Healing sequelae following tooth extraction and dental implant placement in an aged, ovariectomy model.

At present, a lack of consensus exists regarding the clinical impact of osteoporosis on alveolar bone metabolism during implant osseointegration. While limited preclinical and clinical evidence demonstrates a negative influence of osteoporosis on dental extraction socket healing, no preclinical studies offer data on the results of implant placement in 6-mo-old, ovariectomized (OVX) Sprague-Dawley rats. This study aimed to investigate the outcomes of dental tooth extraction socket healing and implant placement in a rodent model of osteoporosis following daily vehicle (VEH) or abaloparatide (ABL) administration. Micro-CT and histologic analysis demonstrated signs of delayed wound healing, consistent with alveolar osteitis in extraction sockets following 42 d of healing in both the VEH and ABL groups. In a semiquantitative histological analysis, the OVX-ABL group demonstrated a tendency for improved socket regeneration with a 3-fold greater rate for moderate socket healing when compared to the OVX-VEH group (43% vs 14%), however, this finding was not statistically significant (p=.11). No significant differences were observed between vehicle and test groups in terms of implant outcomes (BMD and bone volume/total volume) at 14- and 21-d post-implant placement. Abaloparatide (ABL) significantly increased BMD of the femoral shaft and intact maxillary alveolar bone sites in OVX animals, demonstrating the therapeutic potential for oral hard tissue regeneration. The present model involving estrogen-deficiency-induced bone loss demonstrated an impaired healing response to dental extraction and implant installation.

Vitality of autologous retromolar bone grafts for alveolar ridge augmentation after a 3-months healing period: A prospective histomorphometrical analysis.

OBJECTIVES: The incorporation of retromolar bone grafts used for alveolar ridge augmentation is not well understood. This prospective observational study aims to supply histomorphometrical data from bone graft biopsies taken at the time of retrieval and after a 3-month healing period using patient-matched biopsies. MATERIALS AND METHODS: In 17 patients, trephine biopsies of the graft were acquired at the time of graft retrieval and after a 3-month healing period. The biopsies were compared histomorphometrically regarding the number of osteocytes, appearance of osteocyte lacunae, quantity, surface area, and activity of the Haversian canals. RESULTS: All grafts appeared clinically stable after screw removal and 17 implants were placed. Histomorphometric analysis revealed no significant difference in the number of osteocytes (p = .413), osteocyte lacunae (p = .611), the ratio of filled/empty osteocyte lacunae (p = .467) and active Haversian canals (p = .495) between the biopsies retrieved after a 3-months healing period with those at the time of grafting. The only significant difference was noted in the mean surface area of the Haversian canals (p = .002). Specifically, the grafts post 3-month healing showed a significantly larger mean area (0.069 mm2) compared to the time of grafting (0.029 mm2). CONCLUSION: This study demonstrates, compared to other data, a high rate of vital structures in retromolar bone block grafts after 3 months of healing, exhibiting the same histological features in comparison to the biopsies from the native alveolar ridge. Standard histomorphometrical parameters, e.g., the amount of filled or empty osteocyte lacunae for the description of the vitality of the graft need to be reappraised.

Mass Spectrometry-Based Proteomics of Poly(methylmethacrylate)-Embedded Bone.

Liquid chromatography-tandem mass spectrometry (LC-MS/MS) is a widely employed technique in proteomics research for studying the proteome biology of various clinical samples. Hard tissues, such as bone and teeth, are routinely preserved using synthetic poly(methyl methacrylate) (PMMA) embedding resins that enable histological, immunohistochemical, and morphological examination. However, the suitability of PMMA-embedded hard tissues for large-scale proteomic analysis remained unexplored. This study is the first to report on the feasibility of PMMA-embedded bone samples for LC-MS/MS analysis. Conventional workflows yielded merely limited coverage of the bone proteome. Using advanced strategies of prefractionation by high-pH reversed-phase liquid chromatography in combination with isobaric tandem mass tag labeling resulted in proteome coverage exceeding 1000 protein identifications. The quantitative comparison with cryopreserved samples revealed that each sample preparation workflow had a distinct impact on the proteomic profile. However, workflow replicates exhibited a high reproducibility for PMMA-embedded samples. Our findings further demonstrate that decalcification prior to protein extraction, along with the analysis of solubilization fractions, is not preferred for PMMA-embedded bone. The biological applicability of the proposed workflow was demonstrated using samples of human PMMA-embedded alveolar bone and the iliac crest, which revealed anatomical site-specific proteomic profiles. Overall, these results establish a crucial foundation for large-scale proteomics studies contributing to our knowledge of bone biology.

In vitro assessment of internal implant-abutment connections with different cone angles under static loading using synchrotron-based radiation.

