System optimization study of hybrid K-edge/XRF densitometer for uranium-plutonium solution measurement.

In this paper, a comprehensive hybrid K-edge/XRF densitometer (HKED) device model is constructed using MCNP simulation. After the modeling process, a systematic simulation study is conducted to analyze the physical parameters and material selection of KED and XRF. The simulation results reveal that the optimal parameters for the X-ray tube are an X-ray source voltage of 160 kV and a 1 mm Fe filter. The sample should be placed in a vial with an inner diameter of 1.4 cm and an outer diameter of 2 cm. For the KED technique, the determined main parameters are a 1.9 cm Fe filter rod and an inner diameter of 0.08 cm for the collimator. For the XRF technique, the determined main parameters are a 0.01 cm Gd filter and an inner diameter of 0.3 cm for the collimator, with a detector angle of 150°. After selecting appropriate parameters, the average calibration factor Δµ of the KED technique was found to be 3.301 cm2 g-1, with a relative standard deviation (RSD) of 3.36%. Additionally, the comparison between the simulated and calculated values of uranium concentration revealed a minimum measurement error of 0.4%. The minimum detection concentration of KED for uranium solutions is approximately 1 g/L. For plutonium solutions ranging from 0.5 to 20 g/L, linear fitting of the Ka1 net peak area and plutonium concentration showed a coefficient of determination (R2) of 0.999. The detection limit of XRF for plutonium measurement was 2.33✕10-4 g/L. The linear fitting coefficients (R2) of uranium concentration versus K-edge transmission rate and plutonium concentration versus Ka1 net peak area for the hybrid technique in measuring uranium-plutonium mixed solutions are determined as 0.999 and 0.996, respectively, demonstrating the response relationship of the HKED device to uranium and plutonium under different concentrations.

Secofumitremorgins C and D, a pair of atropisomers from saltern-derived fungus Aspergillus fumigatus GXIMD00544.

A pair of atropisomers secofumitremorgins C (1a) and D (1b), together with fifteen known alkaloids (2-16), were isolated from a saltern-derived fungus Aspergillus fumigatus GXIMD00544. The structures of atropisomers 1a and 1b were elucidated by the detailed spectroscopic data, chemical reaction and quantum chemical calculations. Compounds 1 and 8 displayed antifungal spore germination effects against plant pathogenic fungus associated with sugarcane Fusarium sp. with inhibitory rates of 53% and 77% at the concentration of 100 µM, repectively. Atropisomers 1 also exhibited antifouling potential against Balanus amphitrite larval settlement with an inhibitory rate of 96% at the concentration of 100 µM.

Carneusones A-F, Benzophenone Derivatives from Sponge-Derived Fungus Aspergillus carneus GXIMD00543.

Six benzophenone derivatives, carneusones A-F (1-6), along with seven known compounds (7-13) were isolated from a strain of sponge-derived marine fungus Aspergillus carneus GXIMD00543. Their chemical structures were elucidated by detailed spectroscopic data and quantum chemical calculations. Compounds 5, 6, and 8 exhibited moderate anti-inflammatory activity on NO secretion using lipopolysaccharide (LPS)-induced RAW 264.7 cells with EC50 values of 34.6 ± 0.9, 20.2 ± 1.8, and 26.8 ± 1.7 µM, while 11 showed potent effect with an EC50 value of 2.9 ± 0.1 µM.