Highly effective decontamination in a hospital environment: An easy-to-operate, low-cost prototype.

Healthcare-associated infections (HAI) are illnesses acquired during healthcare and are often the most important adverse event during healthcare. With the aim of increasing the effectiveness of disinfection/decontamination processes in the health service with safe and not promote microbial resistance, we propose the development of portable equipment associated with type C ultraviolet light (UVC). The efficiency of the irradiance emitted by the equipment (at dosages 3.5, 5.0, and 60 mJ/cm2) was determined by the action exerted after exposure against four different bacterial (Acinetobacter baumannii, Escherichia coli, Pseudomonas aeruginosa, and Staphylococcus aureus) and three different fungi (Candida albicans, C. parapsilosis, and Aspergillus section Fumigati). It was possible to observe that all treatments were capable of inactivating the bacterial species evaluated (p < 0.05), causing the irreversible death of these microorganisms. The most effective elimination of fungal agents was at a dose of 60 mJ/cm2 of UVC radiation, with a decrease in the fungal inoculum varying between 94% and 100% in relation to the control without exposure. Thus, our study showed that the application of the portable prototype with UVC light (254 nm) at a distance of 48 mm, allowed an average irradiance of 3.5 mW/cm2, with doses of 3.5 ≈ 60 mJ/cm2 (from 1 to 60 s of exposure), which can promote the total reduction of the bacteria evaluated and significantly reduce fungal growth. Therefore, this prototype could be used safely and effectively in the hospital environment, considerably reducing contamination and contributing to the reduction of healthcare-associated infection risk.

Ultraviolet light C prototype device against Sporothrix brasiliensis as a potential physical method for surface disinfection.

Sporothrix brasiliensis is recognized as an emergent fungal pathogen and the high amount of fungal propagules in the lesions of infected cats allows the contamination of surfaces by direct contact. Given that the environment can play a role in the transmission of this fungus, effective methods to eliminate this pathogen from contaminated surfaces are necessary. Physical methods, such as ultraviolet light C (UVC), are broad used for surfaces disinfection, however, non-data about its activity against S. brasiliensis is reported. Therefore, we aimed to evaluate an easy handled prototype of a UVC device, in the inhibition of S. brasiliensis. Three doses and times of exposure of irradiance were tested: 3.5 mJ/cm2 (1 s), 5.25 mJ/cm2 (1.5 s) and 329 mJ/cm2 (94 s) against a standardized inoculum of yeast and mold phase of S. brasiliensis. A decrease in CFU was shown in all doses of irradiance in both phases of S. brasiliensis, the average reduction ranged from 78 to 100% among doses, being a complete fungicidal activity achieved against the yeast phase after the 94 s exposure (329 mJ/cm2). Our data shows that UVC is a potential physical method for disinfection of surfaces contaminated with S. brasiliensis, and the prototype device developed provides an easy handling, and quickly results.