BACKGROUND: The stability of implant-abutment connection is crucial to minimize mechanical and biological complications. Therefore, an assessment of the microgap behavior and abutment displacement in different implant-abutment designs was performed. METHODS: Four implant systems were tested, three with a conical implant-abutment connection based on friction fit and a cone angle < 12 ° (Medentika, Medentis, NobelActive) and a system with an angulated connection (< 40°) (Semados). In different static loading conditions (30 N - 90º, 100 N - 90º, 200 N - 30º) the microgap and abutment displacement was evaluated using synchrotron-based microtomography and phase-contrast radioscopy with numerical forward simulation of the optical Fresnel propagation yielding an accuracy down to 0.1 µm. RESULTS: Microgaps were present in all implant systems prior to loading (0.15-9 µm). Values increased with mounting force and angle up to 40.5 µm at an off axis loading of 100 N in a 90° angle. CONCLUSIONS: In contrast to the implant-abutment connection with a large cone angle (45°), the conical connections based on a friction fit (small cone angles with < 12°) demonstrated an abutment displacement which resulted in a deformation of the outer implant wall. The design of the implant-abutment connection seems to be crucial for the force distribution on the implant wall which might influence peri-implant bone stability.

Mass spectrometry-based proteomic applications in dental implants research.

Dental implants have been established as successful treatment options for missing teeth with steadily increasing demands. Today, the primary areas of research in dental implantology revolve around osseointegration, soft and hard tissue grafting as well as peri-implantitis diagnostics, prevention, and treatment. This review provides a comprehensive overview of the current literature on the application of MS-based proteomics in dental implant research, highlights how explorative proteomics provided insights into the biology of peri-implant soft and hard tissues and how proteomics facilitated the stratification between healthy and diseased implants, enabling the identification of potential new diagnostic markers. Additionally, this review illuminates technical aspects, and provides recommendations for future study designs based on the current evidence.

Comparison of the 3D-microstructure of human alveolar and fibula bone in microvascular autologous bone transplantation: a synchrotron radiation µ-CT study.

Introduction: Autologous bone transplantation is successfully used in reconstructive surgery of large/critical-sized bone defects, whereby the microvascular free fibula flap is still regarded as the gold standard for the reconstruction of such defects in the head and neck region. Here, we report the morphological and lacunar properties of patient-paired bone samples from eight patients from the jaw (AB; recipient site) and the fibula (FB; donor site) on the micron length-scale using Synchrotron µ-CT. Insights into differences and similarities between these bone structures could offer a better understanding of the underlying mechanism for successful surgical outcomes and might clear the path for optimized, nature-inspired bone scaffold designs. Methods: Spatial vessel-pore arrangements, bone morphology, fluid-simulation derived permeability tensor, osteocyte lacunar density, and lacunar morphology are compared. Results: The orientation of the vessel system indicates a homogenous vessel orientation for AB and FB. The average mineral distance (50%) to the closest vessel boundary is higher in AB than in FB (the mean is 96 µm for AB vs. 76 µm for FB; p = 0.021). Average osteocyte lacunar density is found to be higher in AB than in FB (mean 22,874 mm3 vs. 19,376 mm3 for FB; p = 0.038), which might compensate for the high distance from the mineral to the nearest vessel. No significant differences in lacunar volume are found between paired AB and FB. Discussion: A comparable vessel network and similar distribution of vessel porosity between AB and FB may allow the FB graft to exhibit a high regeneration potential when connected to AB, and this might correlate with a high osteoinductive and osteoconductive potential of FB when connected to AB. Since widely used and potent synthetic bone grafts exist, new insight into the bone structure of well-established autologous bone grafts, such as the free fibula flap, could help to improve the performance of such materials and therefore the design of 3D scaffolds.

Root Coverage Using a Novel Porcine Acellular Dermal Matrix: Case Reports of Different Minimally Invasive Techniques with a 3-Year Follow-up.

A recently released commercially available novel porcine acellular dermal matrix (PADM) appears to possess acceptable biologic and clinical properties to be considered as an acceptable soft tissue replacement material. The aim of these three case reports is to present the treatment of multiple gingival recession by means of different variations of the tunnel and PADM as well as the clinical outcomes obtained at 3 years postoperatively. The healing outcomes demonstrated only minor surgical complications, with minimal patient-reported discomfort. At 3 years postoperative, ideal functional and esthetic outcomes were observed. PADM seems to be a promising xenogeneic soft tissue substitute. Further studies with a higher number of patients and defects are necessary to confirm the present findings.

Impact of peri-implantitis on the proteome biology of crevicular fluid: A pilot study.

BACKGROUND: The proteome of the peri-implant crevicular fluid (PICF) has not been systematically investigated. The aim of the present study was to reveal the proteome biology of dental implants affected with peri-implantitis. METHODS: Patients with at least one diseased implant were included (probing depth ≥6 mm, ≥3 mm peri-implant radiological bone loss). Using sterile paper strips, samples were collected from healthy implants (I), healthy teeth (T) and peri-implantitis affected implants (P). Proteome analysis was performed using liquid chromatography - tandem mass spectrometry (LC-MS/MS) and data independent acquisition, allowing the identification and quantification of human and bacterial proteins as well as semi-specific peptides. RESULTS: A total of 38 samples from 14 patients were included in the study; 2332 different human proteins were identified across all samples. No differentially expressed proteins between T and I were found. Comparing P to I, 59 proteins were found upregulated and 31 downregulated in P with significance. Upregulated proteins included proinflammatory proteins such as immunoglobulins, dysferlin, and S100P, as well as antimicrobial proteins, for example, myeloperoxidase or azurocidin. Gene ontology analysis further revealed higher activity of immunological pathways. Proteolytic patterns indicated the activity of inflammatory proteins such as cathepsin G. A total of 334 bacterial proteins were identified and quantified. Peri-implantitis showed elevated proteolytic activity. CONCLUSION: I and T share similarities in their proteome, while diseased implants deviate strongly from healthy conditions. The PICF proteome of peri-implantitis affected sites exhibits an inflammatory fingerprint, dominated by neutrophil activity when compared with healthy implants.

Association of sex steroid hormones and new bone formation rate after iliac onlay grafting: a prospective clinical pilot study.

PURPOSE: The present prospective study evaluates the association between new bone formation rate in the iliac onlay graft and sex steroid hormone serum levels. METHODS: A total of 15 partially or completely edentulous postmenopausal females and 9 males with less than 5 mm height of the remaining alveolar bone underwent iliac onlay grafting followed by dental implant placement using a two-stage approach. Sex hormone binding globulin and 17ß-estradiol serum levels were investigated by electrochemiluminescence immunoassay, while total testosterone level was analyzed using radioimmunoassay. At the time of implant placement, 12 weeks after grafting, bone biopsies were obtained and analyzed histomorphometrically. Statistical analysis was performed using linear mixed models. RESULTS: Grafting procedure was successfully performed in all patients. The mean new bone formation rate was 32.5% (116 samples). In men the mean new bone formation rate (38.1%) was significantly higher (p < 0.01) than in women (27.6%). Independent of gender 17ß-estradiol and testosterone were positively associated to overall new bone formation rate, albeit a significant influence was only seen for 17ß-estradiol in men (p = 0.020). Sex hormone binding globulin had no influence on new bone formation rate (p = 0.897). There was no significant association between new bone formation rate and age (p = 0.353) or new bone formation rate and body mass index (p = 0.248). CONCLUSION: Positive association of 17ß-estradiol as well as testosterone with new bone formation rate after iliac onlay grafting indicates a role of sex steroid hormones in alveolar bone regeneration, although the observed influence was only significant for 17ß-estradiol in men.

Impurities in commercial titanium dental implants - A mass and optical emission spectrometry elemental analysis.

OBJECTIVE: Titanium (Ti) is considered bioinert and is still regarded as the "gold standard" material for dental implants. However, even 'commercial pure' Ti will contain minor fractions of elemental impurities. Evidence demonstrating the release of Ti ions and particles from 'passive' implant surfaces is increasing and has been attributed to biocorrosion processes which may provoke immunological reactions. However, Ti observed in peri-implant tissues has been shown to be co-located with elements considered impurities in biomedical alloys. Accordingly, this study aimed to quantify the composition of impurities in commercial Ti dental implants. METHODS: Fifteen commercial titanium dental implant systems were analyzed using inductively coupled plasma-mass spectrometry (ICP-MS) and optical emission spectrometry (ICP-OES). RESULTS: The elemental composition of implants manufactured from commercially pure grades of Ti, Ti-6Al-4V, and the TiZr alloy (Roxolid) conformed to the respective ISO/ASTM standards or manufacturers´ data (TiZr/Roxolid). However, all implants investigated included exogenous metal contaminants including Ni, Cr, Sb, and Nb to a variable extent. Other contaminants detected in a fraction of implants included As and the radionuclides U-238 and Th-232. SIGNIFICANCE: Although all Ti implant studies conformed with their standard compositions, potentially allergenic, noxious metals and even radionuclides were detected. Since there are differences in the degree of contamination between the implant systems, a certain impurity fraction seems technically avoidable. The clinical relevance of these findings must be further investigated, and an adaptation of industry standards should be discussed.