the pavement construction of a new highway in Northern Italy, where modified bitumen was used as binder for Hot Mix Asphalt. METHODS: We applied a combined approach of air and biological monitoring. Both the aerosol and vapour phases of bitumen were collected applying the NIOSH 5506 method. The 16 PAHs listed as high priority by EPA were determined by HPLC-UV. End-of-shift urine samples were collected from 144 workers to determine 1-hydroxypyrene (1-OHP) and 2-naphthol (2-NAP) concentrations after enzyme digestion and HPLC-UV analysis. Socio-demographic and lifestyle information was collected by a questionnaire. RESULTS: Paving workers were actually exposed to PAHs, including carcinogenic compounds, that were measurable only in the aerosol phase. Higher exposure as well as dose levels were measured for the paver group. Biological monitoring confirmed that 1-OHP was less affected by smoking habits as compared to 2-NAP and showed a higher association with occupational exposure. CONCLUSION: Carcinogenic PAH compounds were detectable only in the aerosol phase and this must be taken into account in the adoption of preventive measures. Biomonitoring supported the superiority of 1-OHP as compared to 2-NAP in assessing the internal dose in such workers.

Biological monitoring of exposure to low concentrations of benzene in workers at a metallurgical coke production plant: new insights into S-phenylmercapturic acid and urinary benzene.

CONTEXT: Urinary S-phenylmercapturic acid (SPMA) and benzene (U-Ben) are usually measured at the end of the work shift (ES), although their kinetic of elimination is not clearly known. OBJECTIVE: To investigate SPMA and U-Ben elimination 16 h after the ES, in 93 coke production workers exposed to low benzene concentrations. MATERIALS AND METHODS: Airborne benzene (A-Ben) was measured by passive samplings, while SPMA, U-Ben, methyl-tert-butyl ether (U-MTBE), cotinine (U-Cot) and creatinine were determined on urine samples collected at ES and before the beginning of the next work shift (next BS). RESULTS: Median A-Ben concentrations were 17.2 µg/m3 in the personal and 34.7 µg/m3 in the stationary samplings. SPMA was always detectable, whereas U-Ben was below the limit of quantification in 26.7% of the ES and 35.6% of the next BS samples, and U-MTBE in more than the 80.0% of the samples. At both the sampling times, SPMA and U-Ben showed a positive dependence on personal A-Ben, as well as on creatinine and U-Cot values. DISCUSSION AND CONCLUSION: SPMA and U-Ben at the next BS were dependent on the exposure to low benzene concentrations suffered in the previous work shift, prompting a reconsideration of the urine sampling time recommended by the American Conference Governmental Industrial Hygienists (ACGIH).

Education and Training in Global Occupational Health and Safety: A Perspective on New Pathways to Sustainable Development.

The institution of specific Occupational Health and Safety (OHS) training programs open to international trainees from developing countries in some European, American and Asian universities is now a well-established reality. Courses and seminars that focus particularly on this subject, widely varying in approach and duration, have been held for years at these universities; these academic institutions have combined their potential to attract students from developing countries with the scheduling of interesting lectures and training activities, depending on the availability of funds sufficient to cover travel and lodging costs. Interdisciplinarity is the key to the entire program and is its main strength, as the trainees have the opportunity to condense the technical notions and methodological aspects of different disciplines (occupational health, industrial hygiene, safety management, ergonomics) in one course. We firmly believe that these programs are a precious instrument for the training of occupational health professionals from low-income countries, as they are able to address their choices correctly, hopefully achieving the goal of reducing the human costs of development.

Assessment of residual exposure to PCBs in metallurgy.

OBJECTIVE: To evaluate the occupational exposure to polychlorinated biphenyls (PCBs) in 56 workers employed in 6 electric arc furnace steelmaking plants and 2 secondary aluminum smelting plants located in the highly industrialized area of Brescia, Northern Italy. METHODS: Thirty-four PCB congeners were found in both environmental and biological samples from workers engaged in scrap yards, electric arc furnaces, casting and maintenance departments. RESULTS: The highest airborne PCB levels were found in the aluminum plant, even 100 times those detected in the steelwork plants. Dioxin-like PCB congeners (DL-PCBs) were poorly represented in all biological samples, whereas non Dioxin-Like PCB congeners (noDL-PCBs), in particular environmentally widespread congeners (PCB 153, 138, 180), could be detected in almost all samples. The mean total PCB serum level was 3.9 ng/ml, with a range of 1.3-10.3 ng/ml, while the geometric mean for airborne PCBs levels was 9305 pg/m3, with a range of 1138-217806 pg/m3. CONCLUSIONS: Despite the higher PCB values recorded in some metallurgical plant workplaces, we failed to find any significant difference between serum concentrations in workers from steel or aluminum production, even in consideration of different tasks or different job seniority, while positive association was found only according to the age of the workers. A possible explanation may be identified in the effectiveness of the individual and collective preventive measures adopted in the workplace. Assessment of the occupational exposure to such compounds, in consideration of the recent classifications as carcinogenic to humans, should be encouraged.

Birth and development of the SIMLII Guidelines program.

OBJECTIVES: This paper aims to review the steps that the Italian Society Occupational Medicine and Industrial Hygiene (SIMLII) has undertaken over the past two decades in the context of a process of integration with quality systems, resulting in several initiatives including the production of different tools for the updating and professional qualification of the Occupational Health Physician (OHP). METHODS: The choice of focusing on a propositional-formative model such as the guidelines (GL) and the choice of the topics to be dealt with, was based on the need to provide the OHP with appropriate tools in order to face the complexity, specificity and rapidity of knowledge evolution which characterize our discipline. RESULTS: After the release of the first set of instruments (25 GL) over the five-year period 2003-2008, it became necessary to adhere to the guidelines of the GL National Program, distinguishing GL's evidence based, from consensus / orientation documents or technical assessments. CONCLUSIONS: In recent years, the introduction of the AGREE method has been of great interest and importance for assessing the quality of content and recommendations, also considering the recent legislation provisions on the criminal and civil liability of the Physician.

[Carcinogenic risk of polycyclic aromatic hydrocarbons: classification and interpretation of the monitoring]. / Rischio cancerogeno degli idrocarburi policiclici aromatici: classificazioni e interpretazioni del monitoraggio.

The polycyclic aromatic hydrocarbons (PAHs) are widespread contaminants characterized by various chemical, physical and toxic properties. The characterization of occupational and environmental exposures and the use of suitable measurements protocols are very significant because their presence in mixtures and environmental persistency. In the past few years, the knowledge concerning carcinogenicity of PAHs have been reviewed, the mechanisms involved are the interaction of PAH's metabolites with DNA and oxidative damages. The main requirement for research concerns lack of knowledge on reference values and occupational exposure's assessment in particular PAHs sampling methods that can lead to combined measurements of vapor and aerosol mixtures. Aims of this study are to describe a possible occupational sources of PAHs providing also an update of mechanism involved in their carcinogenicity and risk calculation as is done in the TEF approach. The classifications provided by International Agencies and Institutions and the limit values adopted have been reviewed and taken into account